Streszczenie treści zawartej na stronie nr. 1
2 CHANNEL / 4 CHANNEL / 5 CHANNEL
AUTOMOTIVE AMPLIFIER
G2-600 / G2-800 / G2-1200
G4-600 / G4-800 / G4-1000
G5-900
INSTRUCTION MANUAL
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
Congratulations on your Purchase Your new high fidelity bridgeable/stereo amplifier is designed to deliver maximum enjoy ment and one year of trouble free service. Please take a few moments to read this manual thoroughly. It will explain the features and operation of your unit and help insure trouble free installation. Features • Four Class ''AB'' High-Current Dual Discrete Drive Stages. • Class ''AB'' Technology MOSFET PWM Power Supply. • Bridgeable & TRI-Mode Operation. • Continuously Vari
Streszczenie treści zawartej na stronie nr. 4
• NEVER operate the amplifier without the proper power and ground wire, 10 gauge minimum. • NEVER operate the amplifier without proper fusing. Fuse holder must be located with in 0.5 meters from the battery. This fuse is to protect the car not the electronics. In case of a short, the fuse will blow instead of the wire burning up. Using other than the recommended fuse ratings at the battery and at the amplifier may cause damage to the amplifier and will void your warranty. • Do not
Streszczenie treści zawartej na stronie nr. 5
INSTALLATION MOUNTING: 1. After reading precaution, decide where you are going to install the unit. Also, see Fig.1. 2. Once the location has been determined, place the amplifier into position. Using a felt tip pen or pencil mark the four holes to be drilled for mounting. NEVER use the amplifier as a template for drilling. It is very easy to damage the amplifier surface in this manner. 3. Remove amplifier. Drill four 3.5 m/m holes into mounting surface. If you want to mount the ampl
Streszczenie treści zawartej na stronie nr. 6
CONNECTIONS INPUT CONNECTIONS This amplifier will accept low level inputs only. Low level is the same as line level. The low level signal is carried through RCA cables. It is preferred to use low level inputs to the amplifier if the head unit is equipped with the low level outputs. If not, you can use a "high to low converter" available through your local car audio shop. Connect the low level/line level RCA cables from the head unit, or signal processor, to the line level input on the ampli
Streszczenie treści zawartej na stronie nr. 7
2CHANNEL SYSTEM WIRING DIAGRAM LINE INPUT GAIN BASS L.P.F H.P.F CH1 L.P.F H.P.F 6V 0.2V 0dB 12dB 50Hz 250Hz 80Hz 1.2KHz FLAT CROSSOVER REMOTE CH2 CH1 CH2 +12V REM GND CAR STEREO HEAD UNIT FIG.2 5 AUTO - ANTENNA LEAD
Streszczenie treści zawartej na stronie nr. 8
4CHANNEL SYSTEM WIRING DIAGRAM LINE INPUT GAIN BASS FREQUENCY FREQUENCY BASS GAIN LINE INPUT CH1 CH3 L.P.F H.P.F H.P.F L.P.F 6V 0.2V 0dB 12dB FLAT 50Hz 500Hz 50Hz500Hz FLAT 0dB 12dB 6V 0.2V CH 1/2 CH 3/4 CH2 CH4 CH1 CH2 CH3 CH4 +12V REM GND CAR STEREO HEAD UNIT FIG.2 6 AUTO - ANTENNA LEAD
Streszczenie treści zawartej na stronie nr. 9
