Instrukcja obsługi Genz-Benz SHUTTLE 6.2 STL6-2-210T

Streszczenie treści zawartej na stronie nr. 1

Owner’s Manual
Model# STL6-2
®
PRODUCT DESCRIPTION – The SHUTTLE 6.2 represents the 2nd generation
®
of our widely acclaimed SHUTTLE series of light weight, high output bass
amplifiers. This model has been designed with our unique ULTRA LIGHT
unified design process, yielding a 600 watt professional high powered tour-class
®
bass guitar amplifier, weighing only 3.75 lbs! This 2nd generation SHUTTLE
amplifier now incorporates our unique 3-Dimensional Power Management
circuitry along with

Streszczenie treści zawartej na stronie nr. 2

FRONT PANEL ® INPUT – The SHUTTLE 6.2 is equipped with a standard ¼” unbalanced input. The input sensitivity range is from 40 mV to 1.6 volts. The input impedance is >500K ohms. The input stage contains a precision high order active high pass filter (more effective and less intrusive than the more common 6 dB filters) and an “RFI” filter (radio frequency interference) to eliminate unwanted noise. The input gain stage consists of a feedback type variable gain circuit that provides wide ra

Streszczenie treści zawartej na stronie nr. 3

® ACTIVE EQUALIZATION – The SHUTTLE 6.2 contains an active 3 band equalizer with sweepable parametric mid range frequency control. This equalizer, similar to those found on professional sound consoles, is a very useful tool. The low frequency EQ section is an 80 Hz shelving curve with 15dB of cut or boost. The high frequency EQ section is a 4 KHz shelving curve with 15dB of cut or boost. The parametric sweepable-mid frequency section features 15dB of cut or boost with a bandwidth approxim

Streszczenie treści zawartej na stronie nr. 4

REAR PANEL DIRECT OUTPUT – An XLR balanced direct output is provided for connection to a PA system or directly into a recording studio console or A/D converter. The Direct Out signal may be switched between mic and line level, pre and post EQ, and the audio signal ground may be connected or lifted from pin 1 to eliminate hum due to ground loops. This output is fully protected against 48 volt phantom power and may be used for driving microphone lines of up to 300 feet without problems. ® TU

Streszczenie treści zawartej na stronie nr. 5

FAN COOLING – The chassis is cooled via a thermal sensing fan design. The fan is always ON but will increase in speed as demand on the amp increases. Do not obstruct the left or right chassis vents. ® SPEAKER OUTPUTS – The SHUTTLE 6.2 provides two Neutrik Speak-On™ connectors (wired 1+/1-). The speaker jacks are paralleled. The minimum speaker load is 4 ohms. Do not ground either the “+” or the “-” outputs. ® POWER INPUT – VOLTAGE SELECTOR SWITCH - The SHUTTLE 6.2 utilizes rear panel switc

Streszczenie treści zawartej na stronie nr. 6

STL6-2-12T COMBO - This model produces 375 watts into the 8 ohm combo configuration and 600 watts when used with an additional 8 ohm extension cabinet. It will be necessary to use a Neutrik Speak-On™ connection when using an extension cabinet with this combo. The speaker is our proprietary high power GBE 12350, high energy 12” Neodymium cast frame driver coupled with our GBE 4941 tweeter. A 100 watt tweeter level control is provided to adjust the output of the tweeter. STL6-2-210T COMBO -

Streszczenie treści zawartej na stronie nr. 7

WARNING! • The use and operation of this device constitutes an agreement of full release of any and all liability connected with its use. Only persons familiar with the operation of high-powered professional audio equipment should attempt to operate this device. • In addition, by use of this device, the user agrees to hold Genz Benz and its designers, sales agents and all other affiliates and related parties harmless in the event of any accident, injury, damage, or loss resulting from s