Streszczenie treści zawartej na stronie nr. 1
COLOR TELEVISION RECEIVER
Chassis : KS3A(P) (REV. 2)
Model : CS29A5HT8X/BWT
CS29A5HT8X/NWT
CS29A5HT8X/VWT
CZ21A8VW8X/ELS
RTV servis Horvat
Tel: ++385-31-856-637
Tel/fax: ++385-31-856-139
Mob: 098-788-319
www.rtv-horvat-dj.hr
COLOR TELEVISION RECEIVER CONTENTS
1. Precautions
2. Reference Information
3. Specifications
4. Alignment and Adjustments
5. Troubleshooting
6. Exploded Views and Parts List
7. Electrical Parts List
8. Block Diagrams
9. Wiring Diagram
10. Schematic D
Streszczenie treści zawartej na stronie nr. 2
Precautions 1. Precautions Follow these safety, servicing and ESD precautions to prevent damage and protect against potential hazards such as electrical shock and X-rays. 1-1 Safety Precautions 1. Be sure that all of the built-in protective devices are replaced. Restore any missing (READING SHOULD NOT BE ABOVE LEAKAGE protective shields. DEVICE 0.5mA) CURRENT UNDER TESTER TEST 2. When reinstalling the chassis and its TEST ALL EXPOSED METAL assemblies, be sure to restore all protective SURFACES
Streszczenie treści zawartej na stronie nr. 3
Precautions 1-1 Safety Precautions (Continued) 15. Observe the original lead dress, especially 9. High voltage is maintained within specified near the following areas: Antenna wiring, limits by close-tolerance, safety-related sharp edges, and especially the AC and high components and adjustments. If the high voltage power supplies. Always inspect for voltage exceeds the specified limits, check pinched, out-of-place, or frayed wiring. Do each of the special components. not change the spa
Streszczenie treści zawartej na stronie nr. 4
Precautions 1-2 Servicing Precautions Warning1: First read the “Safety Precautions” section of this manual. If some unforeseen circumstance creates a conflict between the servicing and safety precautions, always follow the safety precautions. Warning2: An electrolytic capacitor installed with the wrong polarity might explode. 5. Check the insulation between the blades of the 1. Servicing precautions are printed on the AC plug and accessible conductive parts cabinet. Follow them. (example
Streszczenie treści zawartej na stronie nr. 5
Precautions 1-3 Precautions for Electrostatically Sensitive Devices (ESDs) 1. Some semiconductor (“solid state”) devices 5. Use only a grounded-tip soldering iron when are easily damaged by static electricity. Such soldering or unsoldering ESDs. components are called Electrostatically Sensitive Devices (ESDs); examples include 6. Use only an anti-static solder removal device. integrated circuits and some field-effect Many solder removal devices are not rated as transistors. The following techn
Streszczenie treści zawartej na stronie nr. 6
Reference Information 2. Reference Information 2-1 Tables of Abbreviations and Acronyms Table 2-1 Abbreviations A Ampere MV Megavolt Ah Ampere-hour MW Megawatt Å Angstrom MΩ Megohm dB Decibel m Meter dBm Decibel Referenced to One µA Microampere Milliwatt µF Microfarad °C Degree Celsius µH Microhenry °F Degree Fahrenheit µm Micrometer °K degree Kelvin µs Microsecond F Farad µW Microwatt G Gauss mA Milliampere GHz Gigahertz mg Milligram g Gram mH Millihenry H Henry mI Milliliter Hz Hertz mm Millim
Streszczenie treści zawartej na stronie nr. 7