5CHANNEL SYSTEM WIRING DIAGRAM CH 1/2 LINE INPUT LINE INPUT CROSSOVER CROSSOVER GAIN L.P.F H.P.F H.P.F L.P.F CH1 CH3 CH5 FLAT FLAT 6V 0.2V 50Hz 250Hz 80Hz 1.2kHz80Hz 1.2kHz 50Hz 250Hz L.P.F H.P.F GAIN CH2 CH4 CH6 6V 0.2V 50Hz 250Hz FLAT 80Hz 1.2kHz 6V 0.2V CH 3/4 CH 5 CH1 CH2 CH3 CH4 CH5 CH6 +12V REM GND CAR STEREO HEAD UNIT FIG.2 7 AUTO - ANTENNA LEAD
Streszczenie treści zawartej na stronie nr. 10
SPEAKER CONNECTIONS This amplifier can operate in one, two or three channel mode. The minimum impedance for single channel (bridged/mono) operation is 4 or 8 ohms. Tri channel power is referred to stereo and mono at the same time. Minimum impedance remains the same for three channel (front /subwoofer) systems as long as proper passive crossovers are used. Connect right and left speaker wire to corresponding speaker output terminals of the amplifier. Be sure to have the positive wire from th
Streszczenie treści zawartej na stronie nr. 11
SPEAKER CONNECTIONS 4 CH SPEAKER WIRING DIAGRAM 2 SPEAKER BRIDGED 4 CHANNEL AMPLIFIER G4-1000 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH1 CH2 CH2 40A 40A CH3 CH3 CH4 CH4 4-8 Ohms 2 CH 1 CH 2 SPEAKER + 1 SUBWOOFER 4 CHANNEL AMPLIFIER G4-1000 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH1 CH2 CH2 40A 40A CH3 CH3 CH4 CH4 2-4 Ohms 3 CH 2-4 Ohms 1CH 2 CH SUB WOOFER 4-8 Ohms 4 SPEAKER STEREO 4 CHANNEL AMPLIFIER G4-1000 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH1 CH2 CH2 40A 40A CH3 CH3 CH4 CH4 2-
Streszczenie treści zawartej na stronie nr. 12
SPEAKER CONNECTIONS 5 CH SPEAKER WIRING DIAGRAM 3 SPEAKER BRIDGED 5 CHANNEL AMPLIFIER G5-900 SPEAKER BRIDGED POWER GND REM B+ FUSE CH1 CH1 CH2 CH2 CH5 40A 40A CH3 CH3 CH4 CH4 CH5 2-8 Ohms 3 CH 2 CH 4-8 Ohms 1 CH 5 SPEAKER STEREO 2-4 Ohms 1 CH 2 CH 5 CHANNEL AMPLIFIER G5-900 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH1 CH2 CH2 CH5 40A 40A 2-8 Ohms CH3 CH3 CH4 CH4 CH5 5 CH 3 CH 4 CH 2-4 Ohms SUBWOOFER 7 SPEAKER HEX MODE 4-8 Ohms 5 CH 4-8 Ohms 1 CH 2 CH 5 CHANNEL AMPLIFIER G5-900 SPEAKER POWER BR
Streszczenie treści zawartej na stronie nr. 13
ADJUSTMENTS 1.Set to the "H.P.F" position when the amplifier is used to drive a tweeter/midrange system. The frequencies below the crossover point will be attenuated at 12dB/octave. Permits adjustment of the crossover frequency ,by rotating the knob to select any frequency between 80Hz to 1.2kHz & 50Hz to 500Hz as the crossover point. 2.Set to the "L.P.F" position when the amplifier is used to drive a subwoofer. The frequencies above the crossover point will be attenuated at 12dB /
Streszczenie treści zawartej na stronie nr. 14
FRONT/REAR PANEL 2CHANNEL LINE INPUT GAIN BASS L.P.F H.P.F CH1 L.P.F H.P.F 6V 0.2V 0dB 12dB 50Hz 250Hz 80Hz 1.2KHz FLAT CH2 CROSSOVER REMOTE G2-600/800/1200 front 2 CHANNEL AMPLIFIER G2-600 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH2 40A G2-600 REAR 2 CHANNEL AMPLIFIER G2-800 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH2 30A 30A G2-800 REAR 2 CHANNEL AMPLIFIER G2-1200 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH2 40A 40A G2-1200 REAR 4CHANNEL LINE INPUT GAIN BASS FREQUENCY FREQUENCY BASS GAIN
