Instrukcja obsługi Auralex Acoustics Elite Pro Systems EPS-168T

Streszczenie treści zawartej na stronie nr. 1

™
Elite Pro Systems
EPS-168T
Installation Guidelines
™ ®
Congratulations on purchasing an EPS-168T System from Auralex Acoustics. You’re
now on your way to creating a world class listening environment.
Elite Pro Systems offer a sophisticated look by utilizing products covered with specialized
™ ™
acoustical fabrics. The EPS-168T system contains B22 ProPanels , CT45 Bass Traps and
™
ProFusors , which when used together, provide incredibly effective acoustical control in
any room. Use the EPS

Streszczenie treści zawartej na stronie nr. 2

Elite Pro System EPS-168T General Information Recommended Additional Installation Materials • Power Drill • Tape measure • Carpenters Level • Small ladder (depending on ceiling height) • Nail Set • Hammer • Pencil • 32 2.5” 4D finish nails • Straight Edge • 256 .75”-1” drywall screws B22 ProPanel Installation Guide Mark intended location of each B22 Install four impaling clips within marked B22 ➊ ➋ ProPanel on the wall or ceiling. ProPanel location using drywall screws. Exact placement of each

Streszczenie treści zawartej na stronie nr. 3

CT45 Bass Trap Installation Guide Mark a vertical line 16.75” from the intended Hold CT45 Bass Trap in corner with edges ➊ ➋ placement corner on both sides. aligned to the marked vertical lines. 16.75” While continuing to hold panel in place, install Using a nail set or other finish nail, carefully ➌ ➍ one finish nail though the fabric face and the countersink installed nail so its head goes hardened edge of the CT45. Make sure finish through the fabric surface of the CT45 but not nail is i

Streszczenie treści zawartej na stronie nr. 4

Elite Pro System Installations Hold the ProFusor to the wall or ceiling in its Within traced ProFusor outline, mark another ➊ ➋ intended location with the back facing out. rectangle 4” in from both sides, 5.25” down from Make sure diffusor is level. Completely trace its the top and 2.75” up from the bottom. Install one Z- outline. Clip in each corner of the marked inner rectangle using drywall screws, as shown. Traced 5.25” ProFusor Outline 4” 4” Marked inner rectangle 2.75” Set ProFusor in