Streszczenie treści zawartej na stronie nr. 1
IN5502, IN5504, IN5532, IN5534 User’s Guide
5500
Regulatory models: F5500, F5530
010-0715-02
Streszczenie treści zawartej na stronie nr. 2
designed to provide reasonable protection against harmful interference Declaration of Conformity when the equipment is operated in a commercial environment. This Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Portland, equipment generates, uses and can radiate radio frequency energy and, if Oregon 97223-8368 USA not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of the We declare under our sole resp
Streszczenie treści zawartej na stronie nr. 3
Index 64 Table of Contents Introduction 5 Positioning the projector 7 Ceiling Mount 8 Cable management 8 Connecting power 9 Connecting a computer source 9 Optional computer connections 10 Displaying an image 11 Adjusting the image 12 Connecting a video device 13 Video device connections 13 Shutting down the projector 15 Troubleshooting your setup 15 Using the remote control 23 Using the audio 24 Using the keypad buttons 25 Optimizing computer images 25 Presentation features 25 Optimizing video i
Streszczenie treści zawartej na stronie nr. 4
8’/2.4m caused by use of non-approved ceiling mount kits or by installing in an Important Operating Considerations for Safety improper location. • Refer to this guide for proper startup and shutdown procedures. • When the projector is ceiling mounted, wear protective eyewear to • Follow all warnings and cautions in this manual and on the projector. prevent eye injury before opening lamp door. • Do not block the lens with any object while the projector is being used. • The projector must be i
Streszczenie treści zawartej na stronie nr. 5
Follow these instructions to help ensure image quality and lamp life over IMPORTANT: Unpacking/Transport Notes for the IN5502, IN5504, IN5532 and the life of the projector. Failure to follow these instructions may affect the IN5534 warranty. For complete details of the warranty, see the Warranty Booklet. When unpacking your projector, remove the black Lens Protector Ring from around the lens in order to allow full movement of the lens. KEEP the Lens Protector Ring for future transport purpo
Streszczenie treści zawartej na stronie nr. 6
Optional Accessories Introduction Optional accessories include optional top covers in a variety of finishes, Your new digital projector is simple to connect, easy to use, and optional lenses, the Commander-2 remote, ceiling mount, DisplayLink straightforward to maintain. It is a versatile projector that is flexible enough Extender, DisplayLink Wireless Adapter, and LiteShow II. These items and for business presentations and home video viewing, too. The IN5502 and other accessories can be f
Streszczenie treści zawartej na stronie nr. 7
power to an InFocus LiteShow II wireless device or InFocus DisplayLink Connector Panel Extender device. The projector provides both computer and video connection options, including: 12V Screen Trigger output •VGA computer (2) The 3.5mm mini-jack screen trigger provides a 12 volt, 0.25 amp DC output. It turns on when the lamp is lighted. If you connect your projection screen •HDMI (2) to this output using the cable that came with your screen, the screen will •S-video move down when the lamp
Streszczenie treści zawartej na stronie nr. 8
Positioning the Projector To determine where to position the projector, consider the size and shape of Vertical Image Offset is 50 - 110% your screen, the location of your power outlets, and the distance between the projector and the rest of your equipment. Here are some general guidelines: • Position the projector on a flat surface at a right angle to the screen. The projector (with the standard lens) must be at least 3 feet (0.9m) from the projection screen. 110% offset • Position the p
Streszczenie treści zawartej na stronie nr. 9
Ceiling Mount Cable Management If you wish to install the projector on the ceiling: The integrated cable management system allows you to keep the cables organized. To use the cable management system, thread the cables into the • The projector must be installed by a qualified professional in order to slots as shown in the illustration. ensure proper operation and reduce the risk of hazards or injury. It is not recommended you install the projector yourself. • We strongly recommend using InFoc
Streszczenie treści zawartej na stronie nr. 10
RGBHV connection Connecting power Connect one end of the BNC cable to the computer and the other end of the Connect the black power cord to the Power connector on the rear of the cable into the BNC connectors on the projector. projector and to your electrical outlet. The Power light on the Status Indicator Panel (page 15) turns amber. NOTE: Always use the power cord that shipped with the projector. Connect power cord Connecting a computer source DisplayLink If you have a Windows or Macintosh c
Streszczenie treści zawartej na stronie nr. 11
