Instrukcja obsługi ATD Tools 7563

Streszczenie treści zawartej na stronie nr. 1

ATD-7563
UNIVERSAL STRUT SPRING COMPRESSOR
Operation and Safety Instructions

CAUTION:
Carefully read through this entire operator’s manual before using your tool.


Pay close attention to the Rules for safety operation, warnings, and cautions.
If you use your tool properly and only for what it is intended for, you will enjoy
years of safe, reliable service.

SAVE THIS MANUAL FOR FUTURE REFERENCE

Section Page

• General saf

Streszczenie treści zawartej na stronie nr. 2

General Safety Rules WARNING: When using this tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment. Read all warnings and instructions before using this tool. • Always wear ANSI approved safety goggles and ear protection when working with tools and equipment. • Observe work area conditions. Keep work area clean. Cluttered areas invite injuries. Do not use tool in damp or wet locations. Don't expose tool to rain. Keep wo

Streszczenie treści zawartej na stronie nr. 3

Operating Instructions Removal Important: Keep the actuating screw well lubricated. 1. Refer to the vehicle service manual, and follow the manufacturer's recommended procedure to remove the Macpherson strut assembly from the vehicle. 2. Once removed, clamp the strut assembly in a vise. 3. Mark the coil spring in relation to the lower strut platform and top mount. This will aid in the correct positioning for installation. 4. Place two hooks around the coil as close to the top of the s

Streszczenie treści zawartej na stronie nr. 4

Spring Replacement 1. Place the tool and spring assembly on a workbench. Using a ratchet or impact wrench, SLOWLY AND CAREFULLY decompress the spring. 2. Remove the old spring from the strut tool. Install the new spring in the tool so that a maximum number of coils can be grabbed by the tool without interfering with the spring tip placement in the mounting plates. 3. Compress the spring, and follow the instructions for Installation that follow. Installation 1. Position the compress

Streszczenie treści zawartej na stronie nr. 5

‐ 5 ‐