Streszczenie treści zawartej na stronie nr. 1
AUDIO RECEIVER
KRF-A4030
INSTRUCTION MANUAL
About the supplied remote control (RC-R0708) . . .
Compared to standard remote controls, the remote control supplied with this receiver has
several operation modes. These modes enable the remote control to control other audio
components. In order to effectively use the remote control it is important to read the
operating instructions and obtain a proper understanding of the remote control and how to
switch its operation modes (etc.).
Using the remote c
Streszczenie treści zawartej na stronie nr. 2
Preparations Operations Other Before applying the power Caution : Read this page carefully to ensure safe operation. Units are designed for operation as follows. Unpacking Europe and U.K. ................................................................. AC 230 V only 2 Russia ................................................................................. AC 220 V only Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any p
Streszczenie treści zawartej na stronie nr. 3
Getting started Special features Contents 3 Caution : Read the pages marked carefully to ensure MONITOR safe operation. The TAPE2/MONITOR jacks of this unit accept the connec- tion of a cassette deck, graphic equalizer, surround proces- sor, etc. When a 3-head cassette deck is connected to the Preparations TAPE2/MONITOR jacks, it is possible to monitor the sound which has just been recorded during recording. @ Before applying the power ................................... 2 Safety precautions ..
Streszczenie treści zawartej na stronie nr. 4
Preparations Operations Other Setting up the system Caution : Read this page carefully to ensure safe operation. Make connections as shown below. Connecting audio components When connecting the related system components, be 4 sure to also refer to the instruction manuals supplied with the components you are connecting. Do not connect the power cord to a wall outlet until all connections are completed. Shape of AC outlets Microcomputer malfunction For U.K. If operation is not possible or an erron
Streszczenie treści zawartej na stronie nr. 5
Setting up the system Connecting the antennas Connecting the speakers 5 AM Antenna terminal connections 1 Strip coating. 2 Push lever. 1 Push lever. 2 Insert cord. 3 Return lever. 3 Insert cord. 4 Return lever. AM loop antenna The supplied loop antenna is for use indoors. Place it as far as possible from the receiver, TV set, speaker cords and power Front Speakers A Front Speakers B cord, and adjust the direction for best reception. Left Right Left Right FM indoor antenna The supplied indoor ant
Streszczenie treści zawartej na stronie nr. 6
Preparations Operations Other Setting up the system Connecting the system control 6 Do not connect a system control cord to a cassette Connecting system control cords after connecting a deck connected to the TAPE2/MONITOR jacks. KENWOOD audio component system lets you take advantage of convenient system control operations. This unit is compatible only with the [SL-16] mode. The SYSTEM CONTROL operations system control operation is not available if the unit is connected in the [XS-8], [XS], or [X
Streszczenie treści zawartej na stronie nr. 7
Names and functions of parts Main unit 7 Band indicators TUNED indicator MEMO indicator MUTE indicator STEREO indicator Speaker indicators RDS indicator SP. A B MUTE TA NEWS TP PTY MEMO MEMO STEREO TUNED EON RDS indicator FM AUTO TI. VOL AM S.DIRECT S.DIRECT indicator MHz TAPE 2/MONI ******.** kHz AUTO indicator Frequency display, Input display, TAPE 2/ MONI indicator Preset channel display Display VOLUME CONTROL STANDBY MULTI CONTROL INPUT SELECTOR BALANCE PTY TA/NEWS DISPLAY SOUND SOURCE DIREC
Streszczenie treści zawartej na stronie nr. 8
Preparations Operations Other Names and functions of parts Remote control unit 8 BAND (6) key # If tuner is selected as the input source, this key functions as the band selector key. If CD is selected as the input source, this key functions as the play/pause key. 1 2 3 POWER If MD is selected as the input source, this key functions as 0 the play key. 4 5 60 DISC SKIP, A/B, +100 key 1 If CD is selected as the input source, this key functions as 7 8 9 +10 the multi-CD player disc skip key. If TAPE
Streszczenie treści zawartej na stronie nr. 9
Names and functions of parts Preparing the remote control 9 Loading the batteries 1 Remove the cover. 2 Insert the batteries. 3 Close the cover. • Insert two AA-size (R06) batteries as indicated by the polarity markings. Operation When the “STANDBY” indicator is lit, the power turns ON when you press the POWER ( ) key on the remote control. When the power comes ON, press the key you want to operate. Remote sensor Operating range (Approx.) 6 m 30˚ 30˚ Model: RC-R0708 Infrared ray system • When pr
Streszczenie treści zawartej na stronie nr. 10
Preparations Operations Other Normal playback ON/STANDBY Selecting the speaker system SPEAKERS A B INPUT SELECTOR 10 POWER MULTI CONTROL BALANCE VOLUME CONTROL Press the SPEAKERS A or B key to select the speaker system to be used. A ON : Sound from the speakers connected to the SPEAKERS A terminals on the rear panel. B ON : Sound from the speakers connected to the SPEAKERS B terminals on the rear panel. A+B ON : Sound from both the speakers connected to SOUND SOURCE DIRECT AUTO the SPEAKERS A an
Streszczenie treści zawartej na stronie nr. 11
