Instrukcja obsługi JL Audio Stealthbox SB-GM-HUMRH2/12W6v2/DG

Streszczenie treści zawartej na stronie nr. 1

®
Stealthbox
INSTALLATION GUIDE START
HERE
for the
SB-GM-HUMRH2/12W6v2
(2003-Up Hummer H2)
➔ ➔ ➔
STEP 1: Remove the third “jump” seat. *STEPS 2-4 are for the vehicle that are STEP 3: Remove the jack and jack tools.
equip with the internal spare tire.*
STEP 2: Remove the spare tire
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
➔ ➔ ➔
oughly before beginning the project. It
will guide you step by step through the
i

Streszczenie treści zawartej na stronie nr. 2

Cont. From Previous Page ➔ ➔➔➔ STEP 7: With the plastic trim out of the way, STEP 8: Rest the plastic inner wheel well on the STEP 9: (Inside the vehicle) Cut and remove STEP 10: Place the supplied pair of wax sheets remove the plastic inner wheel well. rear tire. Keep the trim and all the mounting hard- the factory jute(sound deadening), from the into place. ware together. removed storage area, from STEP 5. Remember to remove the rear paper backing, from the wax sheets. ➔➔ ➔ STEP 11: Thread the

Streszczenie treści zawartej na stronie nr. 3

Cont. From Previous Page ➔ ➔➔➔ STEP 15: Back out the socket cup set screws, that STEP 16: (Outside the vehicle) Place the sup- STEP 17: Mount the plastic inner wheel well and *STEPS 18-24 are for only for the vehicles was threaded in from STEP 11, to expose 1-1/4”. plied hardware in order onto the exposed socket plastic trim from STEPS 6 & 7. that are equip with the internal spare tire.* cup screw. If more exposed threads are needed, back Connect the speaker wire to the terminal and place You di

Streszczenie treści zawartej na stronie nr. 4

Cont. From Previous Page CONGRATULATIONS! INSTALL COMPLETE. ➔ ➔➔ ➔ Included Hardware: STEP 23: Replace the jack and the jack tools, that STEP 24: Secure the spare tire onto the rack and (2) 3” x 3”Wax sheets were removed in STEP 3. replace the tire cover. (2) 3/8”-16 x 2-1/4” Socket Cup Set Screw (2) 3/8” x 1-1/4” Fender Washer (2) 3/8” USS Flat Washer (2) 3/8” - 16 HEx Nuts (2) 1/2”(w) x 1”(od) Spacers (2) 12mm x 70mm Hex Cap Screws Difficulty Of Installation: Specifications: Mid/High Frequency