Streszczenie treści zawartej na stronie nr. 1
P3PC-1922-01ENZ0
fi-5530C2 Image Scanner
Operator's Guide
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
CONTENTS ■ Regulatory Information ....................................................... vii ■ Note of Liability .................................................................... ix ■ Safety Precautions .............................................................. xii Chapter 1 BASIC SCANNER OPERATIONS........................... 1 1.1 Turning the Scanner ON .................................................... 2 1.2 Placing Documents on the ADF ........................................ 6 1.3
Streszczenie treści zawartej na stronie nr. 4
2.9 Correcting Skew............................................................... 71 2.10 To Output Multi-Images................................................... 74 2.11 Color/Monochrome Auto Detection ............................... 77 2.12 Splitting a Page in Two Pages........................................ 79 2.13 Removing Punch Holes from Images ............................ 81 2.14 Scanning by Pressing the Scan Button on the Scanner .....................................................
Streszczenie treści zawartej na stronie nr. 5
Chapter 6 DOCUMENT SPECIFICATIONS FOR ADF ........ 131 6.1 Document Size................................................................ 132 6.2 Document Quality........................................................... 133 6.3 Maximum ADF Capacity................................................. 137 6.4 Area Not To Be Perforated............................................. 138 6.5 Specifying How to Detect Multifeed.............................. 139 Chapter 7 SCANNER SPECIFICATIONS ..........
Streszczenie treści zawartej na stronie nr. 6
iv
Streszczenie treści zawartej na stronie nr. 7
INTRODUCTION Thank you for purchasing the fi-5530C2 Duplex Color Scanner. This document describes how to handle the fi-5530C2 and basic operations. Before you start using the fi- 5530C2, be sure to read this manual thoroughly to ensure correct use. ■Regulatory Information FCC declaration This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmf
Streszczenie treści zawartej na stronie nr. 8
Bescheimigung des Herstellers / Importeurs Für den fi-5530C2 wird folgendes bescheinigt: •In Übereinsstimmung mit den Bestimmungen der EN45014(CE) funkentstört •Maschinenlärminformationsverordnung 3.GPSGV: Der höchste Schalldruckpegel beträgt 70 dB (A) oder weniger, gemäß EN ISO 7779. ® International ENERGY STAR Program ® As an ENERGY STAR Partner, PFU LIMITED has determined that this ® product meets the ENERGY STAR guidelines for energy efficiency. ® The International ENERGY STAR Office Equip
Streszczenie treści zawartej na stronie nr. 9
■Note of Liability READ ALL OF THIS MANUAL CAREFULLY BEFORE USING THIS PRODUCT. IF THIS PRODUCT IS NOT USED CORRECTLY, UNEXPECTED INJURY MAY BE CAUSED TO USERS OR BYSTANDERS. Also, keep this manual in a safe place so that it can be easily referred to during use of this product. While all efforts have been made to ensure the accuracy of all information in this manual, PFU assumes no liability to any party for any damage caused by errors or omissions or by statements of any kind in this manual
Streszczenie treści zawartej na stronie nr. 10
How Trademarks Are Indicated in This Manual Operating systems (OS) are indicated as follows: ® ® Windows 2000: Microsoft Windows 2000 Professional operating system ® ® Windows XP: Microsoft Windows XP Professional operating system (32/64-bit) ® ® Microsoft Windows XP Home Edition operating system ® ® TM Windows Server 2003: Microsoft Windows Server 2003 Standard Edition operating system (32/64-bit) ® TM Windows Vista: Microsoft Windows Vista Home Basic operating system (32/64-bit) ® TM Microsof
Streszczenie treści zawartej na stronie nr. 11
Symbols Used In This Manual This symbol alerts operators to particularly important information. Be ATTENTION sure to read this information. This symbol alerts operators to helpful advice regarding operation. HINT A TRIANGLE symbol indicates that special care and attention is required. The drawing inside the triangle shows the specific caution. A CIRCLE with a diagonal line inside shows action which users may not perform. The drawing inside or under the circle shows the specific action that is
