Instrukcja obsługi JL Audio Stealthbox SB-N-MURAN/10W1v2

Streszczenie treści zawartej na stronie nr. 1

➔
➔
➔ ➔
➔ ➔
➔
➔
➔
➔ ➔
®
Stealthbox
INSTALLATION GUIDE START
HERE
for the
SB-N-MURAN/10W1v2
(2003-Up Nissan Murano)
STEP 1: Remove all contents, rubber flooring, STEP 2: Open the cargo flooring and hook it STEP 3: a)With a Phillips® screw driver,
cargo shade and lower the rear seats. to the upper lip of the tailgate opening. remove the driver’s side cargo pocket.
Remove the organizer tray, wooden board,
b)Unsnap the wiring harness that is running
factory woofer enclosure, spare tire and the
from

Streszczenie treści zawartej na stronie nr. 2

➔ ➔ ➔ ➔ ➔ ➔ ➔ Cont. From Previous Page ➔➔➔ STEP 7: There is a large L-bracket that is already STEP 8: a)Place a supplied 3/8” lock washer and STEP 9: Place the Stealthbox® into position.The STEP 10: Tuck the rear of the factory harness mounted to the rear of the Stealthbox®.This L- 3/8” flat washer onto a 3/8”-16x1-1/4” hex bolt. speaker terminal needs to face to the front of the under the right rear corner.The harness needs to bracket needs to be unmounted, flipped around and Using this bolt as

Streszczenie treści zawartej na stronie nr. 3

➔ Ω ➔ Cont. From Previous Page CONGRATULATIONS! INSTALL COMPLETE. ➔➔ 1-1/2” Included Hardware: 1) 1/4” USS Flat Washer 1) 3/8”-16x1-1/4” Hex Bolt 2) 3/8” Split Lock Washer 2) #6x3/8” Philip® Head Screws STEP 15: a) Lower the flooring back into position, STEP 16: a) Flip over the side floor panel. STEP 17: Snap the driver’s side rear cargo pocket 1) 3/8”-16x1-3/4” Hex Bolt from STEP 2. Measure 1-1/2” from the outside left edge to the cover into place. 3) 3/8” Flat Washer right.This measurement ne