Instrukcja obsługi Pro-Ject RPM 5

Streszczenie treści zawartej na stronie nr. 1

INSTRUCTIONS FOR USE
Pro-Ject RPM 5

Streszczenie treści zawartej na stronie nr. 2

1 1 © Audio Trade GmbH · Pro-Ject RPM 5 · Revision 20.2.06/1.5.06 2

Streszczenie treści zawartej na stronie nr. 3

PRO-JECT RPM 5 Controls, features and connections 1 Motor transportation screw (marked red) 2 Stepped drive pulley 3 Drive belt * 3a Hook * 4 Hub 5 Platter * 6 Tonearm counterweight * 6a Downforce scale 7 Tonearm lift lever 8/18 Tonearm rest and removable transport lock 9 Tonearm tube 9a Tonearm base 13 Power supply socket 14 Phono output sockets and earth connection 15 Anti-skating weight adjustment scale 16 Anti-skating weight * 17 Anti-skating wei

Streszczenie treści zawartej na stronie nr. 4

Set-up Screw the three feet (23) onto the threaded bolts located on the underside of the plinth. Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it. Fit the drive belt (3) around the hub (4) and the smaller diameter part of the motor pulley (2). Avoid getting sweat or grease on the belt as these will deteriorate the performance and reduce the belt's lifespan. Use absorbent kitchen paper to remove any oil or grease from th

Streszczenie treści zawartej na stronie nr. 5

Adjusting the vertical tracking angle (vta) Put a record and the record weight on the platter. When the needle is lowered into the record groove and the tonearm is not resting on the lift arm, the tube of the tonearm should be parallel to the surface of the record. If it is not loosen both allen screws in the tonearm base just enough to allow vertical movement of the arm pillar without force and slide the arm up or down until it is parallel. Carefully retighten the allen screws without ap

Streszczenie treści zawartej na stronie nr. 6

Mains power connection The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the power supply to the socket (13) on the rear of the record player before connecting the power supply to the mains. Switching on and off Pressing the power switch (20) alternately starts or stops the motor. Changing replay speed Using the accessory too

Streszczenie treści zawartej na stronie nr. 7

Potential incorrect use and fault conditions PRO-JECT turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the m

Streszczenie treści zawartej na stronie nr. 8

Accessories Please remove feet bevore repacking Tonearm transport lock Platter Tonearm counterweight Power supply © Audio Trade GmbH · Pro-Ject RPM 5 · Revision 20.2.06/1.5.06 8 !