Streszczenie treści zawartej na stronie nr. 1
MITEL
5000 Communications Platform (CP)
IP DECT Stand
Configuration and Administration Guide
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
Part Number 57011426 5000 Communications Platform (CP) IP DECT Stand Configuration and Administration Guide Issue 1.0, May 2010
Streszczenie treści zawartej na stronie nr. 4
Streszczenie treści zawartej na stronie nr. 5
Notice This guide is released by Mitel Networks Corporation as a guide for certified service personnel. It provides information necessary to properly configure, maintain, and operate the product. The contents of this document reflect current company standards and are subject to revision or change without notice. Some features or applications mentioned may require a future release and are not available in this release. Future product features are subject to availability and cost. Some features
Streszczenie treści zawartej na stronie nr. 6
Product Disposal Instructions This symbol indicates that the product is classified as electrical or electronic equipment and should not be disposed of with other commercial or household waste at the end of its working life. For appropriate disposal and recycling instructions, contact your local recycling authority or Inter-Tel provider. The Waste of Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC) was established by the European Union to minimize negative impact on the envir
Streszczenie treści zawartej na stronie nr. 7
Contents Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Requirements and Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Optional Repeater . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 About the Handset Connection Status Indicators . . . . . .
Streszczenie treści zawartej na stronie nr. 8
Contents Network Configuration Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 IP Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 File Transfer Protocol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 DHCP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 9
Introduction Introduction The Mitel 5610 Cordless Handset and IP DECT (Digital Enhanced Cordless Telecommunications) Stand provide basic Mitel 5000 Communications Platform (CP) phone features on a cordless handset. The IP DECT Stand supports up to eight cordless handsets. Each handset is programmed as a separate extension on the 5000 CP. The IP DECT Stand connects to the network through the PC port on a Mitel 5312, 5320, 5324, 5330, 5340, or 5360 IP Phone. The IP DECT Stand provides call tra
Streszczenie treści zawartej na stronie nr. 10
About the Handset Connection Status Indicators To determine if a handset call is being supported by the repeater by using the verification tone: 1. Enable the verification tone feature on the stand. (Refer to the RTX4002 DECT Repeater User Manual for instructions.) By default, this tone is disabled. 2. Initiate a call from the handset in the repeater area when this tone is enabled. If the call is being supported by the repeater, you hear the verification tone (a single tone repeated every 2.5
Streszczenie treści zawartej na stronie nr. 11
5610 Cordless Handset Feature Set 5610 Cordless Handset Feature Set This section lists the features available for the 5610 Cordless Handset and IP DECT Stand product. • Call and telephony features o Up to eight cordless handsets per stand o Maximum of three simultaneous calls per stand o Call forward all, on busy, or on no answer o Call timer o Call transfer and call hold o Caller ID with name from phone book o Distinctive ringing o Call log of incoming/outgoing/missed calls o Call return (from
Streszczenie treści zawartej na stronie nr. 12
Related Documentation • Quality of service o Type of Service (ToS) • CODECs o G.711 (64 kbps, A-law & u-law) o G.729 • Interoperability o DECT interface (3081) or DECT 6.0 (3080) o WiFi friendly o Maximum Range from stand: 50 m (150 ft) indoors, 300 m (900 ft) outdoor NOTE These features are subject to change without notice. Related Documentation 5610 Cordless Handset and IP DECT Stand Installation Guide (part number 57011091): This guide provides instructions on how to physically connect the I
Streszczenie treści zawartej na stronie nr. 13
Registration and Configuration Registration and Configuration After you have physically connected the IP DECT Stand to a Mitel IP Phone, you must program the handsets in the 5000 CP database and register the handsets with the IP DECT Stand. You can then configure the 5610 Cordless Handsets for operation using any of the following methods: • from a web browser, such as Internet Explorer (recommended method) • through the menu on the 5610 Cordless Handset • via a configuration file that you ins
Streszczenie treści zawartej na stronie nr. 14
Register the Handsets with the IP DECT Stand Register the Handsets with the IP DECT Stand To register a handset with the IP DECT Stand (gateway), place the handset in the charging cradle. The first handset automatically registers with the IP DECT Stand after approximately 30 seconds. To register each additional handset on the same IP DECT Stand, you must first reboot the stand by pressing the RESET button on the rear panel of the stand. While the stand is resetting, “Searching for Gateway” a
Streszczenie treści zawartej na stronie nr. 15
Configure all Handsets Using the Configurator Web Interface Configure all Handsets Using the Configurator Web Interface You access the IP DECT Stand Configurator web interface by entering the IP address of the IP DECT Stand into the address field on a web browser (such as Internet Explorer) on a PC connected to the local network. The following procedure covers the minimum configuration required to set up the handsets: 1. Press the Volume Up key on the side of the 5610 Cordless Handset to ente
Streszczenie treści zawartej na stronie nr. 16
Configure all Handsets Using the Configurator Web Interface 7. Use the menu items in the left frame of the web page to perform the configuration. The following steps provide basic configuration of a handset. See IP DECT Stand Configuration Notes on page 16 for additional details. Figure 2. Example of IP DECT Stand Configurator Web Interface 8. In the left frame of the Configurator web interface, click VoIP Account 1. 9. Enter the following information. Leave the other fields at the defaults. T
Streszczenie treści zawartej na stronie nr. 17
Configure all Handsets Using the Configurator Web Interface Table 1. Handset Settings (Continued) Field Setting Account Mailbox Number Enter the extension number of the voice mail automated attendant. Registrar Enter the IP Address or FQDN of the host 5000 CP. Authentication Username Enter the handset extension number (as programmed on the 5000 CP). DTMF Signaling Set to RFC2833. (Note that the DTMF Encoding Setting in the 5000 CP SIP phone Call Configuration field must also be set to RFC2
Streszczenie treści zawartej na stronie nr. 18
Configure all Handsets Using the Configurator Web Interface To have calls that are made to each account only ring the associated handset, complete the grid as shown in the following example. In the example below, the grid is configured such that calls to Account 1 ring Handset 1 and Handset 2. Calls to Account 2 ring Handset 2 only, and calls to Account 3 ring Handsets 1 and 3. 13. Under Outgoing Identity to be used for, do the following: • Assign an account to each registered handset. If you
Streszczenie treści zawartej na stronie nr. 19
Configure Handset from the Handset Display Menu 15. In the left frame of the Configurator web interface, click Time Settings, and then do the following: • Enter the hostname of a Time Server on the internet, for example: pool.ntp.org • Enter the time server refresh interval, for example: 255 • Set the time difference between Greenwich Mean Time (GMT) and your current location. For example, if you were located in New York, USA, which observes EST you would set the Timezone field to – 5:00 hour
Streszczenie treści zawartej na stronie nr. 20
Configure Handset from the Handset Display Menu 14. Using the handset dial pad, enter the settings listed in the following table. To enter spaces and special characters, press Options and then press Insert symbols. Table 2. Handset Settings Menu Item Setting Display name Enter the user name assigned to this handset. User name Enter the handset extension number (as programmed on the 5000 CP). Note that you need to change the input mode from alphabetical to numeric using the Option softkey. Ac
