Streszczenie treści zawartej na stronie nr. 1
4929 DSLAM
Installation and User’s Guide
Document No. 4929-A2-GN20-00
March 2005
Streszczenie treści zawartej na stronie nr. 2
Copyright © 2005 Paradyne Corporation. All rights reserved. Printed in U.S.A. Notice This publication is protected by federal copyright law. No part of this publication may be copied or distributed, transmitted, transcribed, stored in a retrieval system, or translated into any human or computer language in any form or by any means, electronic, mechanical, magnetic, manual or otherwise, or disclosed to third parties without the express written permission of Paradyne Corporation, 8545 126th Ave
Streszczenie treści zawartej na stronie nr. 3
Software and Firmware License Agreement ONCE YOU HAVE READ THIS LICENSE AGREEMENT AND AGREE TO ITS TERMS, YOU MAY USE THE SOFTWARE AND/OR FIRMWARE INCORPORATED INTO THE PARADYNE PRODUCT. BY USING THE PARADYNE PRODUCT YOU SHOW YOUR ACCEPTANCE OF THE TERMS OF THIS LICENSE AGREEMENT. IN THE EVENT THAT YOU DO NOT AGREE WITH ANY OF THE TERMS OF THIS LICENSE AGREEMENT, PROMPTLY RETURN THE UNUSED PRODUCT IN ITS ORIGINAL PACKAGING AND YOUR SALES RECEIPT OR INVOICE TO THE LOCATION WHERE YOU OBTAINED THE
Streszczenie treści zawartej na stronie nr. 4
! Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. This product is to be connected to a nominal –48 to –60 VDC supply source that is electrically isolated from the AC source using minimum 18 AWG (0.75mm² ) leads . Two inputs are provided for redundancy. The positive terminal of the DC source is to be reliably connected to earth. Connect a minimum 18 AWG (0.75mm² ) green/yellow earthing (grounding) wire t
Streszczenie treści zawartej na stronie nr. 5
13. In addition, if the equipment is to be used with telecommunications circuits, take the following precautions: — Never install telephone wiring during a lightning storm. — Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. — Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. — Use caution when installing or modifying telephone lines. — Avoid using a telephone (o
Streszczenie treści zawartej na stronie nr. 6
EMI Notices ! UNITED STATES – EMI NOTICE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interfer
Streszczenie treści zawartej na stronie nr. 7
Contents Software and Firmware License Agreement . . . . . . . . . . . . . . . . . . . . B About This Guide Document Purpose and Intended Audience . . . . . . . . . . . . . . . . . . . . v Document Summary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . v Related Product Documents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . vi 1 Introduction Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 8
Contents 4LEDs LED Locations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1 LED Meanings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1 5 Configuration Using the NMS Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1 Web Interface System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . 5-1 Configuring Your Windows PC to Communicate with
Streszczenie treści zawartej na stronie nr. 9
Contents Logging Into the CLI. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-2 CLI Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-2 Using the CLI to Establish Inband Management . . . . . . . . . . . . . . . . . 6-5 7 SNMP Interface Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-1 Downloading MIBs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Streszczenie treści zawartej na stronie nr. 10
Contents iv March 2005 4929-A2-GN20-00
Streszczenie treści zawartej na stronie nr. 11
About This Guide Document Purpose and Intended Audience This document is written for technicians who install the 4929 DSLAM. Document Summary Section Description Chapter 1, Introduction Describes the 4929 DSLAM. Chapter 2, Installation Describes the physical installation of the 4929 DSLAM into a rack. Chapter 3, Cabling Describes how to install all cables for the 4929 DSLAM. Chapter 4, LEDs Explains the meaning and usage of the front panel LEDs. Chapter 5, Configuration Describes the configura
Streszczenie treści zawartej na stronie nr. 12
About This Guide Related Product Documents Documentation for the Paradyne products is available on the World Wide Web at www.paradyne.com. Select Support → Technical Manuals. Document Number Document Title MIM1-A2-GZ40 MIM-10/100 Installation Instructions Describes how to install the MIM-10/100 Micro Interface Module. MIM2-A2-GZ40 MIM-2E1 Installation Instructions Describes how to install the MIM-2E1 Micro Interface Module. MIM2-A2-GZ41 MIM-2T1 Installation Instructions Describes how to insta
Streszczenie treści zawartej na stronie nr. 13
Introduction 1 Overview Paradyne's 4900 Series DSLAMs are ADSL ITU G.992.5 compliant IP DSLAMs. They are available with or without internal POTS splitters.