Reference Information Table 2-2 Table of Acronyms ABL Automatic Brightness Limiter I/O Input/output AC Alternating Current L Left ACC Automatic Chroma Control L Low AF Audio Frequency LED Light Emitting Diode AFC Automatic Frequency Control LF Low Frequency AFT Automatic Fine Tuning MOSFET Metal-Oxide-Semiconductor-Field-Effect-Tr AGC Automatic Gain Control MTS Multi-channel Television Sound AM Amplitude Modulation NAB National Association of Broadcasters ANSI American National Standards Institu
Streszczenie treści zawartej na stronie nr. 8
Reference Information 2-2 IC Line Up Table 2 - 3 IC Line - Up NO BOARD LOC. NO SPEC DESCRIPTION REMARK Video Processor Refer to Table 2-3-1 IC201S VDP3112B Refer to Table 2-3-2 IC601 MSP3411G Multistandard Sound Processor IC901 SDA555X MICOM, TTX(MTP) KS24L161 EEPROM IC902 Refer to Table 2-3-3 Audio AMP IC602 TDA7297 VM Option HIC201 HIC202 DRGB001 RGB Drive AMP Hybrid IC HIC203 HIC204 100Hz Horizontal Pulse AMP Option HIC401 DDRI001 Vertical IC IC301 LA7845 Q402 KSC2073-H2 Horizontal Drive IC
Streszczenie treści zawartej na stronie nr. 9
Reference Information Table 2 - 3 IC Line - Up BOARD NO LOC. NO SPEC DESCRIPTION REMARK T801S AA26-00046A Trans Switching Refer to Table 2-3-6 1 MAIN T444S FUJ-29B001 Trans FBT Refer to Table 2-3-7 IC501 TDA6111Q Video Output AMP R.G.B Drive IC502 IC503 2 CRT QF04 2SC2344 Push-Pull (VM) 2SA1011 QF05 Option QG02 KSA940 TR-Power (TILT) QG03 KSD2073-H2 ICG01 KA4558 OP-AMP (TILT) ICH01 KA4558 OP-AMP Option DOUBLE 3 FOCUS QH01 2SC4636RB TR-Power Option ICS01 4 V-S/W TEA6425 Video Switching IC with A
Streszczenie treści zawartej na stronie nr. 10
Reference Information Table 2-3-1 VIDEO IC (IC201S) REMARK SPEC FUNCTION VDP3108B 50Hz Basic VDP3112B 50Hz, 2H Comb Filtr VDP3120B 50Hz, 2H Comb Filter, Horizontal Scaler VDP3130Y 50Hz, 2H Comb Filter, DVD Input VDP3140D 100Hz Table 2-3-2 SOUND IC (IC601) REMARK SPEC FUNCTION MSP3400D Multistandard, A2 Stereo MSP3410D Multistandard, A2 Stereo, Nicam MSP3411G Multistandard, A2 Stereo, Nicam, Vitual Dolby Table 2-3-3 SOUND AMP (IC602) FUNCTION REMARK SPEC 15W x 2CH, 10W x 2CH TDA7297 Table 2-3-4
Streszczenie treści zawartej na stronie nr. 11
Reference Information Table 2-3-6 TRANS SPEC FUNCTION REMARK FUJ-29B001 29” FUH-29A001B 21” Table 2-3-7 TRANS FLYBACK (FBT) REMARK SPEC FUNCTION AA26-00046A 29” AA26-00044C 21” 2-6 Samsung Electronics
Streszczenie treści zawartej na stronie nr. 12
Specifications 3. Specifications Television CS PAL/SECAM-B/G,D/K,L,I, NTSC-M System Antena Input 75ohms, Coaxial Cable Consumption 100W (Applied When 29” Flat) 220V Only Power Requirements Not Present R815 Free Voltage Frequency 50/60Hz 29 Inch 15W x 2CH Output 21 Inch 10W x 2CH 5W x 2CH Sound Vitual Dolby Option Effect Turbo Sound Pseudo Stereo RCA Input Front Option S-VHS (AV2) Head-Phone AV1 : Scart I/O, RGB Input, Jacks RF Out 2Scart Input/Output AV2 : Scart I/O, Monitor Out Back Option
Streszczenie treści zawartej na stronie nr. 13
Alignment and Adjustments 4. Alignment and Adjustments 4-1 General Alignment Instructions 1. Usually, a color TV-VCR needs only slight 5. Avoid overload. Excessive signal from a touch-up adjustment upon installation. Check sweep generator might overload the front-end the basic characteristics such as height, of the TV. When inserting signal markers, do horizontal and vertical sync and focus. not allow the marker generator to distort test results. 2. Observe the picture for good black and
Streszczenie treści zawartej na stronie nr. 14
