Streszczenie treści zawartej na stronie nr. 1
UCD300/UMP400
Owner's Manual/Manual del Usario/Manual de L'Utilisateur
AM/FM/CD Receiver
RELEASE EJECT
Receptor AM/FM/CD
/
UCD300
MON
PWR
AM/FM/CD Ampli-Syntoniseur
DSP
TUNE
EQ LOC
> >
TRACK
BAND
AM / FM / CD RECEIVER
SEL MUT
LOUD
AS/PS 1 PAU 2 SCN 3 RPT 4 SHF 5 CD- 6 CD+ MODE
>
Streszczenie treści zawartej na stronie nr. 2
UCD300/UMP400 Para obtener instrucciones en Español, diríjase a la página 20. Pour des instructions en Francais, référez-vous à la page 38. PREPARATION customer support line at 1-800-323-4815. Getting Started Disconnect Battery (U.S.A. and Canada only.) It’s a good idea to read all of the instructions Before you begin, disconnect the battery before beginning the installation. negative terminal. Tools and Supplies Contents The following tools and supplies are needed to Installation Instructio
Streszczenie treści zawartej na stronie nr. 3
PCD160U AM / FM / CD RECEIVER CD-IN / UCD300/UMP400 INSTALLATION INSTRUCTIONS Installation Using a Mounting 5. Make sure the radio is right-side up, then BEND TABS carefully slide the radio into the mounting Sleeve sleeve until it is fully seated and the spring 1. Slide the mounting sleeve off the chassis. clips lock it into place. If it is locked into position, use the removal 6. Attach one end of the perforated support tools (supplied) to disengage it. strap (supplied) to the screw stud
Streszczenie treści zawartej na stronie nr. 4
UCD300/UMP400 INSTALLATION INSTRUCTIONS Installation Using a Kit reverse procedure in step 1 of “Installation ISO INSTALLATION Using a Mounting Sleeve” . If your vehicle requires the use of an installation kit to mount this radio, follow the instructions Removing the Radio included with the installation kit to attach the To remove the radio after installation, remove radio to the mounting plate supplied with the kit. the trim ring by lifting in the center and pulling it 1. Wire and test th
Streszczenie treści zawartej na stronie nr. 5
UCD300/UMP400 WIRING CD Changer Connector 10A Antenna Connector Power Antenna Connect to power antenna or amplifier. If not used, tape Blue Amplifier Wiring bare end of wire. Connect line out for optional Gray external amplifiers. The red connector is for the right and the Black Ground white connector is for the left. Connect to ground terminal. Memory/Battery Yellow + Connect to battery or 12 volt power source that is always WARNING! Never combine (bridge) outputs live. The radio will not work
Streszczenie treści zawartej na stronie nr. 6
> UCD300/UMP400 INSTALLING THE REMOVABLE FACEPLATE Faceplate Installation To install the faceplate, slip the right edge of the front panel into the radio then gently press the left side into place. Faceplate Detachment To remove the faceplate, press the RELEASE button, and pull gently on the left side of the front panel. For safekeeping, store the front panel in the protective case provided. Handling Precautions • Make sure the front panel is right-side-up when attaching it to the chassis
Streszczenie treści zawartej na stronie nr. 7
UCD300/UMP400 OPERATING INSTRUCTIONS 1 3 4 Power On/Off Button (PWR) Volume Control (AUDIO) Select Button (SEL) To increase the volume level, turn the AUDIO The SEL button is used to select the audio Press the PWR button (1) to turn the unit on control (3) clockwise. To decrease the volume function (volume, bass, treble, balance or fade) and off when the vehicle ignition switch is on. level, turn the AUDIO control counter- to be adjusted using the AUDIO control (3). When the unit is off, t
Streszczenie treści zawartej na stronie nr. 8
UCD300/UMP400 OPERATING INSTRUCTIONS 4 4 4 Bass Control Front/Rear Fader Control Audible Beep To adjust the bass level, first select the Bass To adjust the front/rear speaker balance, press Press SEL (4) for > 3 seconds to access the mode by pressing the SEL button (4) until the SEL button (4) until “FAD“ appears on the Beep Tone menu. Turn the AUDIO control (3) “BAS” appears on the display panel. Within five display panel. Within five seconds, turn the to select “BEEP ALL”, “BEEP 2ND”, or “BE
Streszczenie treści zawartej na stronie nr. 9
UCD300/UMP400 OPERATING INSTRUCTIONS 5 7 9 Loudness Control (BAND/ FM Mono Select (MON) Local Button (LOC) LOUD) During FM radio operation, the MON button (7) During radio operation, received signals are is used to select monaural or stereo reception usually in stereo mode as indicated by the “ST” When listening to music at low volume levels, of the broadcast signal. Under normal reception icon; however, when the signals are weak or this feature will boost the bass and treble conditions, th
Streszczenie treści zawartej na stronie nr. 10
UCD300/UMP400 OPERATING INSTRUCTIONS 3. Within 5 seconds, press the TUNE/ 11 13 Station Pre-Set Memories Display Selector (DSP) TRACK ( ) button (6b) to adjust the To set any of the 6 pre-set memory buttons, This unit can display either the clock time or minutes to the desired setting. use the following procedure: radio frequency/CD player functions. Press the 4. Press the TUNE/TRACK ( ) button (6a) 1. Turn the unit on and select the desired DSP or DISP/0 button (13) to display the time to
