Instrukcja obsługi Epson R800

Streszczenie treści zawartej na stronie nr. 1

Continuous Ink Supply System
for
EPSON Stylus Photo R800

Installation Instruction


For XM Prefilled Version

With Auto Reset Chips



This Version of the Continuous Ink Flow System comes with Prefilled
Cartridges and Auto Reset Chips. You just need to fill the
Reservoir bottles and print! The whole operation is very easy.
It’s really an effective tool to save your money.

Streszczenie treści zawartej na stronie nr. 2

CIS for EPSON Stylus Photo R800 Instruction Thank you for purchasing XM Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed XM Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges. Please take your time installing XM Continuous Ink

Streszczenie treści zawartej na stronie nr. 3

Put the CISS on the left side Pull out the small rubber plug Place 6pcs of air filters into of the printer. In the meantime from the air hole as above air holes, the thicker side place all the tubes at correct picture shown. is down into tank. position. 2、Second step: Remove the Cartridge A B

Streszczenie treści zawartej na stronie nr. 4

4、Step 4. 1)Remove old cartridges in the printer (Pic A); 2) Insert the CIS cartridges into the cartridge car (Pic B); Make sure the cartridges installed well.(Pic.C) A B C 5、Step 5, Fix Supporting Arm: 1) Tear off the sticker(Pic A); Measure 7.50cm from the edge of the printer, Attach supporting arm on the printer as Picture B show; 2) Tear off the sticker of balance arm (Pic.C); Attach it on the supporting arm (Pic.D); 3

Streszczenie treści zawartej na stronie nr. 5

Clip the tube clamp Finished 7、Step Seven: Adjusting the Tube A B C A. Adjust the length of the tube, move the cartridge Carrier B. Make Sure the tube moving with the cartridge Carrier will not collide or block the printer. C keep enough length of the tube to make sure the cartridge can reach the end Right side of the printer A

Streszczenie treści zawartej na stronie nr. 6

9、Ninth step: Checking the Printing head Printing Head Normal Printing testing normal，Begin to print Printing Head printing Break Printing Break，C

Streszczenie treści zawartej na stronie nr. 7

Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill ink according to the color in short supply. Then put the rubber back. (Please keep the printer and the reservoir at the same horizontal line during the process of refilling ink.) 六、Close the car

Streszczenie treści zawartej na stronie nr. 8

2. Avoid exposure to direct sunshine and don’t keep it in high or freezing temperature. 3. Avoid collision and fallen down.