Streszczenie treści zawartej na stronie nr. 1
DATA PROJECTOR
MODEL
XG-P560W
XG-P560W-N
SETUP MANUAL
Setting up the Screen.......................................... 2 Default Gateway Setting ([3]Default Gateway) .... 36
User Name Setting ([4]User Name) ..................... 36
Screen Size and Projection Distance ................ 3
Password Setting ([5]Password) .......................... 37
Connecting Pin Assignments .......................... 11
RS-232C Baud Rate Setting
Wired Remote Control Terminal Specifications ......13
([6]RS-232C Baud
Streszczenie treści zawartej na stronie nr. 2
Setting up the Screen For optimal image quality, position the projector perpendicular to the screen with the projector’s feet flat and level. Doing so will eliminate the need for Keystone correction and provide the best image quality. Note • The projector lens should be centered in the middle of the screen. If the horizontal line passing through the lens center is not perpendicular to the screen, the image will be distorted, making viewing difficult. • For an optimal image, position the screen s
Streszczenie treści zawartej na stronie nr. 3
Screen Size and Projection Distance The projection screen size varies according to the distance from the lens of the projector to the screen. The optional lenses from Sharp are also available for specialized application. Please see your nearest Sharp Authorized Projector Dealer to details on all the lenses. (Refer to the lens operation manual when using a lens.) Install the projector so that projected images are projected onto the screen at the optimum size by referring to the table. Use the val
Streszczenie treści zawartej na stronie nr. 4
Screen Size and Projection Distance Standard Zoom Lens (AN-P18EZ : Standard Equipment with XG-P560W) F2.5, f=25.5-32 mm 16:10 Signal Input (Normal Mode) Distance from the lens center to Distance from the lens Picture (Screen) size Projection distance [L] the bottom of the image [H] center to the center of χ the image [W] Diag. [ ] Width Height Minimum [L1] Maximum [L2] Lower [H1] Upper [H2] 55 31 3 280'' (711 cm) 603 cm (237'') 377 cm (148'') 11.0 m (36' 0") 13.7 m (45' 1") –439.1 cm (–172 /64")
Streszczenie treści zawartej na stronie nr. 5
Screen Size and Projection Distance Fixed Wide Lens (AN-P8EX) F2.5, f=11.6 mm 16:10 Signal Input (Normal Mode) Distance from the lens center to Distance from the lens Picture (Screen) size Projection distance the bottom of the image [H] center to the center of χ Diag. [ ] Width Height [L] Lower [H1] Upper [H2] the image [W] 27 25 1 140'' (356 cm) 302 cm (119'') 188 cm (74'') 2.4 m (8' 0") –135.7 cm (–53 /64") –52.8 cm (–20 /32") ±33.2cm (13 /16") 25 13 3 120'' (305 cm) 258 cm (102'') 162 cm (64'
Streszczenie treści zawartej na stronie nr. 6
Screen Size and Projection Distance Fixed Wide Lens (AN-P12EX) F2.5, f=17.1 mm 16:10 Signal Input (Normal Mode) Distance from the lens center to Distance from the lens Picture (Screen) size Projection distance the bottom of the image [H] center to the center of χ Diag. [ ] Width Height [L] Lower [H1] Upper [H2] the image [W] 49 1 29 230'' (584 cm) 495 cm (195'') 310 cm (122'') 6.0 m (19' 9") –222.9 cm (–87 /64") –86.7 cm (–34 /8") ±54.5cm (21 /64") 5 43 21 200'' (508 cm) 431 cm (170'') 269 cm (1
Streszczenie treści zawartej na stronie nr. 7
Screen Size and Projection Distance Wide-zoom Lens (AN-P15EZ) F2.5, f=21.2-25.8 mm 16:10 Signal Input (Normal Mode) Distance from the lens center to Distance from the lens Picture (Screen) size Projection distance [L] the bottom of the image [H] center to the center of χ the image [W] Diag. [ ] Width Height Minimum [L1] Maximum [L2] Lower [H1] Upper [H2] 7 1 230'' (584 cm) 495 cm (195'') 310 cm (122'') 7.5 m (24' 8") 9.0 m (29' 7") –360.7 cm (–142") 51.1 cm (20 /64") ±173.4cm (68 /4") 15 31 23 2
