Streszczenie treści zawartej na stronie nr. 1
H- CMD7079
DVD RECEIVER WITH BLUETOOTH DVD- C BLUETOOTH
Instruction manual
Streszczenie treści zawartej na stronie nr. 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ............................................................................................................................................2 Important safeguards ........................................................................
Streszczenie treści zawartej na stronie nr. 3
Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Read carefully through this manual to familiarize yourself with this high-quality system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may c
Streszczenie treści zawartej na stronie nr. 4
Installation/Connections First complete the electrical connections, and then check them for correctness. If you are not confident working with electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or other components of your vehicle, please call your dealer in order to have the unit professionally installed. Before the installation 1. Remove the old unit from the dashboard. Remove the outer trim frame. Insert the keys supplied with the old unit into both sides of
Streszczenie treści zawartej na stronie nr. 5
Installation method A WARNING: Disconnect negative battery terminal from battery before starting installation. Consult the vehicle’s owner’s manual for proper instructions. Remove two transport screws from the top of the unit before installation. 1. After removing the old unit and mounting sleeve, insert supplied mounting sleeve in the opening. 2. Bend the tabs on the mounting sleeve to keep the mounting sleeve firmly in place. 3. Attach wires from the unit to existing wires. See wiring conne
Streszczenie treści zawartej na stronie nr. 6
Installation method B Note: Outer trim frame, hook, and mounting sleeve are not used for this installation. This is only intended as a general guide; contact the vehicle's manufacturer for specific instructions. This method of installation uses the screw holes at the sides of the unit and the holes of the existing vehicle mounting bracket. 1. Remove the hooks on both sides. 2. Align the screw holes of the mounting bracket supplied with the car and the screw holes of the main unit. Tighten the 2
Streszczenie treści zawartej na stronie nr. 7
Electrical connections Speaker Wiring Notes Follow the above wiring diagram to install the head unit with new or existing speakers. This unit is designed for use with four (4) speakers with the impedance between 4 Ohms to 8 Ohms. An impedance load of less than 4 Ohms could damage the unit. 7
Streszczenie treści zawartej na stronie nr. 8
Never bridge or combine the speaker wire outputs. When not using four speakers, use electrical tape to tape the ends of the unused speaker outputs to prevent a short circuit. Never ground the negative speaker terminals to chassis ground. Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may caus
Streszczenie treści zawartej na stronie nr. 9
Panel controls Front panel 1. REL button 2. POWER button 3. PREVIOUS button 4. NEXT button 5. BD/NP/SUB button 6. APS button 7. MODE button 8. PHONE button 9. AUX IN 10. Numeric pad 11. MIC in 12. USB slot 13. Bluetooth operation indicator 9
Streszczenie treści zawartej na stronie nr. 10
14. SD slot 15. EJECT button 16. LCD display 17. Remote control sensor 18. DISC slot 19. ANSWER button 20. VOL/SEL knob 21. END CALL button Back of the front panel 1. Disc loading slot 2. Connector 3. RESET button 4. LED indicator 10
Streszczenie treści zawartej na stronie nr. 11
Remote control (RC) 1. POWER button 2. MODE button 3. BND/SYS button 4. Cursor (LEFT/RIGHT/UP/DOWN)/ ENTER button 5. STOP button 6. AMS/RPT button 7. ST/PROG button 8. LOC/RDM button 9. PREVIOUS/SEEK - button 10. MENU/PBC button 11. OSD button 12. MUTE button 13. ANSWER button 14. GOTO button 15. PLAY/PAUSE button 16. SUB-T button 17. TITLE button 18. SETUP button 19. SLOW button 20. ANGLE button 21. ZOOM button 22. NEXT/SEEK + button 11
Streszczenie treści zawartej na stronie nr. 12
23. VOL+/VOL-/SEL buttons 24. AUDIO button 25. Numeric pad 26. CLOCK DISPLAY/END CALL button 27. PHONE button Battery information of RC 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the RC. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disa
Streszczenie treści zawartej na stronie nr. 13
Glossary PBC (PlayBack Control) PlayBack Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc contains three films, they may b
Streszczenie treści zawartej na stronie nr. 14
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press RESET button to restore the unit to the original factory settings. Power button Press POWER button to turn on the unit. Press POWER to switch the power off. When you switch off the system or car ignition, the settings, tuner presets and the volume level will be retained in the unit’s memory. Mode selection Press the MODE button to cycle the play mode between
Streszczenie treści zawartej na stronie nr. 15
ROCK => FLAT. Keep pressing SEL/VOL knob for 2 seconds to select the RDS function: TA SEEK/ALARM => RETUNE L/S => MASK DPI/ALL. TA (Traffic Announcement) mode To determine what action will the radio take if the newly tuned station does not receive TP (Transport Program) information for 5 seconds. Rotate the VOL/SEL knob to select the desired mode: TA ALARM and TA SEEK. - TA SEEK When newly tuned station does not receive TP information for 5 seconds, the radio retunes to next station which has n
Streszczenie treści zawartej na stronie nr. 16
To mask only the AF with different PI. - MASK ALL To mask both PI and strong signal non-RDS station. Mute Press the MUTE button to activate the Mute function. Press it again or use the VOL/SEL knob on the panel or press the VOL+/VOL- buttons on the RC to cancel. Adjusting clock 1. Press and hold CLOCK DISPLAY button for more than 3 seconds to select the hour setting. Hour digits will blink. 2. Rotate VOL/SEL knob to set the hours. 3. Press VOL/SEL knob to select the minute setting. Minute digits
Streszczenie treści zawartej na stronie nr. 17
Radio operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Choose Radio Band Press BND/SYS button on the RC or BD/NP/SUB button on the panel to select a band. The unit has with five bands: FM1, FM2, FM3, MW1 and MW2. Each of the five bands can store up to six preset stations, for a total of 30 preset memory stations. Radio Tune/Seek Function Press NEXT/SEEK+
Streszczenie treści zawartej na stronie nr. 18
Save Your Preset Stations There are six numbered preset buttons, which can store and recall stations for each band. If while listening to a radio station you would like to save the station as a pre-set, press and hold one of the numeric buttons 1-6 until you hear a beep. The button you pressed is now the pre-set button for that station. Automatic Store/Preset Scan Automatic Scan and Store While listening to the FM radio, press and hold APS button for 3 seconds. The unit will automatically scan a
Streszczenie treści zawartej na stronie nr. 19
so that you do not have to re-tune the stations when driving between different transmitter coverage areas. When AF is on, it means RDS information is received; when AF is flashing, it means RDS information is not yet received. TA - TRAFFIC ANOUNCEMENT Press 8/TA numeric button on the panel so that the unit will be activated for reception of traffic announcement from local radio stations. To choose the TA mode, press and hold SEL button for 2 seconds, the display will show TA SEEK. Rotate VOL/SEL
Streszczenie treści zawartej na stronie nr. 20
DVD operations Insert/Eject disc Insert a disc into disc slot with label side up. The disc will be automatically loaded into the unit, even when it is off or in radio mode. The word “LOAD” will show on the display and the disc will play automatically. Press EJECT button to eject the disc from the slot. If the disc is not removed from the slot within 5 seconds, it will automatically be loaded into the slot again. When the disc is ejected and removed, the unit will automatically switch to radio mo
