Streszczenie treści zawartej na stronie nr. 1
PROJECTION MONITOR
Operating Guide for
51M200, 65M200, 51M200A
IMPORTANT SAFETY INSTRUCTIONS ................................................................................ 2-3
FIRST TIME USE ..................................................................................................................4-19
THE REMOTE CONTROL .................................................................................................. 20-30
ON-SCREEN DISPLAY..............................................
Streszczenie treści zawartej na stronie nr. 2
IMPORTANT SAFETY INSTRUCTIONS SAFETY POINTS YOU SHOULD KNOW ABOUT YOUR ASPECT PROJECTION MONITOR Our reputation has been built on the quality, performance, and ease of service of ASPECT Projection Monitors. Safety is also foremost in our minds in the design of these units. To help you operate these products properly, this section illustrates safety tips which will be of benefit to you. Please read it carefully and apply the knowledge you obtain from it to the proper operation of you ASPECT
Streszczenie treści zawartej na stronie nr. 3
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 15.Projection Monitors are designed to comply with the Follow all warnings and instructions marked on this Projection recommended safety standards for tilt and stability. Monitor. Do not apply excessive pulling force to the front, or top, 1. Read these instructions. of the cabinet which could cause the product to over- 2. Keep these instructions. turn resulting in product damage and/or personal 3. Heed all warnings. injury. 4. Follo
Streszczenie treści zawartej na stronie nr. 4
ACCESSORIES Check to make sure you have the following accessories before disposing of the packing material. REMOTE CONTROL HL02251 “AA” BATTERIES POWER TV CBL/SAT DVD/VCR SWAP PIP MODE PIP FREEZE C.C. DAY/NIGHT MENU SELECT MUTE LAST CH EXIT VOL CH 123 456 789 ANT INFO 0 VID1 VID2 VID3 VID4 REC SIZE SLEEP VID5 CLU-433OUG 1. 2. 1. Remote Control Unit is either CLU-4330UG (Part No. HL02251). 2. Two “AA” size, 1.5V batteries (For Remote Control Unit). REMOTE CONTROL BATTERY INSTALLATION AND REPLACEM
Streszczenie treści zawartej na stronie nr. 5
FIRST TIME USE HOW TO SET UP YOUR NEW HITACHI PROJECTION MONITOR LOCATION Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set. To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the Projection Monitor where temperatures can become excessively hot, for example, in direct sunlight o
Streszczenie treści zawartej na stronie nr. 6
HOOK-UP CABLES AND CONNECTORS Most video/audio connections between components can be made with shielded video and audio cables that have phono connectors. For best performance, video cables should use 75-Ohm coaxial shielded wire. Cables can be purchased from most stores that sell audio/video products. Below are illustrations and names of common connectors. Before purchasing any cables, be sure of the output and input connector types required by the various components and the length of each cab
Streszczenie treści zawartej na stronie nr. 7
FIRST TIME USE FRONT PANEL CONTROLS ASPECT PULL POWER ASPECT PULL POWER AUDIO VOL- VOL+ INPUT MENU INPUT 5 MAGIC FOCUS EXIT SELECT S-VIDEO VIDEO L/MONO R CURSOR MENU/SELECT button This button allows you to enter the MENU, making it possible to set Projection Monitor features to your preference without using the remote. This button also serves as the SELECT button when in MENU mode. INPUT/EXIT button Press this button to select the current VIDEO: 1, 2, 3, 4, 5. Y
Streszczenie treści zawartej na stronie nr. 8
FRONT PANEL JACKS AND CONNECTORS The front panel jacks are provided as a convenience to allow you to easily connect a camcorder or VCR as shown in the following examples: -AUDIO- -AUDIO- INPUT 5 INPUT 5 S-VIDEO VIDEOL/MONO R S-VIDEO VIDEOL/MONO R MAGIC FOCUS MAGIC FOCUS NOTE: 1. Completely insert connection cord plugs when connecting to front panel jacks. If you do not, the played back picture may be abnormal. 2. If you have a S-VHS VCR, use the S-INPU
Streszczenie treści zawartej na stronie nr. 9
FIRST TIME USE REAR PANEL JACKS IMPORTANT: This is a monitor only product. No TV or Cable tuner is included. DVI-HDTV P P Y R B INPUT 1 R (MONO)/L AUDIO P P Y/VIDEO B R INPUT 2 R (MONO)/L AUDIO R (MONO)/L VIDEO S-VIDEO INPUT 3 R (MONO)/L VIDEO S-VIDEO AUDIO INPUT 4 TO HI-FI R L VIDEO S-VIDEO L MONITOR OUT AUDIO R Audio/Video Inputs 1, 2, 3 and 4 The VID1~VID4 buttons will select each video source each time they are pressed. Use the audio and video inputs to connect external devices
Streszczenie treści zawartej na stronie nr. 10
REAR PANEL JACKS Component: Y-P P Inputs B R Inputs 1 and 2 provide Y-P P jacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may B R use composite video signal for INPUT:2. NOTES: 1. Do not connect composite VIDEO and S-VIDEO to Input 3, 4 or 5 at the same time. S-VIDEO has priority over VIDEO input. 2. Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the Monitor’s P input and the components
Streszczenie treści zawartej na stronie nr. 11
FIRST TIME USE REAR PANEL CONNECTIONS TYPICAL FULL-FEATURE SETUP D-VHS AL DIGIT OUTPUT LR DVD Player HDTV Set-T op x Bo OUTPUT OUTPUT YP /C P /C LR B B R R YP P LR B R OUTPUT DVI-HDTV P P Y R B INPUT 1 R (MONO)/L O AUDI P P Y/VIDEO R B INPUT 2 R (MONO)/L O AUDI R (MONO)/L VIDEO S-VIDEO INPUT 3 R (MONO)/L VIDEO S-VIDEO INPUT 4 O AUDI TO HI-FI R L V IDEO S-VIDEO L MONITOR OUT O AUDI R V L R S-VIDEO LR V L R O S-VIDE OUTPUT INPUT INPUT , Laserdisc r VCR, playe VCR #2 , etc.