Streszczenie treści zawartej na stronie nr. 8
Screen Size and Projection Distance Tele-zoom Lens (AN-P23EZ) F2.5, f=31.9-42.5 mm 16:10 Signal Input (Normal Mode) Distance from the lens center to Distance from the lens Picture (Screen) size Projection distance [L] the bottom of the image [H] center to the center of χ the image [W] Diag. [ ] Width Height Minimum [L1] Maximum [L2] Lower [H1] Upper [H2] 7 1 230'' (584 cm) 495 cm (195'') 310 cm (122'') 11.3 m (37' 1") 15.1 m (49' 5") –360.7 cm (–142") 51.1 cm (20 /64") ±173.4cm (68 /4") 15 31 23
Streszczenie treści zawartej na stronie nr. 9
Screen Size and Projection Distance Tele-zoom Lens (AN-P30EZ) F2.5, f=40.8-62.8 mm 16:10 Signal Input (Normal Mode) Distance from the lens center to Distance from the lens Picture (Screen) size Projection distance [L] the bottom of the image [H] center to the center of χ the image [W] Diag. [ ] Width Height Minimum [L1] Maximum [L2] Lower [H1] Upper [H2] 7 1 230'' (584 cm) 495 cm (195'') 310 cm (122'') 15.1 m (49' 5") 22.6 m (74' 1") –360.7 cm (–142") 51.1 cm (20 /64") ±173.4cm (68 /4") 15 31 23
Streszczenie treści zawartej na stronie nr. 10
Screen Size and Projection Distance Tele-zoom Lens (AN-P45EZ) F2.5, f=62.1-97.8 mm 16:10 Signal Input (Normal Mode) Distance from the lens center to Distance from the lens Picture (Screen) size Projection distance [L] the bottom of the image [H] center to the center of χ the image [W] Diag. [ ] Width Height Minimum [L1] Maximum [L2] Lower [H1] Upper [H2] 7 1 230'' (584 cm) 495 cm (195'') 310 cm (122'') 22.6 m (74' 1") 35.1 m (115' 3") –360.7 cm (–142") 51.1 cm (20 /64") ±173.4cm (68 /4") 15 31 2
Streszczenie treści zawartej na stronie nr. 11
Connecting Pin Assignments COMPUTER/COMPONENT input and COMPUTER/COMPONENT output Terminals: mini D-sub 15 pin female connector RGB Input Component Input 1. Video input (red) 1. PR (CR) 10 6 2. Video input (green/sync on green) 2. Y 5 1 3. Video input (blue) 3. PB (CB) 4. Not connected 4. Not connected 5. Not connected 5. Not connected 6. Earth (red) 6. Earth (PR) 7. Earth (green/sync on green) 7. Earth (Y) 8. Earth (blue) 8. Earth (PB) 9. Not connected 9. Not connected 10. GND 10. Not connected
Streszczenie treści zawartej na stronie nr. 12
Connecting Pin Assignments RS-232C Terminal: D-sub 9 pin male connector Pin No. Signal Name I/O Reference 1 Not connected 1 5 2RD Receive Data Input Connected to internal circuit 3SD Send Data Output Connected to internal circuit 4 Not connected 5SG Signal Ground Connected to internal circuit 6 Not connected 7RS Request to Send Connected to CS in internal circuit 8CS Clear to Send Connected to RS in internal circuit 9 Not connected 6 9 RS-232C Cable recommended connection: D-sub 9-pin female con
Streszczenie treści zawartej na stronie nr. 13
Wired Remote Control Terminal Specifications Specifications of wired remote control input • • • • • ø3.5 mm minijack • • • • • External: GND • • • • • Internal: +3.3V Function and transmission codes JUDGEMENT JUDGEMENT SYSTEM CODE DATA CODE SYSTEM CODE DATA CODE CODE CODE CONTROL CONTROL ITEM ITEM C1 C2 C3 C4 C5 C6 C7 C8 C9 C10 C11 C12 C13 C14 C15 C1 C2 C3 C4 C5 C6 C7 C8 C9 C10 C11 C12 C13 C14 C15 STANDBY 1 0 1 1 0 0 1 1 0 1 0 0 1 1 0 FREEZE 1 0 1 1 0 1 0 1 1 0 0 0 1 1 0 ON 1 0 1 1 0 0 1 1 0 1 0
Streszczenie treści zawartej na stronie nr. 14
