Streszczenie treści zawartej na stronie nr. 1
Installation instructions
and User guide
Built-in oven
OB60 single, double and tower multifunction models
NZ AU GB IE
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
1 Contents Safety and warnings 2 Installation instructions 6 SEVEN-FUNCTION SINGLE OVEN MODELS Using your oven for the first time 16 Clock and timer 17 Using your oven 18 Cooking functions 19 Automatic cooking 21 FOUR-FUNCTION SINGLE OVEN MODELS (available in Australia only) Using your oven for the first time 22 Clock, timer and automatic switch-off 23 Cooking functions 24 DOUBLE OVEN MODELS Using the main lower oven for the first time 26 Clock and timer
Streszczenie treści zawartej na stronie nr. 4
2 Safety and warnings Installation WARNING! Electrical Shock Hazard Always disconnect the oven from the mains electricity supply before carrying out any maintenance operations or repairs. Failure to do so may result in death or electrical shock. WARNING! Cut Hazard Take care - panel edges are sharp. Failure to use caution could result in injury or cuts. Important safety precautions To avoid hazard, follow these instructions carefully before installing or using this product. Please make
Streszczenie treści zawartej na stronie nr. 5
3 Safety and warnings The oven will rest on a surface that can support its weight. The benchtop and oven cavity are square and level, and are the required dimensions. The height from the floor suits the user. The oven door can open fully without obstruction. If the supply cord is damaged, it is replaced by the manufacturer, its service agent, or a similarly qualified person in order to avoid a hazard. When you install the oven Do not seal the oven into the cabinetry with silicone
Streszczenie treści zawartej na stronie nr. 6
4 Safety and warnings Operation Your built-in oven has been carefully designed to operate safely during normal cooking procedures. Please keep the following guidelines in mind when you are using your oven: WARNING! Electrical Shock Hazard Switch the oven off at the wall before replacing fuses or the oven lamp. Failure to do so may result in death or electrical shock. WARNING! Hot Surface Hazard Accessible parts may become hot when this oven is in use. To avoid burns and scalds keep c
Streszczenie treści zawartej na stronie nr. 7
5 Safety and warnings Important safety precautions Isolating switch: make sure this oven is connected to a circuit which incorporates an isolating switch providing full disconnection from the power supply. Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use. The instructor should be satisfied that they can use the applianc
Streszczenie treści zawartej na stronie nr. 8
6 Installation instructions I Single oven models I I C E K I J J B L D A 16-20 mm H L F G 2.5 mm Installation diagrams for illustration purposes only Fig. 2 Single product and cabinetry dimensions Product and cabinetry dimensions (mm) A overall height* of product 597 B overall width of product 595 C overall depth of product (excluding handle and knobs) 567 D height of chassis 582 E width of chassis 556 F depth of chassis 545 depth of oven frame and control panel G 22 (=distance between front of
Streszczenie treści zawartej na stronie nr. 9
Tower Double 7 Installation instructions Double and Tower oven models I I I C E B I J J K L A D 16-20 mm H L F G 2.5 mm Fig. 3 Double and Tower product and cabinetry dimensions Product and cabinetry dimensions (mm) A overall height* of product 888 1077 B overall width of product 595 595 C overall depth of product (excluding handle and knobs) 567 567 D height of chassis 874 1057 E width of chassis 556 556 F depth of chassis 545 545 depth of oven frame and control panel G 22 22 (=distance betwee
Streszczenie treści zawartej na stronie nr. 10
8 Air circulation Single oven models OVEN DOOR LOWER TRIM AIR FLOW Fig. 4 Correct and incorrect placement of trim Important: Please take extra care not to damage the lower trim of the oven. The space between the bottom of the door and the lower trim is important for the correct air circulation into the oven. Ensure the oven sits on wooden blocks or similar supports when it is removed from the carton as shown in Fig. 4. This will prevent any damage to the lower trim. After installation, check
