Streszczenie treści zawartej na stronie nr. 9
ECO mode Dimmer Setting the clock Reduces power consumption with the following operations, etc. Adjusts the brightness of the display. 1 Press SHIFT+CLOCK on the remote control. When the unit is turned off, you can also press aSET. ECO ON mode 1 Press DEMO/ECO twice when the unit is turned - The unit blacks out when the unit is turned off. Only the red on, and then within 4 seconds press ENTER. 2 Press f or g to set the time. indicator lights up. (Only when the clock is set.) Each press changes
Streszczenie treści zawartej na stronie nr. 10
CD OPERATIONS To replace disc(s) during playback without interruption While one disc is being played back, press DISC CHANGE so that the compartment opens, replace disc(s) with other one(s), and press DISC CHANGE to close the compartment. Random/Repeat playback Random playback plays all the tracks on one desired disc or all the discs in random order. Repeat playback plays all the tracks En repeatedly on one desired disc or all the discs. 1 Press SHIFT+RANDOM/REPEAT repeatedly on the remote contr
Streszczenie treści zawartej na stronie nr. 11
To check the program Notes on CDs Programmed playback Press f or g repeatedly during stop. The track number •Do not place more than one disc on one tray. Plays back up to 30 selected tracks in programmed order. and program number are displayed in succession. •Do not tilt the unit with discs loaded. 1 Press SHIFT+PROGRAM on the remote control • The unit may not play a CD-R/RW disc recorded on personal To clear the program during stop. computers or certain kinds of CD-R/RW recorders. Press s durin
Streszczenie treści zawartej na stronie nr. 12
RADIO OPERATIONS Tuning in to preset stations On the unit 1 Turn the Dial Function to select the TUNER function and press BAND to select a band. 2 Press c repeatedly or turn MULTI JOG. With each press, the station with the succeeding preset number is tuned in. En On the remote control 1 Press FUNCTION repeatedly to select the TUNER function and press BAND to select a band. 2 Press the numbered buttons for the preset number of your desired station. -To select preset number 20, press +10, +10 and
Streszczenie treści zawartej na stronie nr. 13
Adjustments Antennas Keep antennas away from metallic objects, electrical equipment and cords. FM antenna: Extend fully and position for the best reception. If receiving condition is poor, connect optional outdoor antenna to FM 75 Ω terminal. Be sure to connect the shield braid of the antenna to the 2 terminal. AM antenna: Rotate to find best reception. En To switch to monaural FM reception Press SHIFT+TUNER MODE on the remote control. With each press, "MONO" and "STEREO" are displayed alternate
Streszczenie treści zawartej na stronie nr. 14
TAPE OPERATIONS To reset the tape counter Press s in stop mode, and the tape counter on the display is reset to "0000". Opening and closing the cassette holder will also reset the tape counter. To play continuously (DECK 1 to DECK 2 ) Load tapes in both decks and start playback on DECK 1. Then, as soon as playback on DECK 1 finishes, playback on DECK 2 will start without interruption. En •The both decks play one side of the tapes. To play back type II (High position) tapes Turn MULTI JOG until "
Streszczenie treści zawartej na stronie nr. 15
2 Prepare the source. To record less than a 4-second blank space, press wREC/ 2 Turn the Dial Function to select the CD function To record CD(s), select the CD function and load disc(s). REC MUTE again while "REC" flashes. and load disc(s). To record a radio broadcast, tune in to the desired station. To record more than a 4-second blank space, press wREC/ 3 Press SHIFT+CD EDIT/CHECK once on the remote To record a tape, insert the source tape in DECK 1 and REC MUTE again after the unit enters rec
Streszczenie treści zawartej na stronie nr. 16
9 Press wREC/REC MUTE to start recording on To prevent accidental erasure Programmed Edit Recording side A. Break off the plastic tab of the cassette tape with a screwdriver As you program the CD tracks to record, Programmed Edit On the remote control, press REC MODE and then press or other pointed tool. To record on the tape again, cover the Recording displays the remaining recording time for each side wREC/REC MUTE within 3 seconds. detection slot with adhesive tape. of the tape, so you can ea
Streszczenie treści zawartej na stronie nr. 17
SOUND ADJUSTMENTS Setting a curve manually The equalization curve can be customized to suit your preference. 1 Press SOUND repeatedly to select one of the three frequency ranges to adjust. - BASS: Low range frequencies - MID: Middle range frequencies - TRE: High range frequencies En 2 Turn MULTI JOG (press PRESET N or M on the remote control) to adjust the level within 4 seconds. 3 Repeat Step 1 and 2 to adjust all the three ranges if necessary. To display the current GEQ mode Graphic equalizer
Streszczenie treści zawartej na stronie nr. 18
TIMER OPERATIONS 5 Press f or g to adjust the volume level, then press ENTER or aSET. Adjust from 0 to 26. 6 Prepare the source. To play CD(s), load disc(s). To play the radio, select the band and tune in to the desired station. To play a tape, insert the tape and select the deck. To play external equipment connected to the VIDEO/AUX En jacks, set an external timer for the equipment so that its playback begins at the same time. 7 Press POWER 6STANDBY/ON to turn the unit off. At timer-on time, th
Streszczenie treści zawartej na stronie nr. 19
To display the timer setting Timer recording Press TIMER. Timer recording is available only for TUNER and VIDEO/AUX The timer-on time, the source and the timer-activated duration (with an external timer) sources. are displayed for 6 seconds. 1 Press TIMER (SHIFT+TIMER on the remote Tip: Timer setting can be displayed even while the unit is turned control) repeatedly until "5REC" appears on the display. off, and at that time if you press ENTER or a within 6 seconds after TIMER is pressed, you can
Streszczenie treści zawartej na stronie nr. 20
REFERENCE Condensation Care and maintenance Troubleshooting Moisture may form on the CD pickup lens when: Occasional care and maintenance of the unit and the software If your unit fails to perform properly, check the following guide •The unit is moved from a cold spot to a warm spot are needed to optimize the performance of your unit. and the relevant sections of the Operating Instructions. •The heating system has just been turned on •The unit is used in a very humid room To clean the cabinet Th
Streszczenie treści zawartej na stronie nr. 1
OPERATING INSTRUCTIONS En (English)
CD Stereo System
MANUAL DE INSTRUCCIONES
E (Español)
NSX-D70
U C
MODE D'EMPLOI F (Français)
OWNER'S RECORD
Record the model number and serial number of your set (found at the
rear of your set) below. Refer to them when contacting your Aiwa dealer.
