Instrukcja obsługi Knoll Systems MA850

Streszczenie treści zawartej na stronie nr. 1

Warranty
Knoll Systems warrants MA850 amplifiers sold in the USA and Canada by
MA850 Amplifier
authorized Knoll dealers to be free of defects in materials and workmanship. This
8 Channel Amplifier
warranty extends for three full years from the date of purchase by the original
consumer. Any products returned to Knoll Systems and found to be defective by
Installation Instructions v1.2
Knoll Systems within the warranty period will be repaired or replaced at Knoll

Systems decision, at n

Streszczenie treści zawartej na stronie nr. 2

Important Safety Instructions: Hum and noise In most cases, one of the following suggestions should help you 1) Read these instructions. solve a hum noise in your system. Please try these steps in the 2) Keep these instructions. order shown, proceeding from one step to the next if the prior 3) Read all warnings. suggestion does not eliminate the problem. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. Suggestion #1 7) Do not blo

Streszczenie treści zawartej na stronie nr. 3

Knoll Systems service information Installation The MA850 amplifier does not contain any user serviceable parts inside. Installing the MA850 should be relatively easy. With a bit of If you suspect a problem that may require servicing, contact us at planning, the MA850 will give trouble free service for years. www.knollsystems.com/contact.html, or by phone at 800 566-5579. 1. The most important consideration when installing the Troubleshooting MA850 is cooling. The MA850 has a lot of

Streszczenie treści zawartej na stronie nr. 4

10. Connect the AC power into an outlet than can supply at least four amps (550 watts) dedicated to each MA850. Caution: Never listen to sound that is distorted. If distorted The trigger is 12 VDC (35mA per MA850) via 3.5mm mono sound is heard, turn the volume down immediately or speaker jack. 5 VDC trigger outputs will not work. To connect the and/or amplifier damage could occur that is not covered by the trigger to a receiver use a 12 VDC power supply (we warranty. If this prob