Instrukcja obsługi JL Audio Stealthbox SB-SMRT-4-2/8W3v3

Streszczenie treści zawartej na stronie nr. 1

SB-SMRT-4-2/8W3V3 INSTR_SKU# 011288
Installat Ion

d I F F I C u l t Y :

If you choose to perform the installation yourself, it is absolutely vital that
®
out
the Stealthbox be properly mounted to the vehicle according to these
o F
instructions. Failure to mount the enclosure properly presents two problems:
I n s t a l l a t I o n G u I d e
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
45
caused by the force exerted by the woofer(s).
SB-SMRT-

Streszczenie treści zawartej na stronie nr. 2

SB-SMRT-4-2/8W3V3 INSTR_SKU# 011288 s t e P 4 S T E P 8 Once the trim piece is removed, there are three Torx screws This picture is only to illustrate where the DETAIL below is that hold the dash end piece in place, remove those and the located, the enclosure and, woofer have NOT been mounted end piece. yet. Where the arrow is pointing is where the DETAIL below is located. s t e P 5 D E T A I L Install the included right angle bracket as shown through Looking into the end of the dash, yo

Streszczenie treści zawartej na stronie nr. 3

SB-SMRT-4-2/8W3V3 INSTR_SKU# 011288 s t e P 1 1 S T E P 1 5 Install the included, 3/8-16 x 1” Hex Head Bolt, Split Slide the enclosure up into place, it’s a tight fit and, you’ll Lockwasher and Washer through the Right Angle Bracket need to move it around a little but if you start as shown, it will go in without any problems. installed in ste P 8 into the Stealthbox® as shown. no W You need to t IGHten all o F t He PReVIousl Y Installed Ha RdWa Re! Re-install the woofer into the enclosur

Streszczenie treści zawartej na stronie nr. 4

SB-SMRT-4-2/8W3V3 INSTR_SKU# 011288 I n C l u d e d H a R d W a R e 6) 1/4” Split Lock Washer 5) 1/4” Flat Washer 3) 1/4-20 Hex Nut 3) 1/4-20 x 1” Hex Head Bolt 1) 1/4-20 Speed Clip 1) 1/4-20 x 12” All Threaded Rod 5) 3/8” Flat Washer 2) 3/8-16 x 1” Hex Head Bolt 3) 3/8” Split Lock Washer 1) 3/8-16 x 1 1/2” Hex Head Bolt 2) 3/8-16 Hex Nut 4) Custom Brackets s P e C I F I C a t I o n s Enclosure Type: Acoustic Suspension (sealed) Driver Type: 8W3v3-4 Nominal Impedance: 4 Ohms Conti