RS-232C Specifications and Commands Computer control A computer can be used to control the projector by connecting an RS-232C serial control cable (cross type, commercially available) to the projector. (See page 27 of the projector’s operation manual for connection.) Communication conditions Set the serial port settings of the computer to match that of the table. Signal format: Conforms to RS-232C standard. Parity bit: None Baud rate*: 9,600 bps / 38,400 bps / 115,200 bps Stop bit: 1 bit Data le
Streszczenie treści zawartej na stronie nr. 15
RS-232C Specifications and Commands Commands Example: When turning on the projector, make the following setting. Computer Projector → PO W R __ _ 1 OK ← RETURN CONTROL CONTENTS COMMAND PARAMETER Standby mode Power ON (or 40-second startup time) Power On _ _ _ OK OK or ERR P O W R 1 _ _ _ Off P O W R 0 OK or ERR OK Status 1 0 P O W R ? ? ? ? Projector Condition _ _ _ T A B N 1 0: Normal, 1: Temp High 0: Normal, 1: Temp High 8: Lamp Life 5% or less 2: Fan Error, 4: Cover Open 16: Lamp Burn-out 8:
Streszczenie treści zawartej na stronie nr. 16
RS-232C Specifications and Commands RETURN CONTROL CONTENTS COMMAND Standby mode PARAMETER Power ON (or 40-second startup time) _ _ _ Resize COMPUTER2 Normal R B S R 1 OK or ERR ERR _ _ _ Stretch R B S R 2 OK or ERR ERR _ _ _ Dot By Dot R B S R 3 OK or ERR ERR _ _ _ Smart Stretch R B S R 4 OK or ERR ERR _ _ _ Full R B S R 5 OK or ERR ERR _ _ Area Zoom R B S R 1 0 OK or ERR ERR _ _ V-Stretch R B S R 1 1 OK or ERR ERR _ _ _ DVI Normal R C S R 1 OK or ERR ERR _ _ _ Stretch R C S R 2 OK or ERR ERR _
Streszczenie treści zawartej na stronie nr. 17
RS-232C Specifications and Commands RETURN CONTROL CONTENTS COMMAND Standby mode PARAMETER Power ON (or 40-second startup time) DVI input Picture Mode Standard _ _ R C P S 1 0 OK or ERR ERR _ _ Presentation R C P S 1 1 OK or ERR ERR Movie _ _ R C P S 1 2 OK or ERR ERR _ _ Custom R C P S 1 3 OK or ERR ERR Contrast -30 – +30 _ R C P I * * * OK or ERR ERR _ Bright -30 – +30 R C B R * * * OK or ERR ERR Color -30 – +30 _ R C C O * * * OK or ERR ERR _ Tint -30 – +30 R C T I * * * OK or ERR ERR Red -30
Streszczenie treści zawartej na stronie nr. 18
RS-232C Specifications and Commands RETURN CONTROL CONTENTS COMMAND Standby mode PARAMETER Power ON (or 40-second startup time) _ _ S-VIDEO input Picture Mode Standard V B P S 1 0 OK or ERR ERR _ _ Presentation V B P S 1 1 OK or ERR ERR _ _ Movie V B P S 1 2 OK or ERR ERR _ _ Custom V B P S 1 3 OK or ERR ERR _ Contrast -30 – +30 V B P I * * * OK or ERR ERR _ Bright -30 – +30 V B B R * * * OK or ERR ERR _ Color -30 – +30 V B C O * * * OK or ERR ERR _ Tint -30 – +30 V B T I * * * OK or ERR ERR _ R
Streszczenie treści zawartej na stronie nr. 19
RS-232C Specifications and Commands RETURN CONTROL CONTENTS Standby mode COMMAND PARAMETER Power ON (or 40-second startup time) Digital Shift -40 – +40 _ OK or ERR ERR L N D S * * * _ _ _ OK or ERR ERR OSD Display Normal I M D I 1 Level A _ _ _ OK or ERR ERR I M D I 2 _ _ _ OK or ERR ERR Level B I M D I 0 Video System Auto _ _ _ OK or ERR ERR M E S Y 1 _ _ _ OK or ERR ERR Selection PAL M E S Y 2 SECAM _ _ _ OK or ERR ERR M E S Y 3 _ _ _ OK or ERR ERR NTSC 4.43 M E S Y 4 NTSC 3.58 _ _ _ OK or ERR
Streszczenie treści zawartej na stronie nr. 20
Setting up the Projector Network Environment This section describes the basic procedure for using the projector via the network. If the network is already constructed, the projector’s network settings may need to be changed. Please consult your network administrator for assistance with these settings. You can make network settings both on the projector and on the computer. The following procedure is for making settings on the computer. Network settings on the computer 1. Connecting the projector
