Instrukcja obsługi Metra Electronics 99-7316

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS FOR PART 99-7316
APPLICATIONS
2000-2005 Hyundai XG300/XG350
99-7316
KIT FEATURES
• DIN head unit provision
• ISO DIN head unit provision
KIT COMPONENTS
A) Radio Housing l B) ISO Brackets | C) Trim Plate
A B C
TOOLS REQUIRED:
Phillips Screwdriver I Small Flat Blade Screwdriver
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION

Streszczenie treści zawartej na stronie nr. 2

99-7316 TABLE OF CONTENTS Dash Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Kit Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2, 3 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Streszczenie treści zawartej na stronie nr. 3

DASH DISASSEMBLY 99-7316 2000-2005 HYUNDAI XG300/XG350 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove entire panel sur- rounding radio and climate controls including pocket assembly at bottom of panel. (Figure A) 3 Remove (4) Phillips screws per side B to remove radio and climate control. Note: It is not necessary to discon- nect climate control. (Figure B) 1

Streszczenie treści zawartej na stronie nr. 4

KIT ASSEMBLY 99-7316 DIN HEAD UNIT PROVISION A 1 Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) 2 Slide the aftermarket head unit into the cage and secure. (Figure B) B 2

Streszczenie treści zawartej na stronie nr. 5

99-7316 KIT ASSEMBLY ISO DIN HEAD UNIT PROVISION A 1 Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A) 2 Slide the head unit into the radio opening until the side clips engage. (Figure B) Snap the Trim plate into the Radio 3 Housing. (Figure B) B 3

Streszczenie treści zawartej na stronie nr. 6

KIT ASSEMBLY 99-7316 FINAL ASSEMBLY Locate the factory wiring harness in the dash and make the connection as shown. 1 Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) Re-connect the negative battery terminal and test the unit for proper operation. 2 3 Reassemble radio and dash assemblies in reverse order of disassembly. FINAL WIRING CONNECTIONS Make wiring co

Streszczenie treści zawartej na stronie nr. 7

99-7316 NOTES 5

Streszczenie treści zawartej na stronie nr. 8

INST997316 1-800-221-0932 www.metraonline.com © COPYRIGHT 2004 METRA ELECTRONICS CORPORATION REV. 09/01/05 INST99-7316