Streszczenie treści zawartej na stronie nr. 1
i50 Scanner
i60 Scanner
User’s
Guide
A-61182
Streszczenie treści zawartej na stronie nr. 2
Contents Contents............................................................................................................... i Introduction ........................................................................................................ 1 Safety .............................................................................................................. 2 Safety and regulatory agency approvals ......................................................... 2 Acoustic emission ............
Streszczenie treści zawartej na stronie nr. 3
Requirements and software installation........................................................ 10 Installing the scanner drivers ........................................................................ 10 Scanning your documents .............................................................................. 11 Loading documents....................................................................................... 11 Using the ADF....................................................................
Streszczenie treści zawartej na stronie nr. 4
Color Adjustment............................................................................. 18 Auto Level ....................................................................................... 18 Advanced Settings........................................................................... 18 Highlight / Shadow........................................................................... 19 Curves............................................................................................. 20
Streszczenie treści zawartej na stronie nr. 5
Maintenance...................................................................................................... 27 Cleaning the glass scanning areas ............................................................... 27 Cleaning the ADF.......................................................................................... 28 Replacing the ADF snap-in feed module ...................................................... 29 Troubleshooting.............................................................
Streszczenie treści zawartej na stronie nr. 6
Introduction Thank you for purchasing a KODAK scanner. • The KODAK i50 Scanner is a desktop simplex color scanner. • The KODAK i60 Scanner is a desktop duplex color scanner. Both scanners have automatic document feeders and flatbed platens to accommodate a wide range of general purpose, departmental, and office capture needs. Before you install and operate your scanner, take a few minutes to read through this guide. It contains information about how to install, operate, and maintain your scann
Streszczenie treści zawartej na stronie nr. 7
• Use only the power supply that was provided with the scanner (Sino-American Safety model SA60-24). IMPORTANT: Do not substitute another power supply model or another manufacturer’s power supply. • Avoid the danger of electric shock. Only use the scanner and power supply indoors in a dry location. • When positioning the scanner, make sure that the electrical power outlet is located within 1.52 metres (5 feet) of the scanner and is easily accessible. • Locate the scanner on a stable, level work
Streszczenie treści zawartej na stronie nr. 8
Electromagnetic compliance statements This equipment has been tested and found to comply with the limits for a Class B For the United States digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi
Streszczenie treści zawartej na stronie nr. 9
Scanning specifications You can use the i50 Scanner and i60 Scanner to scan documents that have a paper Acceptable paper sizes weight between 50 and 105 g (14 and 28 lb.) and that are within the following sizes: In the ADF (automatic document feeder) • 94 x 140 mm (3.7 x 5.5 in.) minimum • 216 x 356 mm (8.5 x 14 in.) maximum On the flatbed • up to A4 size (8.3 x 11.7 in.) Do not use the ADF (automatic document feeder) to scan the document types listed Document types to avoid below. Instead, use
Streszczenie treści zawartej na stronie nr. 10
Installation Unpack the scanner carefully and check the contents. If any items are missing or damaged, contact your authorized dealer immediately. • Keep the scanner out of direct sunlight. Direct exposure to sun or excessive heat Precautions may cause damage to the unit. • Do not install the scanner in a humid or dusty area. • Be sure to use the proper AC power source. • Place the scanner securely on a level surface. Tilted or uneven surfaces may cause mechanical or paper-feeding problems. • Ke
Streszczenie treści zawartej na stronie nr. 11
1. Make sure that the scanner is off. Locking the scanner 2. Raise the document cover to reveal the flatbed platen and scanning unit. 3. Turn on the scanner. The scanning unit begins moving. 4. Wait until the scanning unit has moved to the end (opposite the scanner ADF). 5. Turn the scanner off after the scanning unit has finished moving. 6. Place the scanner in an upright position on its front. 7. Lock the scanner by moving the shipping switch (located on the bottom of the scanner) to the locke
