Instrukcja obsługi MTX Audio THUNDERFORM

Streszczenie treści zawartej na stronie nr. 1

Warranty Statement
ThunderForm Loaded Enclosures purchased in the United States from an authorized MTX dealer
are guaranteed against defects in material and workmanship for a period of two years from the date
purchased by the end user, and limited to the original retail purchaser of the product.
Amplified ThunderForm Enclosures purchased in the United States from an authorized MTX dealer
are guaranteed against defects in material and workmanship for a period of one year from the date
purchas

Streszczenie treści zawartej na stronie nr. 2

READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING MOUNTING LOCATION: The enclosure mounts behind the driver’s seat on Chevy S10 Regular Cab Trucks, GMC Sonoma and Isuzu Hombre. TOOLS REQUIRED FOR INSTALLATION: Powered Screwdriver #2 Phillips Head Bit Wire Cutters 5/16” Wrench Terminal Crimpers INSTALLATION: Follow the steps below 1. Place enclosure behind seat, with woofer firing forward (do not mount yet). For technical assistance call 1-800-CALL MTX. These instructions are guidelines only and

Streszczenie treści zawartej na stronie nr. 3

21. When amp turns on, LED will display red during diagnostic mode, carpet to the front of vehicle. and then green, signaling amp is on and functioning. Amp will only turn 5. Open hood. on when radio is on. 6. Drill a hole through the fire wall. Locate a spot low on the fire wall on 22. Adjust gain and crossover. the driver’s side. You should always look to find a clear path. Drill a hole from inside of the vehicle into engine compartment and insert grommet. Setting Gain Firewall Turn gain

Streszczenie treści zawartej na stronie nr. 4

11. Ground amplifier to chassis of vehicle; connect the terminal provided 17. Behind the radio, locate the rear speaker wires. Colors are right to the 10ga black wire from furnished wiring harness. A good ground is channel; dark blue (positive) light blue (negative), and left channel; brown as important as the power connection. The ground should be as short as (positive), yellow (negative). Tap into wires with the supplied RCA High possible and the contact point should be free of paint and