Streszczenie treści zawartej na stronie nr. 1
Models
Indoor Unit 12C1H
MW09C1H MW
Outdoor Unit
MR09C1H
MR12C1H
920-088-01
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
CONTENTS Operation and maintenance Notices for use ■ ......................................1 ■ ................................. 3 Typical Unit Components ■Operation of remote controller ............................. 4 ■Remote Control Instructions............................ 7 ■Routine Maintenance................................. 11 ■Basic Troubleshooting ................................ 12 ■ ................................. Service & Assistance 15 Installation service ■ installation ....... .
Streszczenie treści zawartej na stronie nr. 4
Congratulations Thank you for your decision to purchase Friedrich. Your new Friedrich has been carefully engineered and manufactured to give you many years of dependable, efficient operation, maintaining a comfortable temperature and humidity level. Many extra features have been built into your unit to assure quiet operation, the greatest circulation of cool, dry air, and the most economic operation. General Instructions This Installation and Operation Manual has been designed to insure maxi
Streszczenie treści zawartej na stronie nr. 5
Notices for use Working principle and special functions for cooling Principle: Air conditioner absorbs heat in the room and transmit to outdoor and discharged, so that indoor ambient temperature decreased, its cooling capacity will increase or decrease by outdoor ambient temperature. Anti-freezing function: If the unit is running in COOL mode and in low temperature, there will be frost formed on the heat exchanger, when indoor heat exchanger temperature decrease s below 32 , the ºF indoor unit
Streszczenie treści zawartej na stronie nr. 6
Notices for use Anti-cool wind function: In "Heat" mode, under the following three kinds of state, if indoor heat exchanger doesn't arrive at certain temp., indoor fan will not start, in order to prevent cool wind blowing(within 2 mins): 1. Heating starts. 2.After Auto Defrost finished. 3.Heating under the low temperature. Working temperature range Indoor sideDB/WB( ) Outdoor sideDB/WB(ºF) ºF Maximum cooling 95/75 115/86 . 70/59 Minimum cooling 70/- Maximum heating 75/--- 75/60 Minimum heati
Streszczenie treści zawartej na stronie nr. 7
Typical Unit Components Indoor unit (Image shown here is indicative only. Actual product you receive may differ) Air inlet . Front Panel Display Wrapping Tape Wall Pipe Filter Guide panel Air outlet Wireless remote control Display icon （Only for some Units ）: Cooling Power/Run Receiver Heating Set temp. Dehumidify Outdoor unit Air in Drainage hose Air out 3 Connection pipe
Streszczenie treści zawartej na stronie nr. 8
Operation of Remote Controller 1 START / STOP Press to start or stop operation. 2 : Press to decrease temperature setting. 3 : Press to increase temperature setting. 4 FAN AUTO Press to set fan speed. 5 MODE Press to select operation mode (AUTO/COOL/DRY/FAN/HEAT). 6 SENSOR 7 CLOCK Press it set clock. 8 TIMER ON 1 2 3 Press it to set auto-on timer. 9 AIR SWEEP Press it set swing angle. 5 4 6 10 EXTEND 8 11 TEMP 9 7 12 TIMER OFF 10 11 12 Press it to set auto-off timer 13 13 TURBO 15
Streszczenie treści zawartej na stronie nr. 9
Operation of Remote Controller 26 27 25 24 16 23 22 21 17 18 19 20 16 MODE icon: 20 LIGHT icon: If MODE button is pressed, is displayed by pressing the current operation mode icon LIGHT button. Press LIGHT button again to clear the display. (AUTO), ( COOL), (DRY), (FAN) or (HEAT only for heat pump models) will show. 21 LOCK icon: is displayed by pressing "+" 17 SLEEP icon : and “-” buttons simultaneously. Press is displa
Streszczenie treści zawartej na stronie nr. 10
Operation of Remote Controller 26 27 25 24 16 23 22 21 17 20 18 19 25 27 SENSOR icon: EXTEND icon: is displayed when pressing the is displayed when pressing the SENSOR button. Press this button EXTEND button. Press this button again to clear the display. again to clear the display. 26 FAN SPEED display: Press FAN button to select the desired fan speed setting (AUTO- Low-Med-High).Your selection will be displayed in the LCD windows, except the AUTO fan speed. 6
Streszczenie treści zawartej na stronie nr. 11
Remote Control Instructions Remote Controller Description 1 START / STOP: Press this button to turn on the unit .Press this button again to turn off the unit. 2 Press this button to decrease set temperature. Hold it down for above 2 seconds to rapidly decrease set temperature. In AUTO mode, set temperature is not adjustable. 3 : Press this button to increase set temperature. Hold it down for above 2 seconds to rapidly increase set temperature. In AUTO mode, set temperature is not adjustable.
Streszczenie treści zawartej na stronie nr. 12
Remote Control Instructions 8 TIMER ON : Press this button to initiate the auto-ON timer. To cancel the auto-timer program, simply press this button again. After pressing this button, disappears and "ON "blinks . 00:00 is displayed for ON time setting. Within 5 seconds, press + or - button to adjust the time value. Every press of either button changes the time setting by 1 minute. Holding down either button rapidly changes the time setting by 1 minute and then 10 mi
Streszczenie treści zawartej na stronie nr. 13
Remote Control Instructions 14 SLEEP: Press this button to go into the SLEEP operation mode. Press it again to cancel this function. This function is available in COOL or DRY mode to maintain the most comfortable temperature for you. 15 LIGHT: Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If the light is turned on, is displayed. If the light is tunrned off, disappears. 16 Combination of "+" and "-" buttons:
Streszczenie treści zawartej na stronie nr. 14
Front Panel Illumination On/Off Display indicator light control of indoor unit Display indicator light on: To turn 'On' the light function,the mark will display on the remote controller screen by pressing this button. In which case,the diss- player indicator light will be on if the AC receives this signal. Display indicator light off: To turn 'Off ' the light function,the will disappear on t he remote controller screen by pressing this button. In which case, the display indicator
Streszczenie treści zawartej na stronie nr. 15
Routine Maintenance Caution ● ● Turn power off and pull out the power plug before cleaning air conditioner, or it may cause electric shock. ● Never sprinkle water on the indoor unit and the outdoor unit for cleaning because it can cause an electric shock. ● ● Volatile liquid (e.g. thinner or gasoline) will damage the air conditioner. (So wipe the units with a dry soft cloth, or a cloth slightly moistened with water or cleanser.) Clean the front panel When cleaning the front panel, please dip the
Streszczenie treści zawartej na stronie nr. 16
C a u s e ● Turn unit on. ● Raise/Lower temperature setting. ● Unit will resume normal operation once power has been restored. ● Clean air filter. ● Clean air conditioner. Please contact an Authorized Friedrich Service Agency ● When the compressor starts or stops running The sound of water flow you may here a swoosh during operation. or gugle, this isn't a malfunction. - 12
Streszczenie treści zawartej na stronie nr. 17
13
Streszczenie treści zawartej na stronie nr. 18
C a u s e Immediately stop all operations and plug out, contact the dealer in following situations occur. There is harsh sound during operation. The terrible odors emitted during operation. Water is leaking in the room. Air switch or protection switch often breaks. Turn off unit and switch off breaker. Accidently splash water or something into unit. There is an abnormal heat in power supply cord and power plug. 14
Streszczenie treści zawartej na stronie nr. 19
Service & Assistance Troubleshooting" section and still need help, here is a list of available services: 1 2 3 15
Streszczenie treści zawartej na stronie nr. 20
Installation Important Notices Indoor Unit Placement The air inlet and outlet vent should be far from the obstruction, make sure that the air 1 . can be blown through the whole room. 2 .Select a position where the condensing water can be easily drained out, and the place is easily connected for outdoor unit. 3.Select a location where the children can not reach. 4.Can select the place where is strong enough to withstand the full weight and vibration of the unit. And will not increase the noise. 5
