Streszczenie treści zawartej na stronie nr. 1
PROJECTOR
User’s Manual
HDP2100 High Definition Projector
Streszczenie treści zawartej na stronie nr. 2
Copyright This publication, including all photographs, illustrations and software, is protected under international copy- right laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. © Copyright 2010 Disclaimer The information in this document is subject to change without notice. The manufacturer makes no repre- sentations or warranties with respect to the contents hereof and specifically discla
Streszczenie treści zawartej na stronie nr. 3
HDP2100 Users Manual Important Safety Information Important: It is strongly recommended that you read this section carefully before using the projector. These safety and usage instructions will ensure that you enjoy many years of safe use of the projector. Keep this manual for future reference. Symbols Used Warning symbols are used on the unit and in this manual to alert you of hazardous situations. The following styles are used in this manual to alert you to important information. No
Streszczenie treści zawartej na stronie nr. 4
Preface Projector Installation Notice Place the projector in a horizontal position The tilt angle of the projector should not exceed 15 degrees, nor should the projector be installed in any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically. Allow at least 50 cm clearance around the exhaust vent. Ensure that the intake vents do not recycle hot air from the exhaust vent. When operating the projector in an enclosed space,
Streszczenie treści zawartej na stronie nr. 5
HDP2100 Users Manual Replacing the Lamp Replacing the lamp can be hazardous if done incorrectly. See Replacing the Projection Lamp on page 30 for clear and safe instructions for this procedure. Before replacing the lamp: Unplug the power cord. Allow the lamp to cool for about one hour. Cleaning the Projector Unplug the power cord before cleaning. See Cleaning the Projector on page 32. Allow the lamp to cool for about one hour. Regulatory Warnings Before installing and using the proj
Streszczenie treści zawartej na stronie nr. 6
Preface Table of Contents GETTING STARTED .......................................................................................................................................................... 1 PACKING CHECKLIST........................................................................................................................................................... 1 VIEWS OF PROJECTOR PARTS.............................................................................................
Streszczenie treści zawartej na stronie nr. 7
HDP2100 Users Manual PROJECTION DISTANCE VS. PROJECTION SIZE ................................................................................................................... 39 HDP2100 Series Projection Distance and Size Table .................................................................................................. 39 HDP2100 SERIES TIMING MODE TABLE ...........................................................................................................................40 PR
Streszczenie treści zawartej na stronie nr. 8
HDP2100 Users Manual GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included: HDP2100 SERIES DLP PROJECTOR REMOTE CONTROL VGA CABLE COMPONENT CABLE POWER CORD (WITH TWO AA BATTERIES) HDMI CABLE CARRYING CASE CD-ROM WARRANTY CARD (THIS USER’S MANUAL) Contact your dealer immediately if any items are missing, appear damaged, or if the unit does not work. It is recommend that you keep the original pack
Streszczenie treści zawartej na stronie nr. 9
HDP2100 Users Manual r Views of Projector Parts HDP2100 Series Front-right View ITEM LABEL DESCRIPTION SEE PAGE: Height-adjuster button Push to release height adjuster 1. 13 2. Height adjuster Adjusts level of projector Lens Projection Lens 3. IR receiver Receive IR signal from remote control 4. 6 Focus ring Focuses the projected image 5. 14 Zoom ring Enlarges the projected image 6. See Top view—On-screen Display (OSD) buttons Function keys 7. 3 and LEDs. Importan
Streszczenie treści zawartej na stronie nr. 10
HDP2100 Users Manual r Top view—On-screen Display (OSD) buttons and LEDs SEE ITEM LABEL DESCRIPTION PAGE: Turns the projector On or Off. 1. 11 (Power button) BLANK Displays a blank screen and mutes audio 2. ◄ (Left cursor) / Navigates and changes settings in the OSD 3. Volume- Quick Menu – For Volume Enter Enter or confirm highlighted OSD menu item 4. 16 MENU Opens and exits OSD menus 5. ▲ (Up cursor) / Navigates and changes settings in the OSD 6. Keystone+ Quick
Streszczenie treści zawartej na stronie nr. 11