Streszczenie treści zawartej na stronie nr. 11
9 Air circulation Double and Tower oven models OVEN DOOR LOWER TRIM AIR FLOW Fig. 5 Correct and incorrect placement of trim Important: Please take extra care not to damage the lower trim of the oven. The space between the bottom of the door and the lower trim is important for the correct air circulation into the oven. Ensure the oven sits on wooden blocks or similar supports when it is removed from the carton as shown in Fig. 5. This will prevent any damage to the lower trim. After installati
Streszczenie treści zawartej na stronie nr. 12
10 Replacing the power supply cable Single oven models 1 Unhook the terminal board cover by inserting a screwdriver into the two hooks “A” (Fig. 7). 2 Open the cable crimp by unscrewing screw “F” (Fig. 8), unscrew the terminal screws and remove the cable. 3 Connect the new supply cable, of suitable type and section, to the terminal board following the diagram in Fig. 6. 230-240 V~ 2350-2550W 230-240 V~ 3095-3370W L1 N(L ) 2 E Fig. 6 F A Fig. 7 Fig. 8 Feeder cable section type HO5RR-F 2 230-
Streszczenie treści zawartej na stronie nr. 13
11 Connecting the power supply cable Double and Tower oven models 1 Unscrew the screw “A” securing the cover plate “B” behind the oven (Fig. 9). 2 Remove the cover plate “B”. 3 Remove the screws “C” from the cable clamp (Fig. 10). 4 Insert the mains cable into the cable protector “P”. Type of cable to be used for double models: type V105 for AU and NZ, type H05RR-F for UK 2 and EU - 3 x 2.5 mm section 230-240 V ~ 4400-4800 W. Type of cable to be used for tower models: type V105 for AU
Streszczenie treści zawartej na stronie nr. 14
12 Wiring diagrams Seven-function single oven NZ AU models S1 S2 TM F1 PR 1 1a 1 1a N/7 2a 2 L/8 3a 3 4a 4 5a 5 6a 6 7a 7 8a 8 9a 9 10a 10 11a 11 LF1 LF2 C CIR TL CF G V S L N M Fig. 11a Seven-function single oven GB IE EU models S1 S2 PR TM F1 1 1a 1 N/7 1a 2a 2 L/8 3a 3 4a 4 5a 5 6a 6 7a 7 8a 8 9a 9 10a 10 11a 11 LF LF1 TL1 C CIR TL CF G V S L N M Fig. 11b T T
Streszczenie treści zawartej na stronie nr. 15
5 2 1 3 4 P3 P1 P2 13 Wiring diagrams Four-function single oven models (available in Australia only) S2 S1 TE F1 PR 1 1a CF N/7 L/8 C LF1 G LF2 S V TL T L N M Fig. 12 Double oven models F2 E1 F1 E2 PR S1 S2 1 N/7 1a P3 5 1a 1 L/8 2 2a 2 P1 1 3a 3 3 4a 4 P2 4 5a 5 6a 6 7a 7 LF2 8a 8 9a 9 10a 10 11a 11 C1 LF G1 S1 LF1 TL1 C CIR TL2 CF G TL3 V S T M L N Fig. 13
Streszczenie treści zawartej na stronie nr. 16
14 Wiring diagrams Tower oven models Fig. 14
Streszczenie treści zawartej na stronie nr. 17
15
Streszczenie treści zawartej na stronie nr. 18
16 Using your oven for the fi rst time Clock display Temperature Function indicator light indicator light Control buttons Function Temperature knob knob Fig. 15 Control panel Before using your new oven, please: 1 Read this user guide, taking special note of the ‘Safety and warnings’ section. 2 Remove all accessories and packaging. 3 Set the clock. The oven will not work until the clock has been set. 4 Condition the oven: Put in the shelves and trays. If you are not using the sliding s
Streszczenie treści zawartej na stronie nr. 19
17 Clock and timer Buttons Timer Cooking time End of cooking time Manual position; and cancels the set program Decreases the number shown on the display or changes the volume of the beeps Increases the number shown on the display Fig. 17 Clock display and control buttons Illuminated symbols AUTO - flashing - oven in automatic position but not set AUTO - steady illumination - oven set for automatic cooking - timer in operation AUTO - flashing and timer beeping
Streszczenie treści zawartej na stronie nr. 20
18 Using your oven Fig. 18 Function knob Fig. 19 Temperature knob 1 Select the function using the function knob. The oven lights will come on. 2 Select the temperature using the temperature control knob. The oven temperature indicator light, above the temperature knob on the control panel, will glow until the oven has reached the set temperature, and then it will go out. When you have finished cooking, turn the function and temperature control knobs to the off O 3 position. Note: pre
