Streszczenie treści zawartej na stronie nr. 1
English
User’s Manual
M00024502EN
TM-T88V User’s Manual 1
Streszczenie treści zawartej na stronie nr. 2
English All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the information contained herein. While every precaution has been taken in the preparation of this book, Seiko Epson Corporation assumes no responsibility for e
Streszczenie treści zawartej na stronie nr. 3
English Default Delay Times for Power Management for Epson Products This product will enter low power (sleep) mode after a period of nonuse. The time interval has been set at the factory to ensure that the product meets Energy Star standards of energy efficiency and cannot be modified by the consumer. The power consumption in the sleep mode and power off mode is described below. USB model Serial model Ethernet model Sleep mode 0.8 W 0.7 W 1.4 W AC 230V/50 Hz Power off mode 0.2 W 0.2 W 0.2 W 0.
Streszczenie treści zawartej na stronie nr. 4
English Important Safety Information This section presents important information intended to ensure safe and effective use of this product. Read this section carefully and store it in an accessible location. Key to Symbols The symbols in this manual are identified by their level of importance, as defined below. Read the following carefully before handling the product. WARNING: Warnings must be followed carefully to avoid serious bodily injury. CAUTION: Cautions must be observed to avoid minor
Streszczenie treści zawartej na stronie nr. 5
English Regularly remove the power plug from the outlet and clean the base of the prongs and between the prongs. If you leave the power plug in the outlet for a long time, dust may collect on the base of the prongs, causing a short and fire. Regularly confirm that the plug and AC inlet are not wet with liquid such as water. Do not allow foreign matter to fall into the equipment. Penetration by foreign objects may lead to fire. If water or other liquid spills into this equipment, unplug the p
Streszczenie treści zawartej na stronie nr. 6
English Downloading Drivers, Utilities, and Manuals The latest versions of drivers, utilities, and manuals can be downloaded from one of the following URLs. For customers in North America, go to the following web site: http://www.epsonexpert.com/ and follow the on-screen instructions. For customers in other countries, go to the following web site: https://download.epson-biz.com/?service=pos Unpacking The following items are included with the standard specification printer. If any item is dam
Streszczenie treści zawartej na stronie nr. 7
English Part Names Roll paper cover Control panel Cutter cover Cover open lever Power switch Control Panel (Power) LED This LED is on when the printer is on. Error LED This indicates an error. Paper LED On indicates a paper out. Flashing indicates standby. Feed button This button feeds paper. TM-T20 User’s Manual 7
Streszczenie treści zawartej na stronie nr. 8
English Connecting the Cables CAUTION: For a serial interface, use a null modem cable. For a USB interface, do not turn on the printer before installing the printer driver. Always supply power directly from a standard power outlet. Do not connect to electrical outlets close to devices that generate voltage fluctuations or electrical noise. In particular, stay clear of devices that use large electric motors. Never attempt to stretch the cables to enable a connection. The power cable must have
Streszczenie treści zawartej na stronie nr. 9
English 5. Insert the AC plug into a socket. Installing the Printer You can install the printer horizontally on a flat surface (with the paper exit on top) or vertically (with the paper exit at the front). Also, you can hang it on a wall using the included accessories. CAUTION: Take measures to prevent the printer from moving by vibration during paper cutting and when using a drawer. Affixing tape is provided as an option. Installing the Printer Vertically When installing the printer vertical
Streszczenie treści zawartej na stronie nr. 10
English Note: You can install the printer so that the roll paper cover is upright to the mounting surface using the included wall hanging bracket. 1. Attach the control panel label for vertical installation on the roll paper cover. 2. Install the wall hanging bracket on the printer, and fix it using 2 included screws. 3. Attach 2 rubber feet in the rectangular indents in the printer case, and attach 2 rubber feet within the scribed line on the hanging bracket. 4. Place the printer with the wal
