Instrukcja obsługi OEM Systems NTO FOUND SE-791E

Streszczenie treści zawartej na stronie nr. 1

For 6-1/2" In-Wall Loudspeakers 1-Piece Baffle & Frame
AMPLIFIER OPERATION
These speakers will perform well with amplifiers
from 5 to 125 Watts RMS. However, damage to
the speakers can be done by amplifiers of nearly
any power rating if the amplifier is overdriven into
clipping. “Amplifier clipping” is a phrase used to
describe a condition when, because of the volume
demand, an amplifier is being asked for more
power than it can give. Clipping causes distortion
of the audio signal. I

Streszczenie treści zawartej na stronie nr. 2

For 6-1/2" In-Wall Loudspeakers 1-Piece Baffle & Frame Try to keep the wire length to a minimum. However, allow about 2½ feet of free wire at the speaker cut-out and sufficient length at the electronics to aid in the ease of installation. Adding extra wire later is tedious and time consuming. Avoid bundling speaker cables parallel to electrical cables for extended lengths. Though the impedance speakers to be placed will not be obstructed by a stud is low and the likelihood of