Instrukcja obsługi Extron electronic sJMP 9600 HD

Streszczenie treści zawartej na stronie nr. 1

JMP 9600 • Setup Guide
This guide provides quick start instructions for an experienced installer to set up and operate the Extron®
JMP 9600 HD and JMP 9600 2K Media Players.
NOTE: For full installation, configuration, and operation details, see the
JMP 9600 Media Player User Guide, available at www.extron.com.
The JMP 9600 Media Player is a high quality video and audio playback device that provides one
or two video playback channels. Depending on the model, the player supports playback of vid

Streszczenie treści zawartej na stronie nr. 2

JMP 9600 • Setup Guide f LTC Input and Output connectors — LTC Input connector — Connect an external LTC sync signal to this RCA connector for the media player to function as a sync slave of another device. LTC Output connector — Connect any downstream equipment that requires an LTC sync signal to this RCA connector to either route the external sync signal throughout the system or for the media player to function as a sync master. g L

Streszczenie treści zawartej na stronie nr. 3

JMP 9600 • Setup Guide l Dual Redundant AC Power Input connectors — Connect standard IEC power cords between one rear panel AC Power Input connector and a 100 to 240VAC, 50-60 Hz power source. WARNING: Physically disconnect both power cables from the player before opening the case for servicing. NOTE: • Although the unit performs reliably while running on a single AC power supply, doing so defeats the dual- redundant power supply feature. • Connect the dual power cords to either uninterruptibl

Streszczenie treści zawartej na stronie nr. 4

JMP 9600 • Setup Guide Load and Play a Presentation Load and play a presentation as follows: NOTE The player must be correctly configured for the clip or playlist that you select using the Settings > Video submenu, or else the player does not load the selected clip or playlist and the LCD reports ERROR. 1. Rotate the encoder to highlight the Ch. 1 Status selection or Ch. 2. Status selection. NOTE: The Ch.2 Status selection is only available when the media player is in 2-channel output mode and