Instrukcja obsługi Winegard RS-1500

Streszczenie treści zawartej na stronie nr. 1

MODEL RS-1500
OMNIDIRECTIONAL TV/FM ANTENNA
NOTE: Please read all instructions before beginning installation!
WARNING!
To prevent FIRE or SHOCK HAZARD, avoid exposure of power
supply to moisture.
PARTS LIST
1. (1) Antenna
2. (1) 15' RG-6 Low Loss Coax Cable
3. (1) Cable Tool
4. (1) Power Supply RV-7542
#5. HEX FLANGE NUTS
#1. ANTENNA
5. (4) 1/4-20 Hex Flange Nuts
6. (4) 1/4-20 Carriage Bolts
#6. CARRIAGE
7. (2) Insulated Quick-Disconnect
BOLT
Terminals
8. Mount
#13. ANTENNA
9. (4) Lag S

Streszczenie treści zawartej na stronie nr. 2

OPTION 2: Run cable supplied down through mount The Parts: base and out open slot in base of antenna mount. See Option 2 figure below. Finish routing cable to wall plate. ANTENNA OPTION 2 OPTION 1 1” DIAMETER MOUNT 1” DIAMETER MOUNT & SCREWS (provided). & SCREWS (provided). INSTALL CABLE DO NOT USE ANTENNA MOUNTING GASKET PLUG CABLE GASKET BRACKET PLUG COAXIAL CABLE LARGE MOUNT LARGE MOUNT GASKET GASKET SMALL ANTENNA REMOVE SMALL REMOVE SMALL GASKET ANTENNA GASKET ANTENNA GASKET 1” DIAMETER MOUN

Streszczenie treści zawartej na stronie nr. 3

CONNECTING POWER SUPPLY FIGURE 5 1. Select location for power supply. Run two coax cables (Wiring diagram) (three if Set 2 jack is going to be used) (RG-59 type) between locations and install connectors on each end. 2ND Set Hook Up Mark cables so "cable input", "TV output" "Set 2" No +12 VDC may be identified. Antenna downlead and +12 VDC at this point also needed at inside power supply location. See wiring Auxillary diagram, Figures 5 and 6. Satellite Receiver Connection 2. To mount the power s

Streszczenie treści zawartej na stronie nr. 4

WHAT TO DO WHEN YOUR RV/TV ANTENNA IS NOT WORKING PROPERLY HOW YOUR SYSTEM WORKS WARNING DO NOT install couplers, splitters, etc. between power 2ND Set supply and antenna. Installation of any item on the Hook Up downlead MAY CAUSE A SHORT IN THE SYSTEM. The No +12 VDC downlead supplies +12 VDC to preamp in antenna. at this point Auxillary HOW YOUR SYSTEM WORKS Satellite Receiver Turning power supply on sends +12 VDC up cable to Connection antenna. Voltage energizes transistors on amplifier in an