Streszczenie treści zawartej na stronie nr. 1
Kameleon
HDP6000
1080p DLP™ Projector
Users‟ Manual v1.1
Streszczenie treści zawartej na stronie nr. 2
2 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no gua
Streszczenie treści zawartej na stronie nr. 3
3 TABLE OF CONTENTS Safety Warnings 4 Introduction 5 Positioning the projector 8 Choosing the aspect ratio 9 Video connectors 10 Connecting a video device 10 Composite (RCA) video connection 10 S-video connection 10 Component (RCA) connection 10 SCART RGB connection 10 Digital connections 10 DVI connection 10 HDMI connection 10 Computer connections 11 RS-232 connections 11 Displaying an im
Streszczenie treści zawartej na stronie nr. 4
4 Important Operating Considerations for Safety Refer to this guide for proper startup and shutdown procedures. • Follow all warnings and cautions in this manual and on the projector. • Place the projector in a horizontal position no greater than 8 degrees off axis. • Locate the projector at least 4' (1.2m) away from any heating or cooling vents. • Do not block ventilation openings. Locate the projector in a well ventilated area without obstructions to intake or exhaust vents. Do not pl
Streszczenie treści zawartej na stronie nr. 5
5 Unplug this projector from the wall outlet and refer servicing to qualified service personnel under the following conditions: • When the power cord or plug is damaged or frayed • If liquid has been spilled into the projector • If the projector has been exposed to rain or water • If the projector does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as improper adjustment of other controls may resu
Streszczenie treści zawartej na stronie nr. 6
6 Power RS232 S-Video HDMI VGA Rear Connector Panel USB 12 VDC triggers Composite video Component video Wired remote The projector provides the following connection options: • VGA computer. • Two HDMI™ (High Definition Multimedia Interface) • Three Component Video (RCA) • S-video • Composite video (R
Streszczenie treści zawartej na stronie nr. 7
7 Setting up the Projector There are a number of factors to consider when determining where to set up the projector, including the size and shape of your screen, the location of your power outlets, and the distance between the projector and the rest of your equipment. But here are some general guidelines. NOTE: To ensure adequate cable access, do not place the projector within 6 inches (0.15 m) of a wall or other object. Position the projector on a flat surface
Streszczenie treści zawartej na stronie nr. 8
8 Projector Positioning The projected image becomes larger as the distance between the unit and screen increases. The manual zoom allows the distance from the screen to be within a minimum and maximum range. See the chart on the next page for details. The example below defines the screen height, width, diagonal, etc. HDP6000 Projection Throw Distance 16:9 Video Screen: Screen Diagonal 92" 103" 106" 110" 122.5" 146.75" Minimum Distance 121" 135"
Streszczenie treści zawartej na stronie nr. 9
9 Choosing the aspect ratio Aspect ratio is the ratio of the image width to image height. HDTV and most DVDs are 16:9, which is the default for this projector. When in 4:3 mode the projector places black bars on both sides of the image. Native mode centers the image and turns off the internal scaler so that any resolution larger than the native projector resolution is cropped on the edges. Letterbox expands the image to fill the screen. What you plan to project will also help
Streszczenie treści zawartej na stronie nr. 10
10 Connecting a video device You can connect video devices such as VCRs, DVD players, camcorders, digital cameras, video game consoles, HDTV receivers, and TV tuners to the projector. Connect the audio from your video device to your stereo system to get sound. You can connect the projector to most video devices that can output video. You cannot directly connect the coaxial cable that enters your house from a cable or satellite company; the signal must pass through a tuner first. Example
Streszczenie treści zawartej na stronie nr. 11
11 Computer connections You can connect a computer‟s VGA connector to the VGA input on the projector using a VGA cable. RS-232 connections You can control the projector from an LCD control panel or computer by connecting an RS-232 cable to the projector‟s Serial control connector. Displaying an image Connect the power cord to the Power connector cord plug in power on the back of the projector and to your electrical outlet. NOTE: Always use the power cord t
Streszczenie treści zawartej na stronie nr. 12
12 Adjust the focus and zoom. If the image is square but not centered adjust focus adjust it using the lens shift dials. adjust zoom horizontal lens shift vertical lens shift Rotate the elevator feet if needed for granular adjustment of the projector‟s height. Avoid placing your hands near the hot exhaus
Streszczenie treści zawartej na stronie nr. 13
13 Troubleshooting your setup If your image appears correctly on the screen, skip to the next section. If it does not, troubleshoot the setup. The LED on top of the projector indicates the state of the projector and can help you troubleshoot. The status indicator on the top of the projector can help you diagnose any problems the projector is experiencing.
Streszczenie treści zawartej na stronie nr. 14
14 The following tables show common problems. In some cases, more than one possible solution is provided. Try the solutions in the order they are presented. When the problem is solved, you can skip the additional solutions. Problem Solution Result Plug in power and press the power button. Correct_image No startup screen Computer image Only start up screen appears projected Press the start button and activate the laptops external port. Restart laptop No computer image
Streszczenie treści zawartej na stronie nr. 15
15
Streszczenie treści zawartej na stronie nr. 16
16
Streszczenie treści zawartej na stronie nr. 17
17 Still need assistance? If you need assistance, visit our website at www.knollsystems.com, or call us at 1 800 566 5579. during Pacific west coast time. This product is backed by a limited warranty. An extended warranty plan may be purchased from your retailer or dealer. When sending the projector in for repair, we recommend shipping the unit in its original packing material, or having a professional packaging company pack the unit. Please insure your shipment for its
Streszczenie treści zawartej na stronie nr. 18
18 Using the keypad buttons Most buttons are described in detail in other sections, but here is an overview of their functions: Power–turns the projector on and off (page 12). Auto Image–resynchronize the projector to the source. Presets–cycles through the available preset settings. Menu–opens the onscreen menus. Select–confirms choices made in the menus. Up/Down/Left/Right arrows–navigates to and adjusts settings in the menus. Source–changes the active source. Help–but
Streszczenie treści zawartej na stronie nr. 19
19 Optimizing video images Your projector has been factory optimized for very good performance no matter what the source. However, if you wish to make further changes you can optimize the image using onscreen menus. • Adjust the Keystone, Contrast, Brightness, Color, or Tint in the Picture menu. • Select a Sharpness setting. • Use the Color Control to adjust the color gain and offset. • Adjust the Color Temperature. Select a listed value. • Turn on Overscan to remove noise on the
Streszczenie treści zawartej na stronie nr. 20
20 The menus are grouped by usage: • The Basic Picture menu provides common image adjustments. • The Advanced Picture menu provides more complex image adjustments. • The Setup menu provides set-up type adjustments that are not changed often. • The Status and Service menu provides information about the projector and source. Basic Picture menu To adjust the following settings, highlight the setting, press select, use the arrow buttons to adjust the values, then press Se
