Streszczenie treści zawartej na stronie nr. 1
IN2112, IN2114, IN2116
Regulatory models: V2000, M2100
010-0735-00
Streszczenie treści zawartej na stronie nr. 2
radiate radio frequency energy and, if not installed and used in accordance Declaration of Conformity with the instructions, may cause harmful interference to radio communica- Manufacturer: InFocus Corporation, 27500 SW Parkway Ave. Wilsonville, tions. However, there is no guarantee that interference will not occur in a Oregon 97070 USA particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the We decla
Streszczenie treści zawartej na stronie nr. 3
Table of Contents Introduction 4 Positioning the projector 6 Ceiling Mount 7 Connecting power 8 Connecting a computer source 8 Optional computer connections 9 Displaying an image 10 Adjusting the image 11 Connecting a video device 12 Video device connections 12 Shutting down the projector 14 Troubleshooting your setup 14 Using the remote control 22 Using the audio 23 Using the keypad buttons 24 Optimizing computer images 24 Presentation features 24 Optimizing video images 25 Customizing the proj
Streszczenie treści zawartej na stronie nr. 4
2’ / 0.6 m 8’/2.4 m • When the projector is ceiling mounted, wear protective eyewear to Important Operating Considerations for Safety prevent eye injury before opening lamp door. • Refer to this guide for proper startup and shutdown procedures. • Refer all service to qualified service personnel. Servicing your own • Follow all warnings and cautions in this manual and on the projector. projector can be dangerous to you and will void the warranty. • Place the projector in a horizontal position n
Streszczenie treści zawartej na stronie nr. 5
Introduction Top rear cover LiteTouch keypad Your new digital projector is simple to connect, easy to use, and Top front cover / straightforward to maintain. It is a versatile projector that is flexible enough Lamp access panel for business presentations and home video viewing, too. The IN2112 has native SVGA 800 x 600 resolution, the IN2114 has native XGA 1024x768 resolution, and the IN2116 has WXGA 1280x800 resolution. This guide applies to both products. They are compatible with a wide
Streszczenie treści zawartej na stronie nr. 6
Connector panel The projector provides both computer and video connection options, including: RS-232 5V DC •VGA computer (2) VGA Monitor out output •S-video •Composite video Audio in S-video • Separate audio inputs for video and computer IR Sensor The projector also provides the following connectors: • Monitor out, to provide an image on your desktop computer as well as on the projection screen. • Audio out, to provide sound for external speakers. • 5 volt DC output • RS-232 connector for ser
Streszczenie treści zawartej na stronie nr. 7
Positioning the projector Table 1: IN2112 (SVGA) and IN2114 (XGA) To determine where to position the projector, consider the size and shape of Range of distance to the screen for a given screen size your screen, the location of your power outlets, and the distance between the projector and the rest of your equipment. Here are some general guidelines: Distance to screen Diagonal Screen Minimum distance Maximum Distance • Position the projector on a flat surface at a right angle to the screen.
Streszczenie treści zawartej na stronie nr. 8
Ceiling Mount If you wish to install the projector on the ceiling: • We strongly recommend using InFocus approved ceiling mounts for proper fitting, ventilation and installation. Refer to the installation guide that comes with the InFocus Ceiling Mount Kit (p/n SP-CEIL- UNIV) for more information. The warranty does not cover any dam- age caused by use of non-approved ceiling mount kits or by installing in an improper location. • The ceiling must be strong enough to support the projector and
Streszczenie treści zawartej na stronie nr. 9
Connecting power Connect power cord Connect the black power cord to the Power connector on the rear of the projector and to your electrical outlet. The Power light on the Status Indicator Panel (page 14) turns amber. NOTE: Always use the power cord that shipped with the projector. Connecting a computer source VGA connection Connect one end of the provided computer cable to the VGA 1 or VGA 2 connector on the projector and the other to the VGA connector on your Connect computer cable computer
Streszczenie treści zawartej na stronie nr. 10
Optional computer connections To get sound from the projector, connect an audio cable (optional cable, not Connect audio cable included) to your computer and to the Audio 1 or Audio 2 connector on the projector. (Default settings are as follows: Audio 1 is used with VGA 1 and VGA 2; Audio 2 is used with S-video and composite.) You can also assign a your source to a different audio in connector, see page 23 and page 30. You may also need an adapter. If you are using a desktop computer and wa