Streszczenie treści zawartej na stronie nr. 15
FRONT/REAR PANEL 4CHANNEL 4 CHANNEL AMPLIFIER G4-600 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH1 CH2 CH2 40A CH3 CH3 CH4 CH4 G4-600 REAR 4 CHANNEL AMPLIFIER G4-800 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH1 CH2 CH2 30A 30A CH3 CH3 CH4 CH4 G4-800 REAR 4 CHANNEL AMPLIFIER G4-1000 SPEAKER POWER BRIDGED GND REM B+ FUSE CH1 CH1 CH2 CH2 40A 40A CH3 CH3 CH4 CH4 G4-1000 REAR 5CHANNEL CH 1/2 LINE INPUT LINE INPUT CROSSOVER CROSSOVER GAIN L.P.F H.P.F H.P.F L.P.F CH1 CH3 CH5 FLAT FLAT 6V 0.2V 50Hz 250
Streszczenie treści zawartej na stronie nr. 16
TROUBLE SHOOTING GUIDE. This section provides you with a catalog of amplifier symptoms and their probable causes and solutions. Before you consult this listing, make sure the vehicle's electrical system is working properly by verifying that other electrical items (e. g. headlights, windows, etc.) Still function correctly. SYMPTOM PROBABLE CAUSE SOLUTION No Audio Low or N.C Remote Check remote turn-on voltage at Turn-on connections amp and head unit Blown Fuse Replace with new fa
Streszczenie treści zawartej na stronie nr. 17
SPECIFICATION AMPLIFIER G2-600 G2-800 G2-1200 4 OHMS @ 0.05% THD 100W x 2 150W x 2 225W x 2 4 OHMS Bridged 0.5% THD 200W x 1 300W x 1 450W x 1 MAXIMUM OUTPUT POWER 600 Watts 800 Watts 1200 Watts BASS LEVEL REMOTE YES (OPTIONAL) YES (OPTIONAL) YES (OPTIONAL) CONTROL(16.4Ft) 50Hz-250Hz 50Hz-250Hz 50Hz-250Hz LOW PASS FILTER (VARIABLE) (VARIABLE) (VARIABLE) 80Hz-1.2kHz 80Hz-1.2kHz 80Hz-1.2kHz HIGH PASS FILTER (VARIABLE) (VARIABLE) (VARIABLE) FREQUENCY RESPONSE 10Hz-40kHz 10Hz-40kHz 10Hz-40kHz (-
Streszczenie treści zawartej na stronie nr. 18
SPECIFICATION AMPLIFIER G4-600 G4-800 G4-1000 G5-900 60W x 4 4 OHMS @ 0.05% THD 60W x 4 90W x 4 110W x 4 + 160W x 1 120W x 2 4 OHMS Bridged 0.5% THD 105W x 2 175W x 2 225W x 2 + 160W x 1 MAXIMUM OUTPUT POWER 600 Watts 800 Watts 1000 Watts 900 Watts BASS LEVEL REMOTE N/A N/A N/A N/A CONTROL(16.4Ft) 50Hz-500Hz 50Hz-500Hz 50Hz-500Hz 50Hz-250Hz LOW PASS FILTER (VARIABLE) (VARIABLE) (VARIABLE) (VARIABLE) 50Hz-500Hz 50Hz-500Hz 50Hz-500Hz 80Hz-1.2kHz HIGH PASS FILTER (VARIABLE) (VARIABLE) (VARIABLE)
Streszczenie treści zawartej na stronie nr. 19
WARRANTY WARRANTY LIMITATIONS WARRANTY TERMS The following is NOT covered under Interfire (Effective January 01, 2010) Audio's warranty program: These terms supersede all prior published warranty terms 1. Product owned by anyone other than the Interfire Audio products are warrantied against original purchaser from an authorized defects in materials and workmanship for a Interfire Audio dealer. (The warranty is period of One (1) Year from the original date of NOT transferable and will not
Streszczenie treści zawartej na stronie nr. 20
Interfire Audio, Inc. Santa Fe Springs, CA 90670 www.interfireaudio.com Printed in PRC
