Instrukcja obsługi Winegard RP-SK95

Streszczenie treści zawartej na stronie nr. 1

Automatic Multi-Satellite TV Antenna
Replacement Back-up and Feed Arm
Assembly with LNB and Coax Cable
Instruction Manual
for Model RP-SK95
For help, email help@winegard.com or call 1-800-788-4417
www.winegard.com/mobile
2452290

Streszczenie treści zawartej na stronie nr. 2

4 If there is not already a line marking the top of the stiffener plate, draw Raising the Antenna a line on the stiffener plate to mark the top of the plate. 1 Press and hold “POWER” for two seconds to turn on the interface box. Wait until the interface box finishes “connecting to antenna.” The 5 Using a ½ ″ wrench, loosen and remove the four bolts holding the ® TRAV’LER antenna may enter the search routine after ten seconds. reflector bracket and stiffener plate to the skew housing. At the

Streszczenie treści zawartej na stronie nr. 3

Installing the Replacement LNB Assembly 2 Position the reflector bracket (of the replacement LNB assembly) against the adapter plate. Make sure the fourth outer hole in the adapter plate is centered in the bottom slot of the reflector bracket. The third and fifth outer holes should be close to opposite edges of the bottom slot. 8 4 1 7 1 6 2 3 2 5 3 4 Bottom slot of the reflector bracket Stiffener plate 3 Place the stiffener plate inside the reflector bracket. Make sure the second and thir