Optional computer connections Connect monitor cable To get sound from the projector, connect an audio cable (optional cable, sold separately) to your computer and to the Audio 1 (used with VGA 1) or Audio 2 (used with VGA 2) connector on the projector. You can also assign your source to a different audio in connector, see page 24 and page 31. You may also need an adapter. If you are using a desktop computer and want to see the image on your computer screen as well as on the projection scree
Streszczenie treści zawartej na stronie nr. 12
focus zoom horizontal vertical Displaying an image Press Power button Touch the Power button on the keypad or the remote. The Power button blinks green, a beep will sound and the fans start to run. When the lamp turns on, the start up screen will display and the Power button will become solid green. It can take a minute for the image to achieve full brightness. No start up screen? Get help on page 16. Turn on computer or video device Turn on your computer or video device. The image should ap
Streszczenie treści zawartej na stronie nr. 13
Adjusting the image Adjust distance Position the projector to the desired distance from the screen at a 90 degree angle to the screen. See the Appendix for screen sizes and distances associated with the various lens options. Adjust zoom, focus and If the image is square but not centered on the screen or viewing area, adjust lens shift. Zoom or Focus in the Basic Picture menu. (You can also hold down the Select button for 10 seconds to turn the focus control on.) Then adjust Digital Horz Sh
Streszczenie treści zawartej na stronie nr. 14
HDMI 1.3 connection Connecting a video device HDMI is a standard, uncompressed, all-digital audio/video interface. You can connect video devices such as VCRs, DVD players, camcorders, HDMI provides an interface between sources, such as set-top boxes, DVD digital cameras, video game consoles, HDTV receivers, and TV tuners to the players, and receivers and your projector. Plug an HDMI cable into the projector. You can connect the audio directly to the projector to get sound video out connector
Streszczenie treści zawartej na stronie nr. 15
What is Aspect Ratio? 4:3 screen 16:9 screen Aspect ratio is the ratio of the image width to image height. Standard TV screens and older laptops are 4:3; HDTV and most DVDs are 16:9; and widescreen computers are 16:10. If you are projecting onto a screen, the size/shape of the screen will influence the aspect ratio you decide to use. If you are projecting onto a blank wall, there are no screen size restrictions. 4:3 What you plan to project will also help you choose between 4:3, 16:9 or mod
Streszczenie treści zawartej na stronie nr. 16
Shutting down the projector Troubleshooting your setup The Status Indicator Panel on top of the projector indicates the state of the Screen Save Time projector and is helpful when troubleshooting. You can make the black screen appear after a preset number of minutes by turning on the Screen Save Time feature in the Setup menu. See page 30. Auto Off Time The projector has an Auto Off Time feature that automatically turns the Table 1: Status indicator light behavior and meaning projector off if
Streszczenie treści zawartej na stronie nr. 17
Problem Solution Result No start up screen. Correct image. Plug the power cord into the projector then press the power button. If your computer is using the projector's DisplayLink Computer image projected. Only the start up screen appears. connector, see the DisplayLink Software User's Guide for troubleshooting information. Press the Source button to activate the laptop’s external port. Restart laptop 16 Startup Screen Startup Screen
Streszczenie treści zawartej na stronie nr. 18
Problem Solution Result Press the Auto Image button on the keypad or remote. To No computer image, just the words “Signal out of Computer image projected. adjust computer refresh rate, go to Control Panel > Display > range.” Settings > Advanced > Adapter (location varies by operating system). Signal out of the range You may also need to set a different resolution on your computer, as shown in the following problem, “image fuzzy or cropped.” Only my laptop’s background appears, not the Dis
Streszczenie treści zawartej na stronie nr. 19
Problem Solution Result Image fuzzy or cropped Set your computer’s display resolution to the native Image clear and not cropped. resolution of the projector (Start > Settings > Control Panel > Display > Settings tab). A A A For a laptop, disable laptop monitor or turn- on dual-display mode Image not centered on screen. Adjust Lens Shift in the Basic Picture menu. Correct image. 18
Streszczenie treści zawartej na stronie nr. 20
Problem Solution Result Image not square. Adjust Keystone in the Basic Picture menu. Square image. Image not sharp. Adjust Sharpness in the Basic Picture menu. Correct image. Image does not fit 4:3 or 16:9 screen. Change aspect ratio to 4:3 or 16:9 in Basic Correct image. Picture>Aspect Ratio menu. 19