Streszczenie treści zawartej na stronie nr. 11
UCD300/UMP400 CD PLAYER OPERATING INSTRUCTIONS 15 6 17 Disc Slot Cue/Review Functions Track Scan Select (SCN) With the label surface facing up, gently insert Press and hold the TUNE/TRACK ( ) button During disc play, press the 2 SCN button (17) to the disc into the slot until the soft-loading (6a) to advance rapidly forward or the TUNE/ play the first 10 seconds of each track. mechanism engages and disc play begins. “S -- TRACK ( ) button (6b) to advance rapidly (“S-SCN” will be displ
Streszczenie treści zawartej na stronie nr. 12
UCD300/UMP400 CD PLAYER OPERATING INSTRUCTIONS 18 14 20 Track Repeat Play Select Mode Selector (MODE) Disc Eject Button (RPT) Press the MODE button (14) to change When the disc eject button (20) is pressed, between CD player and radio operation. The During disc play, press the 3 RPT button (18) to disc play is stopped, the disc is ejected, and the current mode is indicated on the display panel. repeat play of the selected track (“S-RPT” will unit will change to radio operation. If the dis
Streszczenie treści zawartej na stronie nr. 13
UCD300/UMP400 MP3 PLAYER OPERATION (UMP400) This section applies to the UMP400 only. Searching by Name Searching the Root Directory 1. Press the AMS button (8) twice to enable 1. Press the AMS button (8) three times. Instructions for Insert/Eject, Play/Pause, Track directory or file name searching. 2. Use the AUDIO control (3) to select the Selection, Cue/Review, Scan, Repeat, and 2. Use the AUDIO control (3) to select the desired directory/song. If a directory is Random are the same for CD
Streszczenie treści zawartej na stronie nr. 14
UCD300/UMP400 CD CHANGER CONTROLS Built into the UCD300 and UCD400 are controls 14 21 22 CD Changer Mode Selector , Disc Select (5CD-/6CD+) to operate an optional CD changer. Please (MODE) These CD-/+ buttons (21 and 22) are used to check with your Phase Linear/Audiovox car select the desired disc for play. To advance to a stereo specialist or call 1-800-323-4815 for Press the MODE button (14) to select operation lower number disc, press the 5 CD- button (21). recommendations of the model
Streszczenie treści zawartej na stronie nr. 15
UCD300/UMP400 REMOTE CONTROL The remote control will allow you to control the basic functions of the UCD300/UMP400. UCD300 REMOTE CONTROL UMP400 REMOTE CONTROL 7 MOD SEL MOD SEL MOD = MODE MOD = MODE PWR PWR BND = BAND BND = BAND VOL VOL AMS = AS/PS DSP = DISP (Display) 9 TUNE/SEEK 8 TUNE/SEEK PAU = VOL VOL LOU BND DSP BND DSP 0 ENT PAU SCN RPT PAU SCN RPT D-AUD AMS AMS 1 2 3 1 2 3 SHF SHF - DISC + - DISC + 4 5 6 4 5 6 INFRARED REMOTE CONTROLLER INFRARED REMOTE CONTROLLER 15
Streszczenie treści zawartej na stronie nr. 16
UCD300/UMP400 CARE AND MAINTENANCE Your new radio/CD player does not require any disc may occur. Such damage will not be • Carefully wipe fingerprints, dust and dirt maintenance. However, proper understanding covered by the Warranty on this product. from the disc’s playing surface with a soft of its use and handling will help you obtain cloth. Wipe in a straight motion from the • When not using the disc player, always maximum enjoyment of its capabilities. We center to the outside of the dis
Streszczenie treści zawartej na stronie nr. 17
UCD300/UMP400 SPECIFICATIONS CD-R and CD-RW Capability Technical Specifications AM Tuner Tuning Range: 530kHz - 1710kHz Depending on media type and method of Sensitivity @ 20dB Signal to Noise: 30uV "recording/burning", some CD-R/RWs may be Frequency Response: 30Hz - 2kHz, -3dB incompatible with this unit. After "recording/ General burning", the session must be closed. Please Power Supply: 11 to 16VDC, negative ground refer to your software's recommended Fuses: Battery - 15 amp, ATO procedu
Streszczenie treści zawartej na stronie nr. 18
UCD300/UMP400 90 DAY LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) LIABILITY UNDER THIS WARRANTY IS may not apply to you. This Warranty gives you warrants to the original retail purchaser of this LIMITED TO THE REPAIR OR specific legal rights and you may also have product that should this product or any part REPLACEMENT PROVIDED ABOVE AND, IN other rights which vary from state to state. thereof, under normal use and conditions, be NO EVENT, SHALL THE COMPANY'S U.S.A: Audiovox Corporation
Streszczenie treści zawartej na stronie nr. 19
UCD300/UMP400 Manual del Usario
Streszczenie treści zawartej na stronie nr. 20
UCD300/UMP400 For instructions in English, please refer to page 2. Pour des instructions en Francais, référez-vous à la page 38. PREPARACIÓN necesita un equipo de instalación pero no Comenzando Desconecte la Batería puede conseguirlo, llame a nuestra línea de Es buena idea leer completamente las Antes de empezar, siempre desconecte la atención al cliente al 1-800-645-4994 (sólo para instrucciones antes de iniciar la instalación. terminal negativa de la batería. U.S.A. y Canadá). Contenido H