Streszczenie treści zawartej na stronie nr. 12
When you have several devices on a SCSI chain, you may need to adjust the SCSI SCSI interface device ID ID selector on the scanner. This selector assigns a specific device ID to the scanner. If the assignment conflicts with an existing SCSI device, select a new ID. NOTE: The factory setting for the scanner is ID 6. ID 0 is usually assigned to an internal hard disk drive and ID 7, ID 8, and ID 9 are not in actual use. The scanner will not operate properly if the SCSI ID is set to ID 7, ID 8, or I
Streszczenie treści zawartej na stronie nr. 13
There are two trays on the scanner: the ADF tray for loading documents to be scanned Adjusting the trays through the automatic document feeder and the output tray which receives scanned documents from the ADF. ADF tray 1. Lift the ADF tray to about a 45° angle. 2. Pull the ADF tray wire leg down on top of the clips on the document cover. Wire leg Clips 3. Press down slightly on the ADF tray to snap the wire leg into the clips. ADF tray 4. Pull the ADF tray extension wire out to the desired len
Streszczenie treści zawartej na stronie nr. 14
1. Lift the output tray to about a 30° angle. Output tray 2. Insert the three protrusions on the output tray into the three slots on the ADF. 3. Release the output tray. POWER LED (green) READY LED (green) ERROR LED (red) Protrusion Output tray extension wire Output tray 4. Make sure that the output tray is firmly attached to the ADF. 5. Pull the output tray extension wire out to the desired length. Make sure that you press the I/O power switch and not the SCSI terminator switch Powering up the
Streszczenie treści zawartej na stronie nr. 15
Requirements and software installation To operate the scanner at its optimum speed, the following minimum configuration is required. NOTE: The actual performance of the system depends on the scanning application, choice of scanning parameters, and the PC configuration. If the scanner is not performing at the optimal speed, using a faster PC and/or more RAM may be necessary to obtain the rated throughput. • IBM PC (or compatible) with a Pentium 933 MHz processor • Microsoft Windows 95, Windows 98
Streszczenie treści zawartej na stronie nr. 16
Scanning your documents Make sure that the scanner is on and has completed its self-test before you turn on Loading documents the PC to begin scanning. See the section entitled “Scanning specifications” for information about the sizes and types of documents that you can scan. Using the ADF Use the ADF to feed multiple documents automatically in a batch. 1. Fan documents before loading to prevent paper jams. 2. Place the documents face down under the balance wire in the ADF tray, with the leading
Streszczenie treści zawartej na stronie nr. 17
1. Open your scanning application. Scanning with TWAIN or ISIS 2. Choose Select Source or Select Scanner on the File menu. If the Select Source or Select Scanner command is not available on the File menu, see your application’s user’s guide to determine how the application link is used. A dialog box with a list of scanning sources appears. 3. Select your Kodak scanner model. You need to select the source only once, unless you want to choose another scanner. 4. Place the document to be scanned in
Streszczenie treści zawartej na stronie nr. 18
Making the most of your scanned images The features in the TWAIN and ISIS dialog boxes are described in this section. Note that not all features are available at all times. The availability of some features may depend on the scanner model or other feature selections. Select how you want to scan on the Scan Method drop-down menu. Scan Method TWAIN ISIS Simplex/One-page—select this Simplex—select this setting if you are setting if you are using the automatic using the automatic document feeder doc
Streszczenie treści zawartej na stronie nr. 19
Select the mode you want to use for your scans on the Image Type drop-down menu. Image Type Black and White—the image appears in black and white with no intermediate shades of gray. That means that each pixel of the image is either 100% black or 100% white. Choose Black and White if you are scanning text or pen and ink drawings. Since only one bit of black or white information is required per pixel, the file size of a Black and White image is only about 1/24 the size of a 24-Bit Color image. Hal
Streszczenie treści zawartej na stronie nr. 20
Resolution or dots per inch (dpi) indicates the scanning resolution, which largely Resolution determines the quality of the scanned image. The greater the resolution, the better the reproduction will be. However, scanning at a higher resolution also increases scanning time and file size. Therefore, up to a certain dpi level, the resolution will not be visually improved, but the file size will be larger. Tips An A4-size color image scanned at 300 dpi in 24-Bit Color mode is approximately 25 MB in
