Streszczenie treści zawartej na stronie nr. 1
WEB card
AW- P
Before attempting to connect, operate or adjust this product, please read these instructions
completely.
RST RDY
LINK/RX
RS232C 10BASE–T
Streszczenie treści zawartej na stronie nr. 2
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation po
Streszczenie treści zawartej na stronie nr. 3
Contents Introduction ....................................................................................................... 3 Precautions for use .......................................................................................... 3 Before use ......................................................................................................... 4 Parts and their functions.................................................................................. 4 Installation .................
Streszczenie treści zawartej na stronie nr. 4
Before use Since the WEB card is a device which is connected to a network, read through the following points to ensure proper use. 1) The image updating interval is not a fixed one. ≥JPEG compression is implemented for the camera images at fixed intervals but the image updating interval as seen from the terminal end via the network varies from one status to another. ≥If the network is congested, the image updating interval is lengthened. ≥Depending on the differences in the subjects, too, the fi
Streszczenie treści zawartej na stronie nr. 5
Installation Ask your dealer to install the card in the camera. Bear in mind the following points when installing the card. ≥ Be absolutely sure to ask your dealer to install the card. ≥ Before installing the card, disconnect the camera’s power supply. ≥ Before handling the card, touch a metal part of the camera to release any static stored in the body. Wearing anti-static wrist straps is even safer. Touching the card without first releasing this static may cause malfunctioning. ≥ Do not allow t
Streszczenie treści zawartej na stronie nr. 6
System upgrading [1] Connections An example of the basic connections is presented below. HUB Install the WEB card (AW-PB309) in the convertible camera. 10Base-T UTP-5 cable (max. 100 m) O I AW-PS505 Windows PC Windows PC AC adapter [2] Recommended system ≥An adequate picture tracing performance will requirements not be achieved if the PC’s performance is too 1) Personal computer low. ≥It may not be possible to achieve the prescribed Provide a Windows-compatible personal performance or
Streszczenie treści zawartej na stronie nr. 7
System upgrading The screen here shows what appears when Windows ME is used as the operating system. 1 Right click on the desktop’s My Network 2 Select “TCP/IP” under the Network Settings icon, and open Properties. tab, and click the Properties button. 3 Now set the IP address and net mask. IP address: 192.168.1.100 Net mask : 255.255.255.0 After inputting the addresses, click “OK,” and restart the PC. [4] Setting the WEB card’s IP address The following addresses were set in the WEB card before
Streszczenie treści zawartej na stronie nr. 8
System upgrading 1. Start up the browser. 2. Input the following address into the browser. http://192.168.1.50/config/config.html 3. A setting screen such as the one shown in the figure below now appears. Input the addresses. 4. Upon completion of the input, press the Submit Query button at the bottom of the setting screen. The new IP address is set when the settings completed screen has appeared. [5] Re-setting the PC’s address The WEB card’s IP address and other settings are completed with th
Streszczenie treści zawartej na stronie nr. 9
Image display method Start up the browser, and input the address. http://(new IP address setting)/user/pb309.html Images can be displayed when the following address is input in the factory setting status. http://192.168.1.50/user/pb309.html When this address is input, an image such as the one shown in Fig. 1 appears. (The image is a sample.) HIGH is set for the image quality and VGA (640 a 480) is set for the size in the initial status. To change the image quality or size, click the button under
Streszczenie treści zawartej na stronie nr. 10
Config screen A number of different settings can be performed on the Config screen. 1. Start up the browser. 2. Input the following address into the browser. http://(new IP address setting)/config/config.html The following address is used in the factory setting status: http://192.168.1.50/config/config.html 3. A setting screen such as the one shown in the figure now appears. 1 2 3 4 10