HDP2100 Users Manual Rear view ITEM LABEL DESCRIPTION SEE PAGE: 1. AC IN Connect the POWER CABLE 11 (USB) Connect the USB CABLE from a computer 2. COMPONENT IN Connect a component video enabled device 3. S-VIDEO IN Connect the S-VIDEO CABLE from a video device 4. VIDEO IN Connect the COMPOSITE CABLE from a video device 5. 10 Connect the RGB CABLE from a computer and VGA IN 6. components HDMI – 1 Connect the HDMI CABLE from a HDMI device 7. 8. HDMI – 2 Connect
Streszczenie treści zawartej na stronie nr. 12
HDP2100 Users Manual Bottom view ITEM LABEL DESCRIPTION SEE PAGE: Tilt adjustor Rotate adjuster lever to adjust angle position. 1. 13 Ceiling support holes Contact your dealer for information on mounting the projector on a ceiling 2. 3. Height adjustor Adjuster drops down when adjuster button is pushed. 13 Height adjustor button Push to release adjustor. 4. Note: When installing, ensure that you use only UL Listed ceiling mounts. For ceiling installations, use approved
Streszczenie treści zawartej na stronie nr. 13
HDP2100 Users Manual Remote Control Parts Important: 1. Avoid using the projector with bright fluorescent lighting turned on. Certain high-frequency fluo- rescent lights can disrupt remote control operation. 2. Be sure nothing obstructs the path between the remote control and the projector. If the path be- tween the remote control and the projector is obstructed, you can bounce the signal off certain reflective surfaces such as projector screens. 3. The buttons and keys on the project
Streszczenie treści zawartej na stronie nr. 14
HDP2100 Users Manual ITEM LABEL DESCRIPTION SEE PAGE: 1. Power OFF Turns the projector off 11 HDMI 2 Displays the HDMI 2 source selection 2. S-VIDEO Displays the S-VIDEO source selection 3. VIDEO Displays the VIDEO source selection 4. Up cursor / Navigates and changes settings in the OSD 5. Keystone+ Quick Menu – For Keystone ENTER Enters and confirms settings in the OSD 6. 16 Right cursor 7. Navigates and changes settings in the OSD 8. Down cursor ASPECT RATIO Di
Streszczenie treści zawartej na stronie nr. 15
Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necessary to point the remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the rear of the projector, the remote will function well within a radius of about 7 meters (23 feet) and 15 degrees above or below the projector level. If the projector does not respond to the remote control, move a little closer. Projector and Remote
Streszczenie treści zawartej na stronie nr. 16
SETUP AND OPERATION Inserting the Remote Control Batteries Remove the battery compartment cover 1. by sliding the cover in the direction of the arrow. Insert the battery with the positive side 2. facing up. Replace the cover. 3. Caution: 1. Only use AA batteries (Alkaline batteries are recommended). 2. Dispose of used batteries according to local ordinance regulations. 3. Remove the batteries when not using the projector for prolonged periods. — 9 —
Streszczenie treści zawartej na stronie nr. 17
HDP2100 Users Manual HDP2100 Users Manual Connecting Input Devices A PC or notebook computer and video devices can be connected to the projector at the same time. Video devices include DVD, VCD, and VHS players, as well as movie camcorders and digital still cameras. Check the user manual of the connecting device to confirm it has the appropriate output connector. ITEM LABEL DESCRIPTION (USB) Connect the USB cable from a computer COMPONENT IN Connect a component video enabled devi
Streszczenie treści zawartej na stronie nr. 18
DLP Projector – User’s Manual DLP Projector – User’s Manual DLP Projector – User’s Manual Starting and Shutting down the Projector Connect the power cord to the projector. 1. Connect the other end to a wall outlet. The POWER LED will be on. Turn on the connected devices. 2. 3. Ensure the POWER LED displays a solid blue and not a flashing blue. Then press the POWER button to turn on the projector. The projector splash screen displays and connected devices are detected.
Streszczenie treści zawartej na stronie nr. 19
HDP2100 Users Manual When the POWER OFF window ap- 5. pears, press on the control panel or on the remote control. The projec- tor turns off. Caution: Do not unplug the power cord until the READY LED stops flashing–indicating the projector has cooled down. – 12 –
Streszczenie treści zawartej na stronie nr. 20
HDP2100 Users Manual Adjusting the Projector Level Take note of the following when setting up the projector: • The projector table or stand should be level and sturdy. • Position the projector so that it is perpendicular to the screen. • Remove the Back Foot Holder on the rear adjuster foot before adjusting the projection angle. • Ensure the cables are in a safe location. You could trip over them. To raise the level of the projector, lift the projector [A] and press the height-adju
