Streszczenie treści zawartej na stronie nr. 1
IN3114, IN3116
Regulatory models: M3100
010-0738-02
DISPERINDAG No. 0287/1.824.51/09.0
Streszczenie treści zawartej na stronie nr. 2
energy and, if not installed and used in accordance with the instructions, may cause Declaration of Conformity harmful interference to radio communications. However, there is no guarantee that Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Portland, Oregon interference will not occur in a particular installation. If this equipment does cause 97223-8368 USA harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
Streszczenie treści zawartej na stronie nr. 3
Table of Contents Introduction 4 Positioning the projector 6 Ceiling Mount 7 Connecting power 8 Connecting a computer source 8 Optional computer connections 9 Displaying an image 10 Adjusting the image 11 Connecting a video device 12 Video device connections 12 Shutting down the projector 14 Troubleshooting your setup 14 Using the remote control 22 Using the audio 23 Using the keypad buttons 24 Optimizing computer images 24 Presentation features 24 Optimizing video images 25 Customizing the proj
Streszczenie treści zawartej na stronie nr. 4
2’ / 0.6 m 8’/2.4m • Only genuine InFocus lamps are tested for use in this projector. Use of non Important Operating Considerations for Safety InFocus lamps may cause electrical shock and fire, and may void the projector • Refer to this guide for proper startup and shutdown procedures. warranty. • Follow all warnings and cautions in this manual and on the projector. • Hg – Lamp contains mercury. Manage in accordance with local • Place the projector in a horizontal position no greater than 8
Streszczenie treści zawartej na stronie nr. 5
Introduction Top rear cover LiteTouch keypad Your new digital projector is simple to connect, easy to use, and straightforward to Top front cover / maintain. It is a versatile projector that is flexible enough for business presentations Lamp access panel and home video viewing, too. The IN3114 has native XGA 1024x768 resolution, and the IN3116 has WXGA 1280x800 resolution. This guide applies to both products. They are compatible with a wide variety of computers and video devices. Product sp
Streszczenie treści zawartej na stronie nr. 6
Connector panel The projector provides both computer and video connection options, including: RS-232 • VGA computer (2) VGA • HDMI (1) 5V DC Monitor out output •S-video HDMI Audio in • Composite video S-video IR Sensor • Separate audio inputs for video and computer • USB DisplayLink connector, for computer audio/video input. This USB connection also provides power out for the DisplayLink Wireless Adapter (and mouse control when used with the optional Commander 2 remote). The projector also pr
Streszczenie treści zawartej na stronie nr. 7
Positioning the projector Table 1: IN3114 (XGA) To determine where to position the projector, consider the size and shape of your Range of distance to the screen for a given screen size screen, the location of your power outlets, and the distance between the projector Distance to screen and the rest of your equipment. Here are some general guidelines: Diagonal Screen Minimum Maximum Distance • Position the projector on a flat surface at a right angle to the screen. The Size (inches/m) distan
Streszczenie treści zawartej na stronie nr. 8
Ceiling Mount If you wish to install the projector on the ceiling: • We strongly recommend using InFocus approved ceiling mounts for proper fit- ting, ventilation and installation. Refer to the installation guide that comes with the InFocus Ceiling Mount Kit (p/n SP-CEIL-UNIV) for more informa- tion. The warranty does not cover any damage caused by use of non-approved ceiling mount kits or by installing in an improper location. • The ceiling must be strong enough to support the projector and
Streszczenie treści zawartej na stronie nr. 9
Connecting power Connect power cord Connect the black power cord to the Power connector on the rear of the projector and to your electrical outlet. The Power light on the Status Indicator Panel (page 14) turns amber. NOTE: Always use the power cord that shipped with the projector. Connecting a computer source DisplayLink Connect USB cable If you have a Windows or Macintosh computer, connect the USB cable between your computer's USB port and the projector's DisplayLink connector*. Then to beg
Streszczenie treści zawartej na stronie nr. 10
Optional computer connections To get sound from the projector, connect an audio cable (optional cable, not Connect audio cable included) to your computer and to the Audio 1 or Audio 2 connector on the projector. (Default settings are as follows: Audio 1 is used with VGA 1 and VGA 2; Audio 2 is used with S-video and composite.) You can also assign a your source to a different audio in connector, see page 23 and page 30. You may also need an adapter. If you are using a desktop computer and wa
