Streszczenie treści zawartej na stronie nr. 1
D-Link DFL-600
Firewall/VPN
Manual
Rev. 4.0
Building Networks for People
Streszczenie treści zawartej na stronie nr. 2
Table of Contents Introduction......................................................... 4 IP Address Settings and Computer Settings ...... 8 Introduction and Overview.................................. 9 Using the Configuration Utility ............................ 12 Setup Wizard...................................................... 14 Home .................................................................. 20 WAN Settings ..................................................... 21 LAN Settin
Streszczenie treści zawartej na stronie nr. 3
Package Contents Contents of Package: • D-Link DFL-600 Firewall/VPN Router • Manual • Quick Installation Guide • Power Adapter, 5V DC, 2.5A* • CAT-5 UTP Cable If any of the above items are missing, please contact your reseller. *Using a power supply with a different voltage rating will damage the product and void the warranty. System Requirements: Internet Explorer 5.5 or higher or Netscape Navigator 7.1 or higher, with JavaScript enabled. One computer with an instal
Streszczenie treści zawartej na stronie nr. 4
Introduction The D-Link DFL-600 VPN Router enables your network to connect to the Internet via a secure, private connection using a Cable or DSL modem. The Virtual Private Network (VPN) that is created on the Internet between your home and a VPN server in your office is secure from interference when you use the DFL-600. It is an ideal way to connect your computer to a Local Area Network (LAN). After completing the steps outlined in the Quick Install Guide (included in your package) y
Streszczenie treści zawartej na stronie nr. 5
Front View LED Indicators WAN (Green) Green LED will LIGHT when a good link is Link/Act. established. Green LED will BLINK when packet is transmitting or receiving (Act.). WAN 10/100 (Green) Green LED will LIGHT when a 100 Mbps Link is established. Green LED will NOT LIGHT when a 10 Mbps Link is established. DMZ (Green) Green LED will LIGHT when a good link is Link/Act. established. Green LED will BLINK when packet is transmitting or receiving (Act.). DMZ 10/100 (Green) Green LED
Streszczenie treści zawartej na stronie nr. 6
Rearview Power (5V Connects the DC power adapter to the Power port 2.5A DC) WAN Connects DSL/Cable modem to the WAN Ethernet port Ports 1-3 Connect networked devices such as computers and ftp servers to the three LAN ports. All LAN ports support auto crossover. DMZ Connects a networked device to the DMZ zone of the Firewall/VPN Router. The DMZ feature can be disabled. Reset To reload the factory default settings, press the reset button. Pressing the Reset button will clear the c
Streszczenie treści zawartej na stronie nr. 7
Firewall Protection Supports general hacker attack pattern monitoring and logging. PPPoE Client Supports PPPoE client function to connect to a remote PPPoE server. Virtual Server Allows the internal server to be accessible from the Internet Upgradeable New Features Allows new features to be added in the future High Performance 64 bit RISC CPU Engine With the most advanced 64 bit R
Streszczenie treści zawartej na stronie nr. 8
IP Address Settings and Computer Settings In order to install the DFL-600 you will need to check your computer’s settings and the values from your ISP. The information offered by your ISP: • Dynamic IP settings • Your fixed IP address for the gateway • Your subnet mask for the gateway • Your default gateway IP address • Your DNS IP address If you would like to use PPPoE, you will need the following values from your ISP in order to install your router: • User Name • Password
Streszczenie treści zawartej na stronie nr. 9
Introduction and Overview The DFL-600 Firewall/VPN Router creates two separate networks on the LAN side of your network − by default, a 192.168.0.0 subnet and a 192.168.1.0 subnet (both with a subnet mask of 255.255.255.0). The DFL- 600 routes packets between these two subnets and the Internet (or the network connected to the DFL-600’s WAN port). An Internet Service Provider (ISP) or a network administrator provides the network address information on the WAN network. The 192.168.0.0 n
Streszczenie treści zawartej na stronie nr. 10
