Streszczenie treści zawartej na stronie nr. 1
890-010 12/04/98 © 1998 RadioLAN. All rights Reserved
DockLINK User Guide
Wireless Local Area Network
Streszczenie treści zawartej na stronie nr. 2
FCC This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
Streszczenie treści zawartej na stronie nr. 3
MCIPUNIIT FCC Rule Part(s): Frequency (MHz): 5775, 5200, 5300 Equipment Class Low Power Communication Device Transmitter Remarks: Maximum Output Power: 50 mW Notes: This device has shown compliance with new rules adopted under Docket 87-389 and is not affected by Section 15.37, transition rule. Each radio is marked with its operating frequency. 890-010 12/04/98 Page iii © 1998 RadioLAN. 15 FCCID:
Streszczenie treści zawartej na stronie nr. 4
The instructions in this document have been carefully checked for accuracy and are presumed to be reliable. RadioLAN and its writers assume no responsibility for inaccuracies and reserve the right to modify and revise this document without notice. It is always our goal at RadioLAN to supply accurate and reliable documentation . If you discover a discrepancy in this document, please e-mail your comments or suggested corrections to marketing@radiolan.com . No part of this publication may be placed
Streszczenie treści zawartej na stronie nr. 5
Trademark Disclosures RadioLAN has made every effort to provide disclosures when using trademarks owned by other companies. Trademarked designations appear throughout this publication. The publisher states that it is using the designations only for editorial purposes, and to the benefit of the trademark owner with no intent to infringe upon that trademark. The following trademarks are found in this manual: Microsoft™, and Windows for Workgroups™, and Windows 95™, Microsoft Internet Explorer™ and
Streszczenie treści zawartej na stronie nr. 6
Notices ................................ ................................ ................................ ................................ ................................ ........ ii Disclaimer ................................ ................................ ................................ ................................ .............................. Trademark Disclosures ................................ ................................ ................................ ....................
Streszczenie treści zawartej na stronie nr. 7
Logging Onto the DockLINK Manager ................................ ................................ ................................ ..................... DockLINK Manager Layout ................................ ................................ ................................ ................................ ..... Discovering Wireless Nodes Within the DockLINK’s Data Range ................................ ................................ .............. Setting Up Security Features .............
Streszczenie treści zawartej na stronie nr. 8
Troubleshooting 85 87 Access Point ................................ ................................ ................................ ................................ ......................... 91 Indicators ................................ ................................ ................................ ................................ .............................. MDI/MDI-X switch ................................ ................................ ................................ ..............
Streszczenie treści zawartej na stronie nr. 9
Welcome to the next generation of RadioLAN wireless network products. The DockLINK is a module, which connects to a 10BaseT Network device, such as a PC, workstation, or printer, allowing interaction with RadioLAN wireless network resources. The DockLINK includes a Radio Unit , a RJ-45 jack for connection to an Ethernet Hub, a power jack, and a special RJ11 serial port for connecting the DockLINK to a VT-100 terminal or modem. There are two versions of the DockLINK: Model 408 for US Installation
Streszczenie treści zawartej na stronie nr. 10
Transform a 10BaseT Network Node into a Wireless Network Station The primary use of the DockLINK is to transform a typical hard-wired 10BaseT Network Interface Card into a wireless network station . This allows the station to access and share network resources such as printers, modems, and servers. When you use the DockLINK in the Dock Mode , you can Interface PC connect the DockLINK to any device containing a 10BaseT Ethernet Network Interface Card to transform your standard Network Interfac
Streszczenie treści zawartej na stronie nr. 11
Designed for Simplicity The DockLINK is designed to be installed and set up quickly. If you require no more than basic management of packet flow , you can simply install the DockLINK and begin using its powerful network access capabilities. In circumstances like these, there is no need for custom configuration. By default, the DockLINK filters all data packets that are not intended for wireless nodes, providing the most efficient wireless network operation. If your network falls into this catego
Streszczenie treści zawartej na stronie nr. 12
Local Management The DockLINK includes a built-in serial port for connecting a VT-100 terminal or a modem . Using a terminal allows you serial access configuration and system performance pages. Connecting a modem to the Serial port allows you to dial into the DockLINK from a remote location to log in and configure or view system performance. System Requirements To successfully place a DockLINK into operation, you must meet the following requirements: • The DockLINK must connect directly to a 10B
Streszczenie treści zawartej na stronie nr. 13
The RadioLAN DockLINK easily d attaches to your 10BaseT equipment and puts it onto the wireless network. t Like other RadioLAN products, the DockLINK is easy to install in just a d few steps. 4 1. Locate the DockLINK near to the 1 10BaseT device, like the printer in K Figure 3 . T 3 2. Attach an Ethernet cable between the DockLINK 10BaseT port and 2 the device d 3. Attach the radio assembly, and t locate it as high as practical, with the two points upward Figure 3 : Quick Installation Steps 4.
Streszczenie treści zawartej na stronie nr. 14
Installation of the DockLINK does not require the use of tools, and no configuration is needed in the DockLINK for operation. If your site uses RadioLAN SubNet ID codes, or encryption, then the DockLINK will need to be configured before operation. If you sense the DockLINK connected device is not operating properly, you may need to review the location of the antenna. This can be done either using the DockLINK Manager display to show the signal quality, or with a RadioLAN equipped computer in the
Streszczenie treści zawartej na stronie nr. 15
This section describes the best ways to locate one or more DockLINKs, and to orient the DockLINK’s Radio Unit. For best performance, orient the DockLINK’s Radio Unit perpendicular to the horizon. Because signal strength and quality diminish when the Radio Unit is enclosed , it is best to locate the Radio Unit outside of cabinets. The most suitable locations are above obstacles such as cubical walls or shelves. For the highest quality wireless network coverage, spacing between DockLINKs and other
Streszczenie treści zawartej na stronie nr. 16
Testing the Data Range Signal Quality To test for best signal quality , locate a temporary wireless 2 station in the location at which you intend to locate the n DockLINK. Use the N D at each wireless station on the network to verify signal quality. Also test locations 3 where fixed wireless stations are not normally located, such as conference rooms. 4 As you test each location, note the signal strength measured on the N ODE D page (see Figure 4 ). In the event that you 54321 discover a locatio
Streszczenie treści zawartej na stronie nr. 17
Distant Wireless Users PCMCIA Users Before installing the DockLINK, note the DockLINK’s Media Access Control (MAC) Address . Each DockLINK’s MAC Address is noted on the bottom of the DockLINK’s housing. There are three basic inputs required by the Radio Unit DockLINK (see Figure 5 ): Switched Outlet • Non-switched electrical outlet • Access to the 10BaseT Network Interface Card • Acceptable signal quality in the wireless network Non-switched Outlet Local Station with 10BaseT Network Interface
Streszczenie treści zawartej na stronie nr. 18
RadioLAN Radio Units include a dual antenna assembly . The antenna assembly operates best if oriented perpendicular to the horizon (see Figure 6 ). Failing to orient the antenna in this vertical orientation will diminish signal quality between the DockLINK and all wireless stations that communicate with it. You can locate the DockLINK assembly on the desk next to your PC, Good or when using a longer Category 5 cable, you can mount the assembly on a wall, or ceiling. Do this: • Point the Radio Un
Streszczenie treści zawartej na stronie nr. 19
Connecting the DockLINK You must connect the DockLINK to the station’s 10BaseT Network Interface Card and to the power . Optionally, you can also connect a modem or VT-100 terminal to the DockLINK for local configuration. Follow these steps to connect external cabling to the DockLINK: Local Station’s Network Interface Card 1 1. Connect the radio to the female DB15 jack on the DockLINK. The radio’s connector is keyed, and only inserts into the jack one way. Do not 3 force the connector into the
Streszczenie treści zawartej na stronie nr. 20
4. Route a standard RJ-45 cable between the station’s10BaseT Network Interface Card and the 10BaseT jack on the DockLINK. Connect the cable to the DockLINK first, and then connect the other end of the cable to the port on the e station’s Network Interface Card. 1 5. Set the MDI/MDI-X push-button switch to the correct setting for the RJ-45 Dual- modular cable. 3 2 Push the switch in for use with a crossover cable. Push the switch out for use with a standard Category 5 cable. Figure 8 : Setting
