Instrukcja obsługi AudioSource 10-Band Graphic Equalizer EQ200

Streszczenie treści zawartej na stronie nr. 1

EQ 200
OWNER’S MANUAL
EQ 200
Ten-Band Stereo Graphic Equalizer
Congratulations on your purchase of the AudioSource® EQ 200.
FEATURES:
Please take a few moments to read this entire manual, and be sure to
retain this document for future reference. Please read and observe all
Ten Bands from 30 Hz to 16 kHz +/-12dB
safety instructions detailed on page 2.
Spectrum Analzyer Display
NOTE: If any part of this product is damaged or missing, please call your
Tape 1 / Tape 2 play-record loops
dealer or

Streszczenie treści zawartej na stronie nr. 2

EQ 200 OWNER’S MANUAL CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL! The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. EXPLANATION OF SAFETY SYMBOLS The lightning flash with the arrowhead symbol

Streszczenie treści zawartej na stronie nr. 3

EQ 200 OWNER’S MANUAL A Few Words about Graphic Equalizers Thank you for choosing this AudioSource EQ 200 Graphic Equalizer. Used correctly, a Graphic Equalizer is a powerful tool for very detailed control over the sound of your speakers, far more than available from simple tone controls. With the EQ 200, you can enhance the sound of older recordings, alter instrumental and vocal balance to suit your own tastes, make “Custom Equalized” recordings, and a multitude of other uses. However, like any

Streszczenie treści zawartej na stronie nr. 4

EQ 200 OWNER’S MANUAL Using the Controls (continued) 7. Level Controls 9. EQ Sliders (continued) Both left and right channels have a control marked “Level”. This controls Looking at the front panel, the sliders that control the lowest frequencies the level, or volume of each channel. Usually, these controls can be are on the left, with the higher frequencies farther right. Usually, set to their maximum position, but these levels can be reduced if an identical adjustments should be made for bot