Streszczenie treści zawartej na stronie nr. 11
English Hanging the Printer on a Wall To hang the printer on the wall, follow the steps below. CAUTION: To fix the printer securely, install the wall hanging bracket on a wall made of wood, concrete, or metal. The thickness of the wall should be 10 mm {0.4”} or more. Be sure to use metallic screws. The screws on the wall side must have a pull-out strength of 150 N (15.3 kgf) or more. 1. Install 2 screws (screw diameter: 4 mm {0.16"}, head diameter: 7 to 9 mm {0.28 to 0.35"}) in the wall at a
Streszczenie treści zawartej na stronie nr. 12
English 4. Align the holes in the wall hanging bracket with the screws on the wall, and hook it securely. Installing Roll Paper Follow the steps below to install the roll paper. 1. Use the cover open lever to open the roll paper cover. Cover open lever 12 TM-T20 User’s Manual
Streszczenie treści zawartej na stronie nr. 13
English 2. Remove the used roll paper core if any, and insert the roll paper. The correct direction of the paper is shown in the illustration below. 3. Pull out some paper, and close the roll paper cover. When the printer power is on, the roll paper is automatically cut. 2 1 TM-T20 User’s Manual 13
Streszczenie treści zawartej na stronie nr. 14
English Changing the Paper Width You can change the paper width from 80 to 58 mm by installing the included 58-mm width paper guide plate. Follow the steps below to change the paper width. CAUTION: Once you change the paper width from 80 to 58 mm, you cannot change it back to 80 mm. When changing the paper width, be sure to make the setting for the paper width with the utility software for the TM-T20. 1. Open the roll paper cover. 2. Align 3 projections on the 58-mm width paper guide plate w
Streszczenie treści zawartej na stronie nr. 15
English Attaching Cover on the Power Switch The enclosed power switch cover ensures that the power switch is not pressed accidentally. You can turn the power switch on and off by inserting a sharp-pointed object in the holes in the power switch cover. To detach the cover, also use a sharp-pointed object. A waterproof cover for the power switch is also included. To use these covers, install them as shown in the illustration below. WARNING: If an accident occurs with the power switch cover atta
Streszczenie treści zawartej na stronie nr. 16
English When a paper jam occurs When a paper jam occurs, never pull out the paper forcibly. Open the roll paper cover and remove the jammed paper. CAUTION: Do not touch the thermal head, because it can be very hot after printing. If the roll paper cover does not open, follow the steps below. 1. Turn off the printer. 2. Put the fingers in the indents in both sides of the cutter cover, and slide it toward the arrow in the illustration below to remove it. Cutter cover Indent 3. Turn the knob unt
Streszczenie treści zawartej na stronie nr. 17
English Cleaning Cleaning the Printer Case Be sure to turn off the printer, and wipe the dirt off the printer case with a dry cloth or a damp cloth. CAUTION: Never clean the product with alcohol, benzine, thinner, or other such solvents. Doing so may damage or break the parts made of plastic and rubber. Cleaning the Thermal Head CAUTION: After printing, the thermal head can be very hot. Be careful not to touch it and to let it cool before you clean it. Do not damage the thermal head by touch
Streszczenie treści zawartej na stronie nr. 18
English Specifications *1 80 mm paper width 58 mm paper width Printing method Thermal line printing Dot density 203 dpi × 203 dpi [dots per 25.4 mm {1"}] Printing direction Unidirectional with friction feed Printing width Default 72.1 mm {2.84"}, 576 dot positions 52.6 mm {2.07"}, 420 dot positions 42 column 68.3 mm {2.69"}, 546 dot positions 47.3 mm {1.86"}, 378 dot positions *2 mode Characters per Default Font A: 48; Font B: 64 Font A: 35; Font B: 46 line 42 column Font A: 42; Font B: 60 Font
Streszczenie treści zawartej na stronie nr. 19
English *1 80 mm paper width 58 mm paper width Power supply Supply voltage: AC100-240V 50/60Hz, Rated current: 1.0 A Temperature Operating: 5 to 45°C {41 to 113°F} Storage: –10 to 50°C {14 to 122°F}, except for paper Humidity Operating: 10 to 90% RH Storage: 10 to 90% RH, except for paper Overall dimensions 146 × 140 × 199 mm {5.75 × 5.51 × 7.83"} (H × W × D) Weight (mass) Approx. 1.7 kg {3.74 lb} lps: lines per second dpi: dots per 25.4 mm (dots per inch) *1: The values are those when th