Model No. _____________________________
Serial No. _____________________________
For assistance and information
(United States and Puerto Rico)
8C-NF6-903-11
020201BKH-U-M
Streszczenie treści zawartej na stronie nr. 2
IMPORTANT SAFETY INSTRUCTIONS WARNING Read the Operating Instructions carefully and completely before Ventilation - The unit should be situated with adequate space To reduce the risk of fire or electric shock, do not expose operating the unit. Be sure to keep the Operating Instructions around it so that proper heat ventilation is assured. Allow 10 this appliance to rain or moisture. for future reference. All warnings and cautions in the Operating cm clearance from the rear and the top of the un
Streszczenie treści zawartej na stronie nr. 3
TABLE OF CONTENTS Overloading - Do not overload wall outlets, extension cords, Lightning IMPORTANT SAFETY INSTRUCTIONS ......... 2 integral convenience receptacles as this can result in a risk of For added protection for this unit receiver during a lightning PREPARATIONS ................................... 4 fire or electric shock. storm, or when it is left unattended and unused for long periods PARTS AND CONTROLS ......................... 5 of time, unplug it from the wall outlet and disconnect
Streszczenie treści zawartej na stronie nr. 4
PREPARATIONS 2 Connect the supplied antennas. Connection Remote control Strip off the insulation of the FM antenna with twisting Plug in the AC power cord to the AC power outlet after all other Detach the battery compartment lid at the rear of the remote the cord. connections are made. control and insert two R6 (size AA) batteries with correct Connect the FM antenna to the FM 75 Ω terminal without polarity. the 2 mark and the AM antenna to the AM LOOP 1 Connect the front speakers. terminals. Con
Streszczenie treści zawartej na stronie nr. 5
PARTS AND CONTROLS Main unit: rear Dynamic Integrated Neo Amplifier is a brand-new amplifier system where clear mid-to-high range 1 AM LOOP, FM 75 Ω terminals frequency sound, as well as rich low frequency sound, can be Plug in the supplied AM and FM antennas here. reproduced and listeners can enjoy the close-to-original sound 2 VIDEO/AUX jacks with less distortion at either high or low volume levels. Accepts analog sound signals from external equipment. Connect using an optional connecting cabl
Streszczenie treści zawartej na stronie nr. 6
Main unit: front 3 SYNC DUB MODE Starts dubbing a whole tape. Enters the setting mode of Graphic Equalizer or Spectrum analyzer display. wREC/REC MUTE Starts recording. SOUND Selects a frequency range of Graphic Equalizer to adjust 4aPAUSE/SET the level. CD and Tape: pauses playback. En ENTER Radio: stores the received station to preset. Determines the mode and the time (ECO, dimmer, clock sSTOP/CLEAR and timer). CD and Tape: stops playback. Radio: clears a station preset. 6 DISC DIRECT PLAY 1-
Streszczenie treści zawartej na stronie nr. 7
Remote control 3 The numbered buttons take on these functions when pressed 5 SHIFT Hold down when pressing a numbered button to change together with SHIFT held down: its function to that printed above the number. PROGRAM e.g.) Enters programmed CD playback mode. "Press SHIFT+SLEEP on the remote control" indicates "Hold down SHIFT and press '6' (SLEEP)", so that you RANDOM/REPEAT can use 'Sleep timer' function. Enters random or repeat CD playback mode. En 6 REC MODE TUNER MODE Starts recording wi
Streszczenie treści zawartej na stronie nr. 8
ADJUSTMENTS BEFORE OPERATIONS DEMO If the clock has not been set, a DEMO appears on the display when the unit is turned off. To deactivate and activate the DEMO Press DEMO/ECO when the unit is turned off. Spectrum analyzer display En You can change the spectrum analyzer display. Press MODE twice and then within 4 seconds turn MULTI JOG to select one of the three spectrum analyzer displays. On the remote control, press SHIFT+DISPLAY repeatedly. - NORMAL: Displays the fluctuation from low frequenc
