Instrukcja obsługi Encore electronic ENH908-NWY

Streszczenie treści zawartej na stronie nr. 1

ENH908-NWY
8 Port Switch

User Guide
0

Streszczenie treści zawartej na stronie nr. 2

The ENH908-NWY is a powerful, high-performance Fast Ethernet switch, with all ports capable of 10 or 100Mbps auto-negotiation operation (NWay), which means the switch could automatically negotiate with the connected partners on the network speed and duplex mode. It is ideal for micro-segmenting large networks into smaller, connected subnets for improved performance, enabling the bandwidth demanding multimedia and imaging applications. Compared to the shared 10Mbps or 100Mbps networks

Streszczenie treści zawartej na stronie nr. 3

Please refer to the following table for LED definition 8port LED Status Operation Power Steady Green Power is on Off Power is off Link/Act Steady Green The port is connected Blinking Green The port is transmitting/receiving data. Off No connection Rear Panel 8port 2

Streszczenie treści zawartej na stronie nr. 4

Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table. In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable. As all the ports support auto MDI / MDI-X function, using a straight cable to

Streszczenie treści zawartej na stronie nr. 5

Standard IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3x full duplex operation and flow control Interface 8* 10/100Mbps RJ-45 Fast Ethernet Ports Uplink Auto MDI/MDI-X （Auto crossover ） Network Speed 10/100Mbps & Full/Half duplex mode auto detection MAC Address 1K MAC address entries Table Memory 768KBytes (8port) Power Supply External Power adapter 5V DC 0.6A EMI CE, FCC 4

Streszczenie treści zawartej na stronie nr. 6

FCC Certifications This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio c