Instrukcja obsługi CyberPower Systems 600E-GP

Streszczenie treści zawartej na stronie nr. 1

3. Charge the Battery
Your new UPS may be used immediately upon receipt. However charge loss may occur during
shipping and storage. So charging the battery for at least 8 hours is recommended to insure that
the battery is fully charged. (To recharge the battery, simply leave the unit plugged into an AC
outlet.)
This UPS can be charged even when UPS is not turn on.

4. Connect to AC
Use German power cord to connect
the UPS to a wall outlet. Please avoid
using extension c

Streszczenie treści zawartej na stronie nr. 2

Shutdown your computer and turn the 5. USB Port to PC The unit is not providing UPS off. Wait 10 seconds and turn the This port allows connection and battery power. UPS back on. This should reset the unit. communication from the USB port The serial cable is not the You must use the cable included with the on the computer to the UPS unit. The cable that was provided with unit for the software. UPS communicates its status to the the unit. ® PowerPanel Personal Edition soft