Normal playback Adjusting the sound 11 Adjusting the tone SOURCE DIRECT playback Use this function to pass the source material direct to the Use the following procedure to adjust the bass and treble amplifier, by passing any audio processing. levels. Press the SOURCE DIRECT (S.DIRECT) key. 1 Press the SOUND key to select the tone mode to be SP. A B adjusted. S.DIRECT TAPE1 BASS : Select this to adjust the low frequency range. (Press the SOUND key once.) • Switch to another input source to cancel
Streszczenie treści zawartej na stronie nr. 12
Preparations Operations Other Recording TAPE2/MONITOR function MULTI CONTROL INPUT SELECTOR 12 You can connect a cassette deck or graphic equalizer to the TAPE2/MONITOR jacks of the receiver. If a graphic equalizer is connected, the TAPE2/MONITOR key should be left in the on position. Alternately, if a cassette deck equipped with a 3-head system is connected to theTAPE2/ MONITOR jacks, you will be able to monitor the just- SOUND TAPE2 /MONITOR recorded signal while making recordings on the cass
Streszczenie treści zawartej na stronie nr. 13
Listening to radio broadcasts Tuning (non-RDS) radio stations Using RDS (Radio Data System) 13 Radio stations can be classified into RDS (Radio Data System) RDS is a system that transmits useful information (in the form stations and other stations. To listen to or store RDS stations of digital data) for FM broadcasts along with the broadcast in the preset memory, see the section entitled, “Using RDS”. signal. Tuners and receivers designed for RDS reception can extract the information from the br
Streszczenie treści zawartej na stronie nr. 14
Preparations Operations Other Listening to radio broadcasts Using the DISPLAY key Presetting RDS stations 14 (RDS AUTO MEMORY) (Main unit only) Pressing the DISPLAY key changes the contents of the This function automatically stores up to 30 stations including display. the RDS stations and ordinary FM stations in the preset memory. In order to use the EON and PTY functions, the RDS Each press switches the display mode as follows: stations must be stored in the preset memory using the RDS AUTO MEM
Streszczenie treści zawartej na stronie nr. 15
Listening to radio broadcasts Presetting radio stations manually Receiving preset stations 15 The RDS auto memory function assigns preset numbers to 1Use the input selector (INPUT SELECTOR) to select RDS stations starting from preset number ”01“. Therefore, the tuner. be sure to execute the RDS auto memory function before using the following operations to manually store AM stations 2Using the remote control unit, enter the number of and other FM stations, and RDS stations. the preset you want t
Streszczenie treści zawartej na stronie nr. 16
Preparations Operations Other Listening to radio broadcasts “NO PROG” is displayed if this operation is attempted Tuning by program type (PTY search) before performing the RDS AUTO MEMORY operation. 16 This function lets you set the tuner to automatically search for stations which are currently broadcasting the type of program 3Press the PTY key to start searching. (genre) you want to listen to. Example: Searching for a Rock Music broadcast. Under certain receiving conditions, it may take more D
Streszczenie treści zawartej na stronie nr. 17
Listening to radio broadcasts 2Press the TA/NEWS key to select the information When waiting for information while listening type of your choice. 17 to a RDS station without the EON function Display When ”TA“ is selected TA TP PTY PTY STEREO SP. A B MUTE EON TUNED FM If the “EON” indicator does not light in steps 3 and 4 and AM AUTO S.DIRECT MHz TAPE 2/MONI BBC 1F M kHz the desired kind of information has already been selected, the information from only the station being received will ”TP“ light
Streszczenie treści zawartej na stronie nr. 18
Preparations Operations Other In case of difficulty Resetting the Microcomputer If the microcomputer may malfunction (unit cannot be With the power cord plugged in, turn the POWER key 18 operated, or shows an erroneous display) if the power cord OFF. Then, while holding down the ON/STANDBY is unplugged while the power is ON, or due to some other key, press the POWER key. external factor. If this happens, execute the following pro- cedure to reset the microcomputer and return the unit to its norm
Streszczenie treści zawartej na stronie nr. 19
In case of difficulty Remote control unit Cause Symptom Remedy 19 • Batteries are exhausted. • Replace with new batteries. 9 Remote control operation is not • The remote control unit is too far away •Operate the remote control unit within possible. from the main system, controlling angle the controllable range. is too large, or there is an obstacle be- tween the receiver and the remote. • The audio cords and system control cords •Connect properly referring to “Setting are not connected properly.
Streszczenie treści zawartej na stronie nr. 20
Preparations Operations Other Caution : Read this page carefully to ensure safe operation. Specifications [ AUDIO section ] [ AM tuner section ] Rated power output during STEREO operation Tuning frequency range................... 531 kHz ~ 1,602 kHz 20 (DIN) 1 kHz, 0.7 % at 4 W ........................ 105 W + 105 W Usable sensitivity (30% mod., S/N 20 dB) (IEC) 63 kHz ~ 12.5 kHz, 0.5 % at 4 W.. 100 W + 100 W ......................................................... 16 μV / (600 μV/m) Total har