Streszczenie treści zawartej na stronie nr. 11
Displaying an image Press Power button Touch the Power button on the keypad or the remote. The Power button blinks green and the fans start to run. When the lamp turns on, the start up screen will display and the Power button will become solid green. It can take a minute for the image to achieve full brightness. No start up screen? Get help on page 15. Turn on computer or Slide the lens cover to the side, if it is covering the lens. video device Turn on your computer or video device. The imag
Streszczenie treści zawartej na stronie nr. 12
Adjusting the image Adjust height If necessary, adjust the height of the projector by pressing the elevator foot release button to extend the foot. Rotate the elevator feet for granular adjustment of the projector’s height. Avoid placing your hands near the hot exhaust vent at the side of the projector. Avoid placing your hands near the hot exhaust vent at the side of the projector. Position the projector to the desired distance from the screen at a 90 degree angle to Adjust distance the scr
Streszczenie treści zawartej na stronie nr. 13
Composite video connection Connecting a video device Plug the composite video cable’s yellow connector into the video out connector on You can connect video devices such as VCRs, DVD players, camcorders, digital the video device. Plug the other yellow connector into the yellow Composite cameras, video game consoles, HDTV receivers, and TV tuners to the projector. connector on the projector. You can connect the audio directly to the projector to get sound from the built-in Plug the white con
Streszczenie treści zawartej na stronie nr. 14
What is Aspect Ratio? 4:3 screen 16:9 screen Aspect ratio is the ratio of the image width to image height. Standard TV screens and older laptops are 4:3; HDTV and most DVDs are 16:9; and widescreen computers are 16:10. If you are projecting onto a screen, the size/shape of the screen will influence the aspect ratio you decide to use. If you are projecting onto a 4:3 blank wall, there are no screen size restrictions. What you plan to project will also mode help you choose between 4:3, 16:9
Streszczenie treści zawartej na stronie nr. 15
Shutting down the projector Troubleshooting your setup The Status Indicator Panel on top of the projector indicates the state of the projector Screen Save Time and is a helpful when troubleshooting. You can make the black screen appear after a preset number of minutes by turning on the Screen Save Time feature in the Setup menu. See page 29. Auto Off Time The projector has an Auto Off Time feature that automatically turns the projector Table 3: Status indicator light behavior and meaning off
Streszczenie treści zawartej na stronie nr. 16
A A Problem Solution Result No start up screen Correct image Plug power cord into the projector then press power button If your computer is using the projector's DisplayLink connector, see the DisplayLink Computer image projected Only start up screen appears Software User's Guide for troubleshooting information. Press the Source button Activate the laptop’s external port Restart laptop 15 Startup Screen Startup Screen
Streszczenie treści zawartej na stronie nr. 17
A A A Problem Solution Result Press the Auto Image button on the keypad or remote. To No computer image, just the words “Signal out of Computer image projected adjust computer refresh rate, go to Control Panel > Display range” > Settings > Advanced > Adapter (location varies by operating system). Signal out of the range You may also need to set a different resolution on your computer, as shown in the following problem, “image fuzzy or cropped” Only my laptop’s background appears, not the
Streszczenie treści zawartej na stronie nr. 18
A Problem Solution Result Image fuzzy or cropped Set your computer’s display resolution to the native Image clear and not cropped resolution of the projector (Start > Settings > Control Panel > Display > Settings tab) A A A For a laptop, disable laptop monitor or turn- on dual-display mode Image not centered on screen Move projector and adjust zoom Correct image 17
Streszczenie treści zawartej na stronie nr. 19
Problem Solution Result Image not square Adjust Keystone in the Basic Picture menu Square image Image not sharp Adjust Sharpness in the Basic Picture menu Correct image Image does not fit 4:3 or 16:9 screen Change aspect ratio to 4:3 or 16:9 in Basic Correct image Picture>Aspect Ratio menu 18
Streszczenie treści zawartej na stronie nr. 20
Problem Solution Result Image upside down Turn off Ceiling Mount in Setup menu Correct image A Image reversed left to right Turn off Rear Project in Setup menu Correct image A Projected colors don’t match source Adjust color, tint, brightness, contrast in the Basic Correct image Picture menu and/or color space in the Advanced Picture menu COLOR COLOR 19