Streszczenie treści zawartej na stronie nr. 12
■Safety Precautions Do not damage the AC cable. A damaged AC cable may cause fire or electric shock. Do not place heavy objects on AC cables, or pull, bend, twist, heat, damage or modify AC cables. Do not use damaged AC cables or power plugs, or install any cables or power plugs to loose wall sockets. Use only specified AC cables and connector cables Use only specified AC cables and connector cables. Failure to use the correct cables might cause electric shock and/or equipment failure. Pleas
Streszczenie treści zawartej na stronie nr. 13
Turn the scanner OFF if it is damaged. If the scanner is damaged for any reason, disconnect immediately the power plug in order to turn out the scanner. Contact the store where you purchased the scanner. Do not put liquids inside the scanner. Do not insert or drop metal objects in to the scanner. Do not scan wet documents or documents with paper clips or staples. Do not splash or allow the scanner to get wet. If foreign objects (water, small metal objects, liquids, etc.) get inside the scanner
Streszczenie treści zawartej na stronie nr. 14
Do not install the scanner on unstable surfaces. Make sure that the scanner is installed on a flat, level surface and that none of its parts extend beyond the surface top, such as a desk or table. Do not install the scanner on unstable surfaces. Install the scanner on a level surface that is free of vibration to prevent it from falling. Install the scanner on a strong surface that will support the weight of the scanner and other devices. Do not block the ventilation ports. Do not block th
Streszczenie treści zawartej na stronie nr. 15
Before moving the scanner, disconnect the power plug from the power outlet. Do not move the scanner with the power and interface cables connected as this might damage the cables, causing fire, electric shock or injuries. Before moving the scanner, be sure to disconnect the power plug from the power outlet, and all other data cables. Make sure that the floor is free of any obstruction. Protect the scanner from static electricity. Install the scanner away from strong magnetic fields and other
Streszczenie treści zawartej na stronie nr. 16
xvi
Streszczenie treści zawartej na stronie nr. 17
Chapter 1 1 BASIC SCANNER OPERATIONS This chapter describes the basic operations of the scanner. In this chapter, Windows XP screenshots are used as examples. The screens and operations may differ slightly if the operating system (OS) you are using is not Windows XP. In addition, when FUJITSU TWAIN 32 is updated, the screens and operations provided in this chapter may be different from the actual ones. 1.1 Turning the Scanner ON................................................................
Streszczenie treści zawartej na stronie nr. 18
1.1 Turning the Scanner ON 1. Press the power button on the operator panel. The scanner is turned on, and the green LED on the operator panel illuminates. During the initialization, the indication of the Function Number Display changes as follows: 8 P 0 1 A number "1" indicated on the operator panel shows that the scanner is in the ready status. Power button To turn the scanner off, hold the power button down for at least two HINT seconds. ■ About Power ON/OFF Control You can select how to p
Streszczenie treści zawartej na stronie nr. 19
BASIC SCANNER OPERATIONS 1.1 Turning the Scanner ON 3) In the [Printers and Other Hardware] window, double click the [Scanners and Cameras] icon. 1 ⇒ The [Scanners and Cameras] window appears. 4) In Windows XP and Windows Server 2003, right-click on the [fi-5530C2dj] icon, and then select [Properties]. In Windows 2000 and Windows Vista, double-click on the [fi- 5530C2dj] icon. ⇒ The [fi-5530C2dj Properties] dialog box appears. 5) Select the [Device Set] tab. fi-5530C2 Image Scanner Operator’s
Streszczenie treści zawartej na stronie nr. 20
⇒ The dialog box shown below appears. 2. Click the [Power Control] button ⇒ The dialog box shown below appears. 3. In this dialog box, do the following: • To power on/off the scanner by pressing the Power button: ⇒ Select [Enable power switch]. • To power on/off the scanner by connecting/disconnecting the AC cable: ⇒ Select [Disable power switch]. 4