Alignment and Adjustments 4-4 Dynamic Focus Adjustment 1. A dynamic focus adjustment should be done after replacing the CRT PCB, FBT or CRT. ❶ 2. Input a crosshatch pattern. 3. Enter “ STANDARD “ in video mode. 4. Turn the Dynamic focus VR fully clockwise (maximum).( ) ❶ ❷ 5. Turn the Static focus VR fully counterclockwise (maximum).( ) ❷ 6. Slowly turn the static focus VR counterclockwise. Adjust until the ❷ STATIC FOCUS VR vertical line in the middle of the screen H has maximum clarity
Streszczenie treści zawartej na stronie nr. 15
Alignment and Adjustments 5. Turn the SCREEN VR until “MRCR G B” and “MRWDG” are green and those value are about 100. (The incorrect SCREEN Voltage may result that “MRCR G B” and “MRWDG” should be red) Note 1. When you do not have Toshiba Pattern, follow this method. 1. Set the TV on the condition that AV mode no signal(black) 2. Enter the “Menu” and set the mode to blue screen off. 3. Enter the “Service Mode”. 4. Select “ G2-Adjust”. 5. Set the values as below. IBRM = 220 WDRV =
Streszczenie treści zawartej na stronie nr. 16
Alignment and Adjustments 2 4-6 E PROM (IC902) Replacement 1. When IC902 is replaced, all adjustment data revert to the initial values. So, all adjustment values when servicing should be readjusted. 2. After IC902 is replaced, connect the AC power supply cord. 3. Turn the power switch ON. 4. In stand-by, warm up the TV for at least 10 seconds. 5. Power on the TV. 4-7 White Balance Adjustment Equipment : Color-Analyzer (CA-100) Input Signal : Pattern signal (Toshiba pattern) 1. Select STAN
Streszczenie treści zawartej na stronie nr. 17
Alignment and Adjustments 4-8 Factory Adjustment 4-8-1 Service Mode 1. To enter the “Service Mode”, Press the remote-control keys in this sequence : - If you do not have Factory remote-control DISPLAY() PICTURE OFF PICTURE ON MENU MUTE - If you have Factory remote-control PICTURE ON DISPLAY() FACTORY 2. After the Service Mode is entered, the initial screen is as shown in the figure below. Service Deflection Video Adjust 1 Video Adjust 2 Video Adjust 3 Option(81h 0Ch) * These hexa digits are
Streszczenie treści zawartej na stronie nr. 18
Alignment and Adjustments 4-8-2 Memory Data 4-8-2(A) DEFLECTION (GEOMETRIC ADJUSTMENT VALUE) Fixed Value Initial No. OSD Range Function Remark Value 1 V Shift -128 ~127 -30 Adjust Vertical Picture Position -7 2 V Amp -128 ~127 Adjust Vertical Picture Size 3 V Slope -3 Adjust Vertical Slope Correction -128 ~127 4 V SC -128 ~127 -17 Not to be adjusted Adjust Vertical S-Correction 5 H EW -128 ~127 73 Adjust Horizontal Picture Size 6 H Trapizium -128 ~127 -47 Adjust Horizontal Trapeziod H Parabola
Streszczenie treści zawartej na stronie nr. 19
Alignment and Adjustments 4-8-2(B) SCREEN CHANGE (I2C BUS GEOMETRIC ADJUSTMENT) 1 V Shift 6 V Amp 2 V Slope 7 V SC 8 3 H EW H Trapizium 9 H Symmetry 4 H Parabola 5 H Corner 10 H Shift Samsung Electronics 4-7
Streszczenie treści zawartej na stronie nr. 20
Alignment and Adjustments 4-8-2(C) VIDEO ADJUST 1 Fixed Value Initial No. OSD Range Function Remark Value 1 Red Cufoff Adjust Red Cutoff Level 0 ~255 127 2 0 ~255 Adjust Green Cutoff Level Low Light Green Cutoff 127 Adjust Blue Cutoff Level 0 ~255 3 Blue Cutoff 127 Adjust Red Output Gain 4 Red Drive 0 ~255 127 High Light Adjust Green Output Gain 5 Green Drive 0 ~255 127 6 Blue Drive 0 ~255 127 Adjust Blue Output Gain 100 Low Light 7 Sub Bright 0 ~ 200 Adjust Brightness Level High Light 8 Sub Co
