Instrukcja obsługi UNICOM Electric MICROGST-8

Streszczenie treści zawartej na stronie nr. 1

MicroGST-5
MicroGST-8
5 or 8 Port 10/100/1000Base-T
Desktop Switch
MicroGST-5 GEP-32005T-1
MicroGST-8 GEP-32008T-1
908 Canada Court
City of Industry, CA 91748 U.S.A.
Phone: 626.964.7873 or 800.346.6668 Fax: 626.964.7880
www.unicomlink.com e-mail: info@unicomlink.com
USER’S MANUAL
©UNICOM 2009. UNICOM and “A Network Systems Solution” are trademarks of UNICOM Electric, Inc.
All rights reserved. Specifications subject to change without notice.
Rev: 10.09

Streszczenie treści zawartej na stronie nr. 2

Streszczenie treści zawartej na stronie nr. 3

The information in this guide may be changed without notice. The manufacturer assumes no 1. Introduction responsibility for any errors which may appear in this guide. Ethernet is a trademark of XEROX Corporation. Microsoft, Windows and Windows logo are trademarks of Microsoft Corporation. Thank you for purchasing Unicom’s MicroGST-5 or MicroGST-8 Desktop Copyright 2009. All right are reserved. No Part of the contents of this guide maybe transmitted or Gigabit Switch. Before you start installing

Streszczenie treści zawartej na stronie nr. 4

2. Installation 4 Technical Specifications This chapter describes the function of the switch components and
MicroGST-5 (5-Port 10/100/1000T switch) shows how to install it on your network. Basic knowledge of networking Ports 5-Port 1000Base-T Buffer Memory 104 KB is assumed. Read this chapter completely before installation. MAC Address 1000 Jumbo Frame 9 KB Size (W x D x H) Metal case: 109 x 84 x 27 (mm) Plastic case: 120 x 84 x 32 (mm) 2.1 Front View and LEDs Weight Metal case: 0.48 kg Figure

Streszczenie treści zawartej na stronie nr. 5

wires of 1,2,3,6 are reversed so that wire 1 become 3 at the other end 2.2 Rear View of the cable, 2 becomes 6, and so forth. Figure 2.1-1 illustrates the rear panel of the MicroGST-5 Switch; To determine which wire is wire 1, hold the RJ-45 plug with the spring Figure 2.1-2 illustrates the rear panel of the MicroGST-8 Switch. clip facing towards the ground and the end pointing away from you. The Table 2.2-1 shows the port function of both switches. copper wires exposed upwards to your view. The

Streszczenie treści zawartej na stronie nr. 6

2.3 Installing the switch 3. Specifications The MicroGST-5 and 8 Switches do not need software configuration. To install the switches, simply complete the following steps: 3.1 Cable Specifications
Table 3-1 lists the cables you can use and their specifications. Step 1 Select a location for your switch.
Put the switch on a sturdy surface. Caution:
Please do not use telephone cables. Telephone cables do not support Keep enough ventilation space between the switch and the Ethernet or Fast Eth