Instrukcja obsługi Paradyne Uplink Interface Module UIM-10/100

Streszczenie treści zawartej na stronie nr. 1

Installation Instructions
UIM-10/100
Uplink Interface Module
Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when
CAUTION
handling this equipment.
INSTALLATION
1. Unpack and inspect the equipment.
The following components should be included:
! 1 UIM-10/100
! 4 #6 Phillips Panhead Internal Locking Screws
! 2 #6 Phillips Beige Flathead Screws
If there is visible damage, do not attempt to connect the device; contact Customer Support at 1

Streszczenie treści zawartej na stronie nr. 2

c. Remove the blanking plate* from the selected port. d. Carefully slide the faceplate of the UIM under the lip of the MUM faceplate at the selected port opening such that the UIM circuit board is facedown and the UIM label shows through the port opening with the model name along the right-hand edge. e. Ensure the mounting holes on the UIM are lined up with the corresponding pems on the MUM and the board-to-board connector key pins are properly aligned. f. Gently press down with even press

Streszczenie treści zawartej na stronie nr. 3

c. Remove the blanking plate* from the selected port. d. Carefully slide the faceplate of the UIM under the inside lip of the Mini DSLAM at the selected port opening such that the UIM circuit board is facedown and the UIM label shows through the port opening with the model name along the right-hand edge. e. Ensure the mounting holes on the UIM are lined up with the corresponding pems on the Mini DSLAM board and the board-to-board connector key pins are properly aligned. f. Gently press dow

Streszczenie treści zawartej na stronie nr. 4

Additional Information LED Indicators LED State Indication Additional Information 100 solid green Fast Ethernet connection If the 100 LED is illuminated, the Lnk LED will also be illuminated. (100 Mbps) is established no no Fast Ethernet If the 100 LED remains unlit but the Lnk LED is illuminated then a link has illumination connection been established at 10 Mbps rather than 100 Mbps. Act flashing Ethernet activity Traffic is flowing without any problems. amber solid amber heavy traffic no no

Streszczenie treści zawartej na stronie nr. 5

European Regulatory Compliance Information for Class A Equipment This Class A product complies with European Norm EN55022. Warning: In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures to correct the situation. 220-0000016 rev01 © Copyright 2001 Net to Net Technologies, Inc. ™ The Net to Net Logo is a trademark of Net to Net Technologies, Inc. http://www.NetToNet.com/ Worldwide Headquarters EMEA Headquarters Con