The DMZ port is used to allow computers and devices connected to this port to have more direct access to the Internet. This is useful for certain applications that may conflict with the firewall and Network Address Translation (NAT) features of the DFL-600. Computers and devices connected to the DMZ port will not have the level of protection that the LAN ports can provide, however. It is recommended that computers and devices connected to the DFL-600’s DMZ port have some type of firewal
Streszczenie treści zawartej na stronie nr. 11
address, subnet mask, default gateway address, and primary and (optional) secondary DNS addresses. This information will be provided by your ISP. Point-to-Point Protocol over Ethernet (PPPoE) − this protocol requires the use of a Username and Password to gain access to the network. In addition, you can specify a Connect on Demand connection that will connect to the Internet only when a computer or device on your LAN makes a request, or when the DFL-600 is rebooted. If you do not kno
Streszczenie treści zawartej na stronie nr. 12
Using the Configuration Utility Launch your web browser and type the device IP address (https:// 192.168.0.1) in the browser’s address box. This is the default IP address of your DFL-600. Press Enter. The following dialog-box will appear to prompt you to enter the DFL-600’s default User Name and Password. The DFL-600’s default User Name is admin and the default Password is also admin − all lower case. Click OK to open the Home menu. Note: Please make sure that the computer
Streszczenie treści zawartej na stronie nr. 13
The Setup Wizard will guide you the most basic setup tasks, such as setting an administrative password, selecting the type of WAN connection you have, entering your computer’s host name (if required by your ISP), saving the configuration and restarting the router. All other setup tasks can be accomplished using the configuration utility from your web browser. To use the Setup Wizard, click on the Run Setup Wizard link. This will start the Setup Wizard.
Streszczenie treści zawartej na stronie nr. 14
Setup Wizard The Setup Wizard will guide you through the most basic setup tasks for the DFL-600. All other configuration tasks can be accomplished through the web-based manager. The Home menu contains a Run Setup Wizard link. Click on this button to run the Setup Wizard. Click Next to continue.
Streszczenie treści zawartej na stronie nr. 15
Enter a password in the Password field, and again in the Verify Password field. This will become the logon password for the DFL-600. This password is case-sensitive, so remember to use capital letters when logging on to the DFL-600’s web-based manager − if you enter a password with capital letters here. The user name, admin, will not be changed here. Note: If you choose to input a password, please remember it. If you lose your password, you will have to manually reset the unit (u
Streszczenie treści zawartej na stronie nr. 16
This menu allows you to select the type of connection your ISP provides. Many ISPs use the PPPoE (Point-to-Point Protocol over Ethernet) for DSL connections, while many Cable ISPs use DHCP (Dynamic Host Configuration Protocol). DHCP assigns an IP address for your Internet connection each time you log on (and is therefore, a dynamic IP address). DHCP is referred to as Dynamic IP address on the DFL-600. The Setup Wizard will open a page with the appropriate fields for the entry of yo
Streszczenie treści zawartej na stronie nr. 17
Some ISPs require you to use an assigned host name for your Internet connection. If your ISP requires this, you can enter the assigned host name in the Host Name field. If you selected Static IP Address on the Select Internet Connection Type (WAN) wizard screen above, the following screen will open: This screen will allow you to enter the static IP address information, if your ISP has assigned a static IP address to your Internet account. Your ISP must provide this information.
Streszczenie treści zawartej na stronie nr. 18
This screen will allow you to enter the PPPoE information, if your ISP uses the PPPoE protocol for your Internet account. Your ISP must provide this information. Click Next to continue.
Streszczenie treści zawartej na stronie nr. 19
You have completed the basic setup Wizard. The configuration now needs to be entered into the DFL-600’s non-volatile RAM. Clicking Restart will save the configuration to non-volatile RAM and restart the router.
Streszczenie treści zawartej na stronie nr. 20
Home The Home menu contains links to all of the setup menus for the DFL-600. Click on the WAN button:
