Instrukcja obsługi Renesas R8C/2

Streszczenie treści zawartej na stronie nr. 1

Renesas Starter Kit for R8C/25
Quick Start



LCD module


Application Board Interface
Reset switch E8 header
LCD module
connector
LIN connector

E8 emulator

Application Board Interface
User LEDs

Analog adjust



User switches

Streszczenie treści zawartej na stronie nr. 2

1. Installation Do not connect the E8 emulator hardware until the software support has been installed. 1. Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If the installer does not start, browse to the RSK directory from the CD root folder and double click on “setup.exe”. 2. The software license agreement will be displayed. Please select the appropriate radio button and click to continue. 3. Select the software components t

Streszczenie treści zawartej na stronie nr. 3

4. HEW Workspace HEW integrates various tools such as compiler, assembler, debugger and editor into a common graphical user interface. To learn more on how to user HEW, open the HEW manual installed on your computer (Start Menu > All Programs > Renesas > High-performance Embedded Workshop > Manual Navigator). 13. Launch HEW from the Start Menu. (Start Menu > All Programs > Renesas > High-performance Embedded Workshop > High-performance Embedded Workshop) 14. In the “Welcome” dialog box:

Streszczenie treści zawartej na stronie nr. 4

27. The first time the E8 is used the following dialog appears: Otherwise skip to step 31. 28. Click . 29. Select “Renesas E-Series USB Driver”. Select “USB Interface”. The channel number will vary. 30. Click . 31. Accept any dialogue warning that an older version of E8 firmware is necessary to work with the application. Allow download of firmware to complete, this may take several seconds. 32. Select “Power supply is carried out” if the E8 is to provide the power to the

Streszczenie treści zawartej na stronie nr. 5

35. Right click on the download module listed in the left hand pane and select “Download module”. The code will be downloaded to the microcontroller. This may take several seconds. 36. Click the button. The code will run and you will see the LEDs flash on the board. 37. Click the button. The code will stop and the source code will be opened at the current program counter. 6. Next Step After you have completed this quick start procedure, please review the tuto