Streszczenie treści zawartej na stronie nr. 1
WIRELESS
300N ADSL2+
MODEM ROUTER
USER MANUAL
MODELS
524780 (ANNEX A),
524797 (ANNEX B)
INT-524780/524797-UM-1109-03
Streszczenie treści zawartej na stronie nr. 2
Federal Communications Commission Interference Statement FCC Part 68 This equipment complies with Part 68 of the FCC Rules. On the bottom of this device is a label that contains the FCC registration number and ringer equivalence number (REN) for this equipment. You must provide this information to the telephone company upon request. The REN is useful to determine the quantity of devices you may connect to the telephone line and still have all of those devices ring when your number
Streszczenie treści zawartej na stronie nr. 3
FCC Part 15 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee t
Streszczenie treści zawartej na stronie nr. 4
during normal operation. The antenna(s) used for this transmitter must not be co- located or operating in conjunction with any other antenna or transmitter. R&TTE Compliance Statement This equipment complies with all the requirements of Directive 1999/5/EC of the European Parliament and the Council of March 9, 1999, on radio equipment and telecommunication terminal Equipment and the mutual recognition of their conformity (R&TTE). The R&TTE Directive repeals and replaces in the directi
Streszczenie treści zawartej na stronie nr. 5
Contents 1 INTRODUCTION..................................................................... 1 2 HARDWARE .......................................................................... 3 3 SETUP WIZARD ..................................................................... 6 3.1 Getting Started ........................................................................................... 6 3.2 Automatically Set the ISP...........................................................................
Streszczenie treści zawartej na stronie nr. 6
5.2.4.2 Advanced Settings ...................................................................... 49 5.2.4.3 Security ....................................................................................... 53 5.2.4.4 Access Control ............................................................................ 55 5.2.4.5 WPS ............................................................................................ 56 5.2.5 QoS...............................................................
Streszczenie treści zawartej na stronie nr. 7
1 Introduction TM Thank you for purchasing this INTELLINET NETWORK SOLUTIONS Wireless 300N ADSL2+ Modem Router, Model 524780 (Annex A) or Model 524797 (Annex B). This is an all-in-one modem, router, Wireless N access point, firewall and Fast Ethernet four-port switch that allows you to access the Internet and download music, play interactive games online or surf the Web at double the speed (depending on operating environment and distance between networked devices) previously avail
Streszczenie treści zawartej na stronie nr. 8
Minimum Requirements • A PC with pre-installed Ethernet adapter (required) and a Web browser (Internet Explorer 4.0 or higher) • RJ45 Ethernet crossover cable (included in the package) • RJ11 (ADSL-ready) phone line Package Contents • ADSL 2+ Router (Annex A or B) • Power adapter • Ethernet Cat5 RJ45 cable, 1.0 m (3 ft.) • RJ11 telephone cable, 1.8 m (5.9 ft.) • Quick installation guide • Setup CD with user manual 2
Streszczenie treści zawartej na stronie nr. 9
2 Hardware Rear Panel Antenna A Antenna B Item Name Description Antenna A/B These antennas are 3dBi dipole antennas. Radio Position the switch to activate or deactivate the wireless ON/OFF functions. Reset / WPS Reset the router to factory default settings (clear all settings) or start the WPS function. Press this button and hold for 10 seconds to restore all settings to factory defaults; press this button for less than 5 seconds to start the WPS function. 1 - 4 The router’s 4
Streszczenie treści zawartej na stronie nr. 10
Front Panel On the router’s front panel, there are LEDs that inform you of the router’s current status, as explained below. LED Status Description POWER (Green) On Router is switched on and correctly powered. WLAN (Yellow) On Wireless LAN WPS is on. Off Wireless LAN is disabled. Blinking Wireless traffic is transmitting or receiving. ADSL (Green) On Connected to an ADSL DSLAN successfully. Blinking ADSL line is not connected to Internet. The LAN cable is connected
Streszczenie treści zawartej na stronie nr. 11
Installation 1. Connect the router to your ADSL cable through the supplied RJ11 cable. 2. Connect the router to your PC, hub or switch by attaching the Ethernet cable to the LAN port of the router. 3. Connect the power adapter to the power jack on the rear panel of the router. 4. The ADSL LED will be on if the router is connected to the ADSL cable and receives the ADSL signals successfully. If the LED is blinking, contact your ISP (Internet service provider) to check the pr
Streszczenie treści zawartej na stronie nr. 12
3 Setup Wizard This router provides a Setup Wizard tool to configure the ADSL settings. This wizard collects some ISPs’ ADSL settings so that you can easily configure the router’s ADSL settings by only selecting the ISP vendor from the wizard. If you cannot find your ISP from the list in the wizard, manually set the ISP information through the wizard. 3.1 Getting Started Before starting, check the following items: 1. Make sure that you have connected the ADSL cable to the router corr
Streszczenie treści zawartej na stronie nr. 13
3. The wizard will run and try to search for the router. If the router is found, the wizard will guide you to Step 5. 7
Streszczenie treści zawartej na stronie nr. 14
4. If the router cannot be found, enter the IP address and the password of the router to search again. Click “Next” to continue. 5. The wizard will automatically select the country you are in by checking the language of the operating system in your computer and then advance to the Select ISP screen. Select the ISP. If you cannot find the ISP, click “Other” to reselect the country or manually configure the ISP information. 8
Streszczenie treści zawartej na stronie nr. 15
3.2 Automatically Set the ISP If you can find the ISP from the wizard, follow the procedures below to let the wizard set the ISP settings automatically. 1. Select the ISP of your ADSL service. 2. Enter the username and password that your ISP has provided to you, if needed. Click “Next.” 9
Streszczenie treści zawartej na stronie nr. 16
3. Click “Save” to save the settings and reboot the router. 4. After saving and rebooting the router, the ISP settings are completed. The wizard will then help to set your computer to obtain an IP address from the router automatically. NOTE 1: To use the router to access the Internet, the IP address of each PC needs to be set in the same network segment as the router. The wizard will help to set the proper IP address for your computer. NOTE 2: By default, the router’s DHCP server is en
Streszczenie treści zawartej na stronie nr. 17
5. The wizard will try to connect to the ISP you have selected. If the connection fails, run the wizard to select the ISP again. 6. If you successfully connect to the ISP, you will see the screen below. To configure additional settings, click “Advanced Settings” to go the Web management of the router, or click “Finish” to close the wizard. 11
Streszczenie treści zawartej na stronie nr. 18
5.3 Manually Set the ISP If you cannot find the ISP from the wizard, follow the steps below to set the ISP settings manually. Before configuring the ISP manually, check with your ISP (Internet service provider) as to what kind of service is provided, such as PPPoE, PPPoA or RFC1483/2684. Gather the information as illustrated in the following table and keep it for reference. PPPoE VPI/VCI, VC-based/LLC-based multiplexing, Username, Password (and Service Name). PPPoA VPI/VCI, VC-based/
Streszczenie treści zawartej na stronie nr. 19
2. Check with your ISP as to the connection type of the ADSL line. Select the Connection Type and click “Next.” 3. Input the VPI, VCI and encapsulation data supplied by your ISP. If the Connection Type is “Static IP Address,” you need to input the IP address information supplied by your ISP. For details about each setting, refer to Section 5.2. 13
Streszczenie treści zawartej na stronie nr. 20
4. Enter the username and password that your ISP has provided to you, if needed. Click “Next.” 5. Click “Save” to save the settings and reboot the router. 6. After saving and rebooting the router, the ISP settings are completed. The wizard will then help to set your computer to obtain an IP address from the 14