The 4900 Series DSLAMs are Ethernet based, environmentally hardened, and small enough to fit in even crowded Remote Terminal cabinets. The 4900 Series DSLAMs support I
Streszczenie treści zawartej na stronie nr. 14
1. Introduction Compliant to ETSI 300-119-1-3 Environmental Requirements MTM for enhanced security and prioritization Embedded web-based management system for easy, platform-independent remote management, and SNMP for remote monitoring IGMP snooping for multicast video support Available with integral 600 Ohm POTS splitters, 900 Ohm POTS, or ISDN splitters 1-2 March 2005 4929-A2-GN20-00
Streszczenie treści zawartej na stronie nr. 15
Installation 2 Preparation Consider the following before installing the DSLAM: Installation Site – Your installation site should be well ventilated, clean, and free of environmental extremes. Installation Options – The DSLAM may be: — Mounted with the included mounting brackets in a standard 19-inch (483 mm) or 23-inch (584 mm) rack (including both Bay Networks and Nortel 23-inch racks), or, with separately purchased mounting brackets, in a 21-inch (535 mm) ETSI rack. ETSI brackets are a
Streszczenie treści zawartej na stronie nr. 16
2. Installation Table 2-1. Cable Descriptions Connector Name or MIM Connector and Cable For Connecting . . . ADSL2+ 50-pin RJ21X Telco-type Up to 24 DSL ports to a Main straight connector and 50-wire Distribution Frame, punchdown cable. Up to two cables block, or splitters. POTS required: one for DSL and one Up to 24 POTS splitter ports to for POTS (if POTS splitters are Main Distribution Frame or installed). punchdown block. SFP GigE SFP transceiver and A 4900 Series DSLAM to an cabl
Streszczenie treści zawartej na stronie nr. 17
2. Installation Unpacking the Hardware HANDLING PRECAUTIONS FOR ! STATIC-SENSITIVE DEVICES This product is designed to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performing installation procedures, however, take proper static control precautions to prevent damage to equipment. If you are not sure of the proper static control precautions, contact your nearest sales or service representative. The DSLAM is shipped in a cardboar
Streszczenie treści zawartej na stronie nr. 18
2. Installation Installing the Brackets for Rack Mounting The 4900 DSLAM can be installed in a rack using mounting brackets. Two brackets suitable for a 19-inch (483 mm) rack and two brackets suitable for a 23-inch (584 mm) Bay Networks or Nortel rack are shipped with the unit. Procedure To install the mounting brackets for rack mounting: 1. Identify eight flat-head screws provided with the mounting brackets. 2. Attach the brackets appropriate to your rack size. Tighten all screws firmly.
Streszczenie treści zawartej na stronie nr. 19
2. Installation Installing the DSLAM Into a Rack Use: #10-32 mounting screws for rails with threaded screw holes #12-24 mounting screws and self-retaining nuts for rails with unthreaded screw holes Procedure To install the DSLAM into a rack: 1. Determine where in the rack you will mount the DSLAM. If your rack does not have threaded screw holes, slip self-retaining nuts onto the rails where the DSLAM will be fastened. 02-17070 2. Place the unit so that the brackets rest against the front
Streszczenie treści zawartej na stronie nr. 20
2. Installation 3. Insert and tighten the screws in the top screw positions, then tighten the bottom screws. 2-6 March 2005 4929-A2-GN20-00
