Streszczenie treści zawartej na stronie nr. 1
Color Rear Projection TV KP-FX53/FX43
4-090-470-22 (2)
Projection TV
GB
Operating Instructions
• Before operating the unit, please read this manual thoroughly and retain
it for future reference.
FR
Mode d’emploi
•Avant de faire fonctionner cet appareil, lisez attentivement le présent
mode d’emploi et conservez-le pour toute référence ultérieure.
CT
CS
PR
• xxxxxxxx xxxxxxxxxxxxxxxx xxxxxxxxxxxx xxxxxxxxxxx xxxxxxxxxxx
xxxxxxx.
AR
• xxxxxxxx xxxxxxxxxxxxxxxx xxxxxxxxxxxx xxxxxxxxxxx xxxxxxxxxxx
x
Streszczenie treści zawartej na stronie nr. 2
2
Streszczenie treści zawartej na stronie nr. 3
Using Your New Projection TV Table of Contents WARNING Using Your New Projection TV Getting Started ............................................................................................. 5 Step 1 Install the projection TV ............................................................ 5 Step 2 Connect the antenna .................................................................. 6 Step 3 Insert the batteries into the remote.......................................... 7 Step 4 Setting up your p
Streszczenie treści zawartej na stronie nr. 4
WARNING To prevent fire or shock hazard, do not expose the projection TV to rain or moisture. Dangerously high voltages are present inside the projection TV. Do not open the cabinet. Refer servicing to qualified personnel only. For general safety: • Do not expose the projection TV to rain or moisture. • Do not open the rear cover. For safe installation: • Do not block the ventilation openings. • Do not install the projection TV in hot, humid or excessively dusty places. • Do not install the pr
Streszczenie treści zawartej na stronie nr. 5
Using Your New Projection TV min. 1.9 m (6 ft.) min. 1.9 m (6 ft.) min. 2.4 m (8 ft.) min. 2.4 m (8 ft.) Using Your New Projection TV Getting Started Step 1 Install the projection TV For the best picture quality, install the projection TV within the areas below. Optimum viewing Optimum viewing area area (Horizontal) (Vertical) KP-FX43 KP-FX43 20° 60° 60° 20° KP-FX53 KP-FX53 20° 60° 60° 20° continued Using Your New Projection TV 5
Streszczenie treści zawartej na stronie nr. 6
Getting Started (continued) Step 2 Connect the antenna If you wish to connect a VCR, see the “Connecting a VCR” diagram on page 7. Rear of projection TV Antenna cable (not supplied) or IEC connector (not supplied) Antenna cable (not supplied) : Signal flow CAUTION Do not connect the power cord until all other connections are complete, otherwise, a minimal current leakage through the antenna and/or other terminals to the ground could occur. 6 Using Your New Projection TV
Streszczenie treści zawartej na stronie nr. 7
Using Your New Projection TV Connecting a VCR To play a video tape, press t (see page 16). To 8 (antenna) Antenna cable (not supplied) Rear of projection TV To To antenna (S video input) output VCR Y Y G S video cable PB /CB PB/CB HD B (not supplied) PR SYNC /CR PR/CR VD R AUDIO VIDEO (MONO) L L L R L VIDEO IN R R R To S video 11 2 3 2 VIDEO OUT output To video and To t 1, 2 or 3 (video input) audio outputs (yellow) -L (MONO) (white) Audio/Video cable -R (red) (not supplied) : Signal flo
Streszczenie treści zawartej na stronie nr. 8
PROG INDEX + + + G G G T T T O O O W W W R R R I I I P P P N N N Getting Started (continued) Step 4 Setting up your projection TV automatically VIDEO ! A/B DRC-MF PROG MENU MENU ENTER HD/DVD Press ! to turn on the 1 projection TV. INITIAL SETUP LANGUAGE: ENGLISH The “INITIAL SETUP” menu appears, and you can select the on-screen language. Move up or down 2 to select the desired INITIAL SETUP language, then press START AUTO PROGRAM . NOW? The automatic channel YES presetting menu appears. NO 8 Us
Streszczenie treści zawartej na stronie nr. 9
Using Your New Projection TV + + + G G G T T T O O O W W W R R R I I I P P P N N N Move up or down to 3 INITIAL SETUP select “YES”, then press PROG : 09 to preset the channel TV SYS : AUTO VHF LOW automatically. The screen will indicate automatic presetting is in progress. INITIAL SETUP START DIGITAL QUICK After channel presetting is FOCUS NOW? complete, automatic convergence adjustment YES menu appears. NO Make sure that “YES” is 4 selected, then press . The convergence adjustment screen appe
Streszczenie treści zawartej na stronie nr. 10
Connecting optional components You can connect optional audio/video components, such as a VCR, a DTV (Digital Television) Receiver, multi disc player, camcorder, video game, or stereo system. To watch and operate the connected equipment, see pages 16 and 30. Connecting a camcorder/video game equipment using the t (video input) jacks To open the drop-down panel of your projection TV, push the eight edge of the panel until you hear a click, then the panel over will open downwards. PROG MENU ENTER
Streszczenie treści zawartej na stronie nr. 11