Streszczenie treści zawartej na stronie nr. 12
TIPS ON REAR PANEL CONNECTIONS • S-VIDEO and DVI-HDTV connections are provided for high performance laserdisc players, VCRs etc. that have this feature. Use these connections in place of the standard video connection if your device has this feature. • If your device has only one audio output (mono sound), connect it to the left audio jack on the Projection Monitor. • Refer to the operating guide of your other electronic equipment for additional information on connecting your cables. • You may us
Streszczenie treści zawartej na stronie nr. 13
FIRST TIME USE CONNECTING EXTERNAL AUDIO DEVICES To control the audio level of an external audio amplifier with the remote control, connect the system as shown below. REAR PANEL OF PROJECTION MONITOR DVI-HDTV P P Y R B INPUT 1 R (MONO)/L O AUDI P P Y/VIDEO R B INPUT 2 R (MONO)/L O AUDI R (MONO)/L VIDEO S-VIDEO INPUT 3 R (MONO)/L VIDEO S-VIDEO INPUT 4 O AUDI TO HI-FI R L V IDEO S-VIDEO L MONITOR OUT O AUDI R LR INPUT Stereo System r Amplifie NOTE: To prevent damage to the speaker and distorted so
Streszczenie treści zawartej na stronie nr. 14
CONNECTING EXTERNAL VIDEO SOURCES The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your Projection Monitor is dependent on the model and features of each component. Check the owner’s manual of each component for the location of video and audio inputs and outputs. The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your particular assortment of components and features.
Streszczenie treści zawartej na stronie nr. 15
FIRST TIME USE CONNECTING EXTERNAL VIDEO SOURCES CONNECTING A MONAURAL AUDIO SOURCE TO INPUT1~INPUT5 1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the Projection Monitor below. 2. Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack. 3. Press the VID4 button to view the program from the VCR or the laserdisc player. The VIDEO label disappears automatically after approximately
Streszczenie treści zawartej na stronie nr. 16
CONNECTING EXTERNAL VIDEO SOURCES CONNECTING A STEREO SOURCE TO INPUT1~INPUT5 1. Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the Projection Monitor below. 2. Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the INPUT (AUDIO/R) jack. 3. Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the INPUT (AUDIO/L) jack. 4. Press the VID4 button to view the program from the VCR or lase
Streszczenie treści zawartej na stronie nr. 17
FIRST TIME USE CONNECTING EXTERNAL VIDEO SOURCES CONNECTING AN S-VIDEO SOURCE TO INPUT 3, 4 AND 5 1. Connect the cable from the S-VIDEO OUT of the VCR or the laserdisc player to the INPUT (S-VIDEO) jack, as shown on the Projection Monitor below. 2. Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the INPUT (AUDIO/R) jack. 3. Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the INPUT (AUDIO/L) jack. 4. Press the VID4 button to view the prog
Streszczenie treści zawartej na stronie nr. 18
CONNECTING EXTERNAL VIDEO SOURCES CONNECTING A COMPONENT SOURCE WITH DVI-HDTV CAPABILITY TO INPUT 1. 1. Connect the DVI connection cable from the output of the HDTV set top box or DVD player to the DVI-HDTV input as shown on the Projection Monitor below. 2. Connect the cable from the AUDIO OUT R of the HDTV set top box or DVD player to the INPUT (AUDIO/R) jack. 3. Connect the cable from the AUDIO OUT L of the HDTV set top box or DVD player to the INPUT (AUDIO/L) jack. 4. Press the VID1 button
Streszczenie treści zawartej na stronie nr. 19
FIRST TIME USE CONNECTING EXTERNAL VIDEO SOURCES CONNECTING A COMPONENT SOURCE TO INPUT 1 OR 2: Y-P P . B R 1. Connect the cable from the Y OUT of the Laserdisc/DVD player or HDTV set top box to the INPUT (Y) jack, as shown on the Projection Monitor below. 2. Connect the cable from the C /P OUT or B-Y OUT of the Laserdisc/DVD player or HDTV set top box to the INPUT (P jack. B B B) 3. Connect the cable from the C /P OUT or R-Y OUT of the Laserdisc/DVD player or HDTV set top box to the INPUT (P
Streszczenie treści zawartej na stronie nr. 20
THE REMOTE CONTROL In addition to controlling all the functions on your ASPECT Projection Monitor, the new remote control is designed to operate dif- ferent types of VCRs, CBL (Cable TV) converters, satellite receivers, DVD players, and other audio/video equipment. Basic oper- ation keys are grouped together in one area. To operate your Projection Monitor, point the remote control at the IR Receiver sensor (see page 7) of the Projection Monitor and press the TV button. The remote will now contro