Streszczenie treści zawartej na stronie nr. 11
Displaying an image Press Power button Touch the Power button on the keypad or the remote. The Power button blinks green and the fans start to run. When the lamp turns on, the start up screen will display and the Power button will become solid green. It can take a minute for the image to achieve full brightness. No start up screen? Get help on page 15. Turn on computer or Slide the lens cover to the side, if it is covering the lens. video device Turn on your computer or video device. The imag
Streszczenie treści zawartej na stronie nr. 12
Adjusting the image Adjust height If necessary, adjust the height of the projector by pressing the elevator foot release button to extend the foot. Rotate the elevator feet for granular adjustment of the projector’s height. Avoid placing your hands near the hot exhaust vent at the side of the projector. Avoid placing your hands near the hot exhaust vent at the side of the Adjust distance projector. Position the projector to the desired distance from the screen at a 90 degree angle to the s
Streszczenie treści zawartej na stronie nr. 13
S-video connection Connecting a video device If your video device uses a round, four-prong S-video connector, plug an S- You can connect video devices such as VCRs, DVD players, camcorders, video cable into the S-video connector on your video device and into the S- digital cameras, video game consoles, HDTV receivers, and TV tuners to the video connector on the projector. Use the audio cable as described above. projector. You can connect the audio directly to the projector to get sound Keep i
Streszczenie treści zawartej na stronie nr. 14
What is Aspect Ratio? 4:3 screen 16:9 screen Aspect ratio is the ratio of the image width to image height. Standard TV screens and older laptops are 4:3; HDTV and most DVDs are 16:9; and widescreen computers are 16:10. If you are projecting onto a screen, the size/shape of the screen will influence the aspect ratio you decide to use. If 4:3 you are projecting onto a blank wall, there are no screen size restrictions. mode What you plan to project will also help you choose between 4:3, 16:9
Streszczenie treści zawartej na stronie nr. 15
Shutting down the projector Troubleshooting your setup The Status Indicator Panel on top of the projector indicates the state of the Screen Save Time projector and is a helpful when troubleshooting. You can make the black screen appear after a preset number of minutes by turning on the Screen Save Time feature in the Setup menu. See page 29. Auto Off Time The projector has an Auto Off Time feature that automatically turns the Table 3: Status indicator light behavior and meaning projector off
Streszczenie treści zawartej na stronie nr. 16
A A Problem Solution Result No start up screen Correct image Plug power cord into the projector then press power button Computer image projected Only start up screen appears Press the Source button Activate the laptop’s external port Restart laptop 15 Startup Screen Startup Screen
Streszczenie treści zawartej na stronie nr. 17
A A A Problem Solution Result Press the Auto Image button on the keypad or remote. To No computer image, just the words “Signal out of Computer image projected adjust computer refresh rate, go to Control Panel > Display > range” Settings > Advanced > Adapter (location varies by operating system). Signal out of the range You may also need to set a different resolution on your computer, as shown in the following problem, “image fuzzy or cropped” Only my laptop’s background appears, not the W
Streszczenie treści zawartej na stronie nr. 18
A Problem Solution Result Image fuzzy or cropped Set your computer’s display resolution to the native Image clear and not cropped resolution of the projector (Start > Settings > Control Panel > Display > Settings tab) A A A For a laptop, disable laptop monitor or turn- on dual-display mode Image not centered on screen Move projector and adjust zoom Correct image 17
Streszczenie treści zawartej na stronie nr. 19
Problem Solution Result Image not square Adjust Keystone in the Basic Picture menu Square image Image not sharp Adjust Sharpness in the Basic Picture menu Correct image Image does not fit 4:3 or 16:9 screen Change aspect ratio to 4:3 or 16:9 in Basic Correct image Picture>Aspect Ratio menu 18
Streszczenie treści zawartej na stronie nr. 20
Problem Solution Result Image upside down Turn off Ceiling Mount in Setup menu Correct image A Image reversed left to right Turn off Rear Project in Setup menu Correct image A Projected colors don’t match source Adjust color, tint, brightness, contrast in the Basic Correct image Picture menu and/or color space in the Advanced Picture menu COLOR COLOR 19
