Streszczenie treści zawartej na stronie nr. 1
TL-SG2008
8-Port Gigabit Smart Switch
REV1.0.0
1910010984
Streszczenie treści zawartej na stronie nr. 2
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2014 TP-LINK TECHNOLOGIES CO.,
Streszczenie treści zawartej na stronie nr. 3
Safety Information When product has power button, the power button is one of the way to shut off the product; When there is no power button, the only way to completely shut off power is to disconnect the product or the power adapter from the power source. Don’t disassemble the product, or make repairs yourself. You run the risk of electric shock and voiding the limited warranty. If you need service, please contact us. Avoid water and wet locations. This product can be used in
Streszczenie treści zawartej na stronie nr. 4
CONTENTS Package Contents ..........................................................................................................................1 Chapter 1 About this Guide...........................................................................................................2 1.1 Intended Readers .........................................................................................................2 1.2 Conventions..................................................................
Streszczenie treści zawartej na stronie nr. 5
5.1.1 Port Config.......................................................................................................28 5.1.2 Port Mirror........................................................................................................29 5.1.3 Port Security ....................................................................................................31 5.1.4 Port Isolation....................................................................................................32 5
Streszczenie treści zawartej na stronie nr. 6
8.1.1 Snooping Config ..............................................................................................79 8.1.2 Port Config.......................................................................................................80 8.1.3 VLAN Config ....................................................................................................81 8.1.4 Multicast VLAN ................................................................................................82 8.2 Multica
Streszczenie treści zawartej na stronie nr. 7
10.3.2 Port Binding ................................................................................................... 113 10.3.3 VLAN Binding................................................................................................. 113 10.4 Application Example for ACL .................................................................................... 114 Chapter 11 SNMP.................................................................................................................
Streszczenie treści zawartej na stronie nr. 8
Package Contents The following items should be found in your box: One TL-SG2008 8-Port Gigabit Smart Switch One power adapter Four rubber cushions Quick Installation Guide Resource CD for TL-SG2008 switch, including: • This User Guide • Other Helpful Information Note: Make sure that the package contains the above items. If any of the listed items are damaged or missing, please contact your distributor. 1
Streszczenie treści zawartej na stronie nr. 9
Chapter 1 About this Guide This User Guide contains information for setup and management of TL-SG2008 8-Port Gigabit Smart Switch. Please read this guide carefully before operation. 1.1 Intended Readers This Guide is intended for network managers familiar with IT concepts and network terminologies. 1.2 Conventions In this Guide the following conventions are used: The switch or TL-SG2008 mentioned in this Guide stands for TL-SG2008 8-Port Gigabit Smart Switch without any explanation.
Streszczenie treści zawartej na stronie nr. 10
Chapter Introduction Chapter 4 System This module is used to configure system properties of the switch. Here mainly introduces: System Info: Configure the description, system time and network parameters of the switch. User Management: Configure the user name and password for users to log on to the Web management page with a certain access level. System Tools: Manage the configuration file of the switch. Access Security: Provide different security measures for the login to enhance
Streszczenie treści zawartej na stronie nr. 11
Chapter Introduction Chapter 9 QoS This module is used to configure QoS function to provide different quality of service for various network applications and requirements. Here mainly introduces: DiffServ: Configure priorities, port priority, 802.1P priority and DSCP priority. Bandwidth Control: Configure rate limit feature to control the traffic rate on each port; configure storm control feature to filter broadcast, multicast and UL frame in the network. Voice VLAN: Configure voic
Streszczenie treści zawartej na stronie nr. 12
Chapter 2 Introduction Thanks for choosing the TL-SG2008 8-Port Gigabit Smart Switch! 2.1 Overview of the Switch Designed for workgroups and departments, TL-SG2008 from TP-LINK provides wire-speed performance and full set of layer 2 management features. It provides a variety of service features and multiple powerful functions with high security. The EIA-standardized framework and smart configuration capacity can provide flexible solutions for a variable scale of networks. QoS and IGMP
Streszczenie treści zawartej na stronie nr. 13
The following parts are located on the front panel of the switch: Reset: Press this button for five seconds or above to reset the software setting back to factory default setting. LEDs Name Status Indication On(Green) The switch is powered on. Power Flashing/Off The switch is powered off or power supply is abnormal. Flashing The switch is working normally. System On/Off The switch is working abnormally. A 1000Mbps device is connected to the corresponding port, but On no activity
Streszczenie treści zawartej na stronie nr. 14
Chapter 3 Login to the Switch 3.1 Login 1) To access the configuration utility, open a web-browser and type in the default address http://192.168.0.1 in the address field of the browser, then press the Enter key. Figure 3-1 Web-browser Tips: To log in to the switch, the IP address of your PC should be set in the same subnet addresses of the switch. The IP address is 192.168.0.x ("x" is any number from 2 to 254), Subnet Mask is 255.255.255.0. For the detailed instructions as to how
Streszczenie treści zawartej na stronie nr. 15
Figure 3-3 Main Setup-Menu Note: Clicking Apply can only make the new configurations effective before the switch is rebooted. If you want to keep the configurations effective even the switch is rebooted, please click Save Config. You are suggested to click Save Config before cutting off the power or rebooting the switch to avoid losing the new configurations. Return to CONTENTS 8
Streszczenie treści zawartej na stronie nr. 16
Chapter 4 System The System module is mainly for system configuration of the switch, including four submenus: System Info, User Management, System Tools and Access Security. 4.1 System Info The System Info, mainly for basic properties configuration, can be implemented on System Summary, Device Description, System Time, Daylight Saving Time and System IP pages. 4.1.1 System Summary On this page you can view the port connection status and the system information. The port status diagram s
Streszczenie treści zawartej na stronie nr. 17
Figure 4-2 Port Information Port Info Port: Displays the port number of the switch. Type: Displays the type of the port. Rate: Displays the maximum transmission rate of the port. Status: Displays the connection status of the port. Click a port to display the bandwidth utilization on this port. The actual rate divided by theoretical maximum rate is the bandwidth utilization. The following figure displays the bandwidth utilization monitored every four seconds. Monitoring the bandwidth
Streszczenie treści zawartej na stronie nr. 18
Figure 4-4 Device Description The following entries are displayed on this screen: Device Description Device Name: Enter the name of the switch. Device Location: Enter the location of the switch. System Contact: Enter your contact information. 4.1.3 System Time System Time is the time displayed while the switch is running. On this page you can configure the system time and the settings here will be used for other time-based functions. You can manually set the system time or synchron
Streszczenie treści zawartej na stronie nr. 19
Time Config Manual: When this option is selected, you can set the date and time manually. Get Time from NTP When this option is selected, you can configure the time zone Server: and the IP Address for the NTP Server. The switch will get UTC automatically if it has connected to an NTP Server. Time Zone: Select your local time. Primary/Secondary NTP Server: Enter the IP Address for the NTP Server. Update Rate: Specify the rate fetching time from NTP server. Synchronize with When thi
Streszczenie treści zawartej na stronie nr. 20
Predefined Mode: Select a predefined DST configuration. USA: Second Sunday in March, 02:00 ~ First Sunday in November, 02:00. Australia: First Sunday in October, 02:00 ~ First Sunday in April, 03:00. Europe: Last Sunday in March, 01:00 ~ Last Sunday in October, 01:00. New Zealand: Last Sunday in September, 02:00 ~ First Sunday in April, 03:00. Recurring Mode: Specify the DST configuration in recurring mode. This configuration is recurring in use. Offset: Specify the time adding