Streszczenie treści zawartej na stronie nr. 11
Config screen 1Network Set the IP address, net mask and gateway address in the fields provided here. Consult your network administrator for details on the addresses. After setting the information, you must click the Submit Query 4 button. Bear in mind that the settings will not take effect unless this button is clicked. Refer also to the pages on system upgrading. 2Default Image setting Set the quality and size of the image which is to appear when the power is turned ON. The factory settings ar
Streszczenie treści zawartej na stronie nr. 12
Passwords Three kinds of passwords can be set for the WEB card so that three levels of access restriction can be established. 1) Monitor password 2) Operation password 3) Management password Types of passwords Each password serves to restrict the kinds of operations that a user can perform. In terms of their functions, the management password has the highest level of authority. It is followed by the operation password and then by the monitor password which has the lowest level of authority. Wh
Streszczenie treści zawartej na stronie nr. 13
Passwords Types of passwords 3) Management password 1) Monitor password This is used to restrict access to the Config This is used to restrict access to images. screen. The following window appears when an image The following window appears when the has been accessed. Config screen has been accessed. Input “monitor” into the user name field, and Input “management” into the user name field, input the password which was set on the and input the password which was set on the Config screen into the
Streszczenie treści zawartej na stronie nr. 14
Passwords The following anomalies do not indicate that something is wrong with the WEB card. What kind of window appears differs according to the type and version of the browser used. The following anomalies may appear due to the characteristics of the browser but they do not indicate that something is wrong with the WEB card. Type of browser Screen/operation status Anomaly Netscape 4.7 or When a password has been The password may not be confirmed if access is Internet Explorer 5.5 set made wit
Streszczenie treści zawartej na stronie nr. 15
Pan/tilt head and camera control The pan/tilt head and camera can be controlled from the WEB card. ≥ The pan/tilt head that can be connected is the AW-PH350. (A dedicated software cable is required. Contact your local dealer for details.) ≥ The camera that can be controlled is the AW-E300, 600 or 800A. ≥Provide the AW-CA50F29 dedicated cable (optional accessory) separately for connection to the pan/tilt head. ≥ Since control is exercised via the network, the response time taken for the images to
Streszczenie treści zawartej na stronie nr. 16
Before requesting service Item Checkpoint Status Remedial action 1 Power Is the RDY LED lighted? No 1 Check whether the power adapter has been connected properly. 2 Check whether the camera’s power LED is lighted. 3 Check whether the WEB card has been correctly installed in the camera. Yes Power is OK. 2 Communication Is the LINK/RX LED lighted? No 1 Check that the network cable has been connected securely. 2 Check that the HUB’s power is ON. 3 Check that the connection has not been made to the
Streszczenie treści zawartej na stronie nr. 17
Specifications and accessories Specifications Power supply : DC 12 V (supplied from camera unit) Power consumption : 1.9 W indicates safety information. a a a a a a Dimensions (W H D) : 3-5/8˝ 2-3/4˝ 7/8˝ (92 70 21.5 mm) Weight : 0.22 lbs (100 g) Image compression system : JPEG Image quality : 3-level setting a a a Screen size : 640 480, 320 240, 640 240 a Image updating interval : 15 images/sec. for 320 240 a a 7.5 images/sec. for 640 480, 640 240 a I/O connectors : 10 BASE-T RJ-45 connecto
Streszczenie treści zawartej na stronie nr. 18
18
Streszczenie treści zawartej na stronie nr. 19
19
Streszczenie treści zawartej na stronie nr. 20
PANASONIC BROADCAST & TELEVISION SYSTEMS COMPANY DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA Executive Office: 3330 Cahuenga Blvd W., Los Angeles, CA 90068 (323) 436-3500 EASTERN ZONE: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7621 Southeast Region: 1225 Northbrook Parkway, Ste 1-160, Suwanee, GA 30024 (770) 338-6835 Central Region: 1707 N Randall Road E1-C-1, Elgin, IL 60123 (847) 468-5200 WESTERN ZONE: 3330 Cahuenga Blvd W., Los Angeles, CA 90068 (323) 436-350
