Instrukcja obsługi Seiko Group UB-R02

Streszczenie treści zawartej na stronie nr. 1

UB-R02 User’s Manual
410462701

Copyright © Seiko Epson Corporation 2004
Printed in China 2004.01
Introduction
The UB-R02 is an interface board on which is installed an IEEE 802.11b Radio
®
Frequency (RF) module for EPSON TM printers.
This manual provides instructions, including a simple setup for operators of
POS systems in which the UB-R02 is installed so that the operators can use the
UB-R02 safely and correctly.
Key to Symbol
The symbol in this manual is identified by its level of impo

Streszczenie treści zawartej na stronie nr. 2

How to Set Up the UB-R02 Preparation Printing a Status Sheet Power on the printer. Wait for a few seconds. Then, hold down the push button on the interface card for more than 3 seconds. The printer prints the parameters for the UB-R02. You can check all setting values necessary (SSID, Network mode, IP address, Subnet mask, Gateway address) for the network connection. Connection Set the setting of the host PC and AP to match the network setting that you have confirmed with the status sheet.

Streszczenie treści zawartej na stronie nr. 3

EMC Standards Applied Product Name: UB-R02 Model Name: M195A The following standards are applied only to the interface boards that are so labeled. (EMC is tested using the EPSON power supplies and TM series printers.) Europe: CE marking North America: EMI:FCC/ICES-003 Class A Oceania: EMC:AS/NZS 3548, CISPR22 Class B WARNING You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the equipment. CE Marking The prin

Streszczenie treści zawartej na stronie nr. 4

-Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.