Streszczenie treści zawartej na stronie nr. 1
R R
U E
VIDEO CASSETTE RECORDER VIDEO CASSETTE RECORDER
INSTRUCTIONS
INSTRUCTIONS
BR-DV600UA BR-DV600EA
OPERATE OPERATE
ON/OFF
CH-1/3 CH-1/3 ON/OFF
VIDEO CASSETTE RECORDER BR-DV600UA
VIDEO CASSETTE RECORDER BR-DV600EA
REC LEVEL
REC LEVEL
EJECT
EJECT
MENU ADVANCE PRESET
MENU ADVANCE PRESET
CH-2/4 REC PLAY PAUSE CH-2/4
REC PLAY PAUSE
SHIFT– SHIFT+ +
SHIFT– SHIFT
REMOTE REMOTE
HOLD SHIFT A. DUB
HOLD SHIFT A. DUB
SELECT SET
LOCAL SELECT SET LOCAL
REW STOP FF
REW STOP FF
V.IN/A.MONI A.OUT COUNTER
V
Streszczenie treści zawartej na stronie nr. 2
E U Supplement This equipment is in conformity with the provisions and protection requirements of the corresponding European Directives. This equipment is designed for professional video appliances and can be used in the following environments: 5 residential area (in houses) 1. Read all of these instructions. 5 commercial and light industry; e.g. office or theatres 2. Save these instructions for later use. 3. All warnings on the product and in the operating instructions should be adhered t
Streszczenie treści zawartej na stronie nr. 3
U E SAFETY PRECAUTIONS SAFETY PRECAUTIONS POWER SYSTEM Warning Notice CAUTION ATTENTION Connection to the mains supply FOR YOUR SAFETY (Australia) RISK OF ELECTRIC SHOCK RISQUE D’ELECTROCUTION DO NOT OPEN NE PAS OUVRIR 1. Insert this plug only into effectively earthed three- This unit operates on voltage of 220 V to 240 V AC, pin power outlet. 50 Hz/60 Hz. ATTENTION: POUR EVITER TOUT RISQUE D’ELECTROCUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, 2. If any doubt exists regarding the earthi
Streszczenie treści zawartej na stronie nr. 4
CONTENTS 1 INTRODUCTION 1 INTRODUCTION 7 PLAYBACK 1-1 Major features 1-1 Major features .............................................. 5 Playback preparation ........................................ 28 1-2 Maintenance ................................................ 5 Playback ........................................................... 29 5 MiniDV format 5 RS-232C interface (optionally available) 1-3 Precautions .................................................. 6 Repeat play .................
Streszczenie treści zawartej na stronie nr. 5
1 INTRODUCTION 1 INTRODUCTION 1-3 Precautions 1-4 Precautions for use of head cleaning tape Adhere to the following precautions when using the head Note 1) When used in a low humidity environment (10% Installation and storage Cassette tape cleaning tape. RH to 30% RH), head cleaning should be 5 To avoid malfunctions or damage to your recorder, do 5 Type conducted at intervals half of those given in the 1. The tape runs for 10 seconds at a time in the PLAY not use or store it in places subjec
Streszczenie treści zawartej na stronie nr. 6
PGZ01945 Ω 2 CONTROLS, CONNECTORS AND DISPLAYS 2 CONTROLS, CONNECTORS AND DISPLAYS 2-1 Front panel 2-2 Rear panel # $ % ^& * ( ) OPERATE CH-1/3 ON/OFF DV % IN/OUT VIDEO CASSETTE RECORDER BR-DV600UA 1 COMPONENT VIDEO AUDIO LINE CH 1/3 CH 2/4 REC LEVEL IN @ $ Y/C EJECT IN IN 1 R-Y B-Y Y # 2 MENU ADVANCE PRESET OUT CH-2/4 REC PLAY PAUSE @ SHIFT SHIFT AUTO OFF DEW OUT CH 1/3 OVER REMOTE OUT 40 30 20 10 0 dB HOLD SHIFT A. DUB CH 2/4 OVER SERVO RF MONITOR 3 ! 32k 48k SLAVE PB NDF HOLD OUT SELEC
Streszczenie treści zawartej na stronie nr. 7
2 CONTROLS, CONNECTORS AND DISPLAYS 2 CONTROLS, CONNECTORS AND DISPLAYS 2-3 On-screen display 2-4 LCD display The on-screen display can be viewed on a monitor connected to the rear panel’s [VIDEO MONITOR OUT] connector when the AUD LOCK: Lights when the video and audio AUTO OFF DEW CH 1/3 OVER sampling clocks (at 48 kHz) are No. 500 menu switch is set to “ON”. Pressing the [MENU] button will bring up the menu switch display 6 0 40 30 20 10 dB synchronized in the Play mode. Lights
Streszczenie treści zawartej na stronie nr. 8
PGZ01945 PGZ01945 3 CONNECTIONS 3 CONNECTIONS 3-1 Video system connections 3-2 Audio system connections Reference sync signal Video output from a VCR, etc. Sync signal generator, etc. Audio output from a VCR, etc. This unit automatically selects the sync signal as shown in DV Analog audio (2 channels) Input the table below, depending on the presence of external sync External sync signal input (SYNC IN) and video input (VIDEO IN), the No. 003 DV Composite IN/OUT VIDEO COMPONENT
Streszczenie treści zawartej na stronie nr. 9
PGZ01945 PGZ01945 PGZ01945 3 CONNECTIONS 3 CONNECTIONS 3-4 Editing system examples 3-3 Other connections The BR-DV600UA/EA can be used as a feeder for different video formats. 5 Simplified digital cut editing system Using an editing remote controller with JVC bus specifications such as the RM-G800/G805, digital cut editing is possible DV IN/OUT COMPONENT VIDEO AUDIO LINE with another MiniDV VCR. When the BR-DV600UA is used as a recorder, the following editing operations cannot be CH 1/3 CH
Streszczenie treści zawartej na stronie nr. 10
PGZ01945 PGZ01945 3 CONNECTIONS 3 CONNECTIONS 5 Mixed S-VHS/VHS system 5 Edit adjust setting This is an editing system which uses the BR-DV600UA as a feeder/player with an RS-422A serial remote controller such as The No. 353 menu switch must be adjusted according to the configuration of the editing system being the RM-G820. In this case, the BR-DV600UA cannot be used as a recorder VCR. used. The S-VHS/VHS VCR can be replaced with a D-9/Betacam VCR. Setting table (when the RM-G80
Streszczenie treści zawartej na stronie nr. 11
3 CONNECTIONS 4 MENU SWITCHES You can set menu switches using either the on-screen display or the counter display. To set switches on the on-screen display, you will need to connect a monitor to the VCR’s [VIDEO MONITOR OUT] connector. This section explains how to set switches using the on-screen display. The same procedures apply to switch setting on the counter display, the only difference being that each menu switch item is indicated by numeric code rather than by name. 5 Control via the
Streszczenie treści zawartej na stronie nr. 12
4 MENU SWITCHES 4 MENU SWITCHES q: Factory setting 4-2 Menu switch details (00): The number in the bracket shows the set value on the counter display. For switch setting procedures, refer to “Menu switch setting (When the optional SA-K46 RS-232C interface 108 VIDEO INPUT SELECT 211 AUDIO MONITOR procedure”. board is installed) Details: Use this to select the input video signal when Details: Use this to select which audio channel to q: Factory setting EEE 1394 (01): Allows control of this unit
Streszczenie treści zawartej na stronie nr. 13
4 MENU SWITCHES 4 MENU SWITCHES q: Factory setting q: Factory setting (00): The number in the bracket shows the set value (00): The number in the bracket shows the set value on the counter display. on the counter display. 312 AUTO REW 363 CONTROLLER SELECT 414 TCG SELECT 504 INFORMATION SELECT Details: Selects whether or not the tape is rewound Details: Selects the setting according to the type of Details: Selects the time code generator mode. Details: Selects which information is displayed on
Streszczenie treści zawartej na stronie nr. 14
