Streszczenie treści zawartej na stronie nr. 1
™
PM ONE
Production Mixer
Operating Guide
Streszczenie treści zawartej na stronie nr. 2
Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: Risk of electrical shock — DO NOT OPEN! CAUTION: To reduce the risk of electric shock, do not remove cover. No user serviceable parts inside.
Streszczenie treści zawartej na stronie nr. 3
ª PM ONE Professional Stereo Production Mixer ª Thank you for purchasing the PM One stereo production mixer. The unique features of this mixer are sure to add to your performances, both live and recorded. The PM One is a true stereo, fully featured mixer with the DJ in mind. With a built-in stereo graphic EQ, stereo level meter, and assignable crossfade, the PM One adds convenience to any production system. This manual combines both a descriptive and tutorial approach in order to explain the fun
Streszczenie treści zawartej na stronie nr. 4
U U F F E E S S REAR PANEL TM WARNING: TO REDUCE THE RISK OF OUTPUT CHANNEL CHANNEL CHANNEL CHANNEL FIRE OR ELECTRIC SHOCK DO NOT EXPOSE ONE FOUR THREE TWO ONE THIS EQUIPMENT TO RAIN OR MOISTURE. TO PREVENT THE RISK OF FIRE HAZARD, REPLACE WITH SAME TYPE 250 VOLT FUSE. P R O D U C T I O N REC AMP LINE 5 LINE 4 LINE 3 LINE 2 PHONO 2 LINE 1 PHONO 1 AVIS:RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR. REMPLACER PAR UNFUSI- M I X E R GND MIC 2 120V 60Hz/230V 50Hz BLE DE MEME TYPE ET DE 250 VOL
Streszczenie treści zawartej na stronie nr. 5
OUTPUTS The PM One features two different stereo outputs. These outputs are designed for the different types of inputs found on various external equipment. Pay close attention to ensure you have selected the right output for your application. Always use quality, shielded cables and verify a good connection. 5. OUTPUT RECORD These stereo RCA tape output jacks provide a signal for the recording inputs of a stereo tape deck. The output signal is a -10 dBu representation of the Output Amp (6) signal
Streszczenie treści zawartej na stronie nr. 6
8. PHONO INPUT GROUND SCREW Grounds from external turntable(s) should be connected at this point for a proper input connection. 9. MIC 1 INPUT The Mic 1 Input is located on the top of your PM One. (See diagram on back.) The Mic 1 Input is a balanced, low impedance controlled by the Microphone Fader (11). The Voice-over Switch (12) can be placed in the TALK position while the Mic 1 Input is active to temporarily drop the music level by 12 dB. 10. MIC 2 INPUT The Mic 2 Input is a balanced, low i
Streszczenie treści zawartej na stronie nr. 7
13. CHANNEL FADER This stereo fader controls the level of each individual channel regardless of input type. Placing the fader in the Ò0Ó position will produce minimum gain or no signal. Moving the fader to the Ò10Ó position will give maximum gain or the highest output. 14. CHANNEL INPUT SELECT SWITCH The inputs on Channels 1 through 4 are controlled by an input selector switch. Each channel has a designated switch that is used to select its input. The inputs of Channels 1 and 2 offer both PHONO
Streszczenie treści zawartej na stronie nr. 8
selected on the right X-Fader Assign). The interim from left to right would produce a combination of both, allowing a smooth transition from one channel to the other. Note: The X-Fader is replaceable by removing the two outside mounting screws on the top of the unit. Once the screws have been removed, the slider can be pulled out and replaced with ease. 18. X-FADER ASSIGN The two X-Fader Assign selectors determine which two channels the X-Fader (17) controls. These two selectors are located on e
Streszczenie treści zawartej na stronie nr. 9
CUE This section identifies and describes the Cue features of the PM One. The Cue allows you to preview and stage material prior to playing through the mains (Output-amp). 23. CUE ASSIGN Use this selector to determine which pair of channels you would like to cue at one time. Your options include CH 1/2, CH 3/4, and MASTER. Along with the Cue Monitor (25), you can pan between Channels 1 and 2 or Channels 3 and 4 in your headphones. In addition, you may select the MASTER setting to monitor the sig
Streszczenie treści zawartej na stronie nr. 10
ª PM One Recommended Hookup for DJÕs Drum Machine Mini Disc Turntable CD Player CD Player Wireless Mic* Hi Z Mic Turntable L/R Input CH. A Input CH. B Input ¨ SP 2GÕs ¨ Tape Deck CH. A Output CS 800s CH. B Output ¨ PVM 22 Headphones *NOTE: Wireless mics are typically mono. From the line out (mono) of the wireless mic receiver, it will be necessary to use a stereo splitter in order to utilize both the left and right channels of an input channel. 10
Streszczenie treści zawartej na stronie nr. 11
ª PM One Recommended Hookup for Production CD Player Wireless Mic* Tape Deck Wireless Mic* L/R Input CH. A Input L/R Input CH. B Input ¨ SP 2GÕs ¨ Tape Deck CH. A Output CH. B Output CS 800s ¨ PVM 22 Headphones *NOTE: Wireless mics are typically mono. From the line out (mono) of the wireless mic receiver, it will be necessary to use a stereo splitter in order to utilize both the left and right channels of an input channel. 11
Streszczenie treści zawartej na stronie nr. 12
PM ONE SPECIFICATIONS Inputs: Microphone: 1m V 47 k Ohm/High impedance Phone: 3m V 47 k Ohm Line/Tape/CD: 150m V 27 k Ohm Output: 1.5 Volt max Frequency response: 20-20,000 Hz ± 3 dB Distortion: ±0.08% S/N ratio: More than 60 dB Attenuation at Voice over: -12 dB Equalization range: +/-12 dB with independent channels on the bands 60 Hz, 150 Hz, 400 Hz, 1 kHz, 2 kHz, 4 kHz, 6 kHz, 15 kHz. Headphone monitor impedance: 16 Ohm/Output 250mV Power source: AC 110/220 V, 50/60Hz, 15 Watt Dimensions: 19
Streszczenie treści zawartej na stronie nr. 13
NOTES: 13
Streszczenie treści zawartej na stronie nr. 14
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. 6. Clean only with a damp cloth. 7. Do not block any of the ventilation openings. Install in accordance with manufacture
Streszczenie treści zawartej na stronie nr. 15
PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTY Effective Date: July 1, 1998 What This Warranty Covers Your Peavey Warranty covers defects in material and workmanship in Peavey products purchased and serviced in the U.S.A. and Canada. What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service pe
Streszczenie treści zawartej na stronie nr. 16
Peavey Electronics Corporation ¥ 711 A Street ¥ Meridian, MS 39301 (601) 483-5365 ¥ Fax (601) 486-1278 ¥ www.peavey.com ©1999