Using Your New Projection TV Connecting audio/video equipment using the T (monitor output) jacks Antenna cable (not supplied) Rear of projection TV Y Y To G Audio system PB /CB PB/CB antenna HD B output PR SYNC VCR /CR PR/CR VD R or (MONO) L L L To To video R R R audio and audio 11 2 3 2 inputs inputs To T (yellow) Audio cable (monitor (not supplied) -L (MONO) output) (white) -R (red) Audio/Video cable (not supplied) : Signal flow Note • If you select “HD/DVD 1” or “HD/DVD 2” on your pr
Streszczenie treści zawartej na stronie nr. 12
Connecting optional components (continued) Connecting a DVD player to (component video input) 1 Using an audio cable, connect R and L under 1 or 2 (component video input) on your projection TV to the LINE OUT, AUDIO R and L output connectors on your DVD player. 2 Using a component video cable, connect Y, PB/CB, and PR/CR under 1 or 2 (component video input) on your projection TV to the COMPONENT VIDEO OUT Y, CB, and CR output connectors on your DVD player. 3Press t or HD/DVD on the remote or
Streszczenie treści zawartej na stronie nr. 13
Using Your New Projection TV Connecting a DVD player to t (video input) Connect t 1, 2, or 3 (video input) / (audio/video) connectors on your projection TV to LINE OUT on your DVD player. Rear of projection TV To t 1, 2, or 3 To audio/video output (video input) Audio/Video cable (not supplied) (MONO) L R-AUDIO-L VIDEO DVD LINE OUT R player 1 2 3 (yellow) -L (MONO) (white) : Signal flow -R (red) Notes • Since the high quality pictures on a DVD disc contain a lot of information, picture noise
Streszczenie treści zawartej na stronie nr. 14
Connecting optional components (continued) Connecting a DTV (digital television) receiver to 1 or 2 (component video input) jacks Rear of projection TV Component video cable To 1 or 2 (not supplied) (Component video input) To component video output Audio cable (not supplied) To audio Y Y G output PB /CB PB/CB B PR /CR PR/CR R L L R R Digital TV 1 2 To -L (white) receiver -R (red) : Signal flow Notes • The projection TV is equipped with the G/B/R/HD/VD inputs. If your DTV receiver is not equip
Streszczenie treści zawartej na stronie nr. 15
Using Your New Projection TV PROG INDEX + G T O W R I P N Watching the TV VIDEO This section explains various functions and operations used while watching the TV. Most operations can be done using DRC-MF A/B the remote. HD/DVD HD/DVD 1 indicator 12 3 PROG 45 6 Number buttons 78 9 JUMP 0 JUMP PROG MENU ENTER PROG MENU ENTER PROG +/– OPTION RESET 2 +/– TV Press ! to turn on the 1 projection TV. When the projection TV is in standby mode (the 1 indicator on the projection TV is lit red), press !/1
Streszczenie treści zawartej na stronie nr. 16
Watching the TV (continued) To select a TV program quickly (1) Press and hold PROG +/–. (2) Release PROG +/– when the desired program number appears. Note • When you select a TV program quickly, the picture may be disrupted. This does not indicate a malfunction. Additional tasks To Press Turn off temporarily @/1. The 1 indicator on the projection TV lights up red. Turn off completely ! on the projection TV. Adjust the volume 2 +/–. Mute the sound %. t (or t on the projection TV) to select “VIDEO
Streszczenie treści zawartej na stronie nr. 17
Using Your New Projection TV Setting the Wake Up timer Press until the desired 1 WAKE UP TIMER:10M period of time appears. After 10 minutes The Wake Up timer starts immediately after you WAKE UP TIMER:OFF WAKE UP TIMER:12H00M have set it. No Wake Up Timer After 12 hours Select the TV channel or video mode you want to wake up to. 2 Press !/1, or set the Sleep timer if you want the projection TV to turn off 3 automatically. The indicator on the projection TV lights up orange. To cancel the Wake
Streszczenie treści zawartej na stronie nr. 18
Advanced Operations Selecting the picture and sound modes JUMP 0 PROG You can select picture and sound modes and adjust the setting to your preference in the “PERSONAL” option. OPTION RESET Selecting the picture mode Press repeatedly until DYNAMIC STANDARD the desired picture mode is selected. PERSONAL HI-FINE Select To “DYNAMIC” receive high contrast pictures. “STANDARD” receive normal pictures. “HI-FINE” receive higher density pictures with mild contrast. “PERSONAL” receive the last adjusted
Streszczenie treści zawartej na stronie nr. 19
Advanced Operations PROG INDEX + G T O W R I P N Viewing higher VIDEO quality pictures — “DRC-MF” DRC-MF DRC-MF A/B The Digital Reality Creation-Multi Function (DRC-MF) feature allows you to enjoy higher quality pictures on your projection TV. You can select “DRC1250” to watch super real (higher resolution) HD/DVD pictures, or “DRC100” for moving pictures or “PROGRESSIVE” for still pictures to 12 3 reduce flicker if necessary. 45 6 78 9 JUMP 0 Press DRC-MF repeatedly DRC-MF: DRC1250 DRC-MF: DRC1
Streszczenie treści zawartej na stronie nr. 20
PROG INDEX + G T O W R I P N Watching two VIDEO programs at the same time DRC-MF A/B — “TWIN” With the TWIN pictures feature, you can display a different TV program beside HD/DVD the main picture. 12 3 45 6 78 9 JUMP 0 Displaying TWIN pictures Press . 10 12 To return to the normal screen Press . The left picture is displayed in full screen. Tip •You can also display the TWIN pictures using the menu (see “Changing the MULTI PICTURE setting” on page 41). •Pressing displays the right picture in fu