5 PREPARATION 5 PREPARATION Preparing this unit for recording or playback. Built-in clock setting Time data is recorded in the sub code area of the tape during recording. In the Play mode, this data is read out and can be shown on the on-screen display or the counter display. OPERATE ON/OFF CH-1/3 [Reference] VIDEO CASSETTE RECORDER BR-DV600UA [OPERATE] button Clock data is retained for about 60 hours after the REC LEVEL EJECT 6-hour power supply is used up (Operate On mode). ADVANCE: Change
Streszczenie treści zawartej na stronie nr. 15
6 RECORDING 6 RECORDING [REC LEVEL] control [REC LEVEL] control OPERATE OPERATE CH-1/3 ON/OFF ON/OFF CH-1/3 VIDEO CASSETTE RECORDER BR-DV600UA VIDEO CASSETTE RECORDER BR-DV600UA REC LEVEL REC LEVEL EJECT EJECT MENU ADVANCE PRESET MENU ADVANCE PRESET CH-2/4 REC PLAY PAUSE CH-2/4 REC PLAY PAUSE SHIFT SHIFT OVER AUTO OFF DEW SHIFT SHIFT AUTO OFF DEW CH 1/3 REMOTE CH 1/3 OVER REMOTE 40 30 20 10 0 dB 40 30 20 10 0 dB HOLD SHIFT A. DUB SERVO RF HOLD SHIFT A. DUB CH 2/4 OVER CH 2/4 OVER SERVO RF 3
Streszczenie treści zawartej na stronie nr. 16
7 PLAYBACK Playback Repeat play 1 Press the [PLAY] button. 1 Set the No. 311 and No. 312 menu switches to “ON”. CH-1/3 ON/OFF connector. Other data recorded on the tape is read out See No. <311 AUTO PLAY> and No. 312 on pages 21 to 22. button REC LEVEL EJECT 2 To stop playback, press the [STOP] button. 2 Press the [PLAY] but
Streszczenie treści zawartej na stronie nr. 17
PGZ01945 8 EXTERNAL TIMER-START FUNCTION 9 TIME CODE (AUTOMATIC START-UP WITH POWER SUPPLY) The time code is recorded frame by frame together with the materials to be recorded on the tape. With this time code, the position of the materials can be precisely specified, improving the editing accuracy and working efficiency. (The editing accuracy of 0 frame may not be obtained even though the time code is used, depending on the performance of the VCR and editing controller and influence of editing
Streszczenie treści zawartej na stronie nr. 18
9 TIME CODE 9 TIME CODE 1 Set the menu switches. ( See pages 22 and 23.) OPERATE ON/OFF CH-1/3 5 Set the No. 413 menu switch to “INTERNAL”. VIDEO CASSETTE RECORDER BR-DV600UA HM S F 5 Set the No. 414 menu switch to REC LEVEL EJECT “PRESET”. 5 Set the No. 415 menu switch. MENU ADVANCE PRESET Setting is not necessary for user bits. CH-2/4 REC PLAY PAUSE REC RUN: The time code is counted only during SHIFT SHIFT AUTO OFF DEW CH 1/3 OVER REMOTE HM S F 40 30 20
Streszczenie treści zawartej na stronie nr. 19
9 TIME CODE 10 SUPER SCENE FINDER FUNCTION 5 Recording time code from an external time code 5 Recording time code data input to the [DV IN] The SSF data recorded on the tape with the GY-DV500/DV550/DV700W’s Super Scene Finder function can be read out by installing the optional SA-K46 RS-232C interface board. Consult your JVC dealer for details on installation of the SA-K46 generator connector RS-232C interface board. ● Menu switch setting ● Menu switch setting No. 413 ......... EX
Streszczenie treści zawartej na stronie nr. 20
SAVE STBY H M L BARS CAM AU O TF O F KN O E N E PRST A B PGZ01945 11 BACKUP RECORDING FUNCTION 12 RS-232C INTERFACE Long-time series recording is possible by connecting other 12-1 Command tables DV recorders in series. 5 Backup recording 5 Operation This section provides information on programming VCR operations via the RS-232C interface. 1. Start recording with the source VCR. Source VCR Basic table * Be sure to start from the beginning of the tape. DV camcorder GY-DV500/DV550 or 01 